管間距 的英文怎麼說

中文拼音 [guǎnjiānjù]
管間距 英文
tube spacing
  • 管 : Ⅰ名詞1 （管子） pipe; tube 2 （吹奏的樂器） wind musical instrument 3 （形狀似管的電器件） valve;...
  • 間 : 間Ⅰ名詞1 （中間） between; among 2 （一定的空間或時間里） with a definite time or space 3 （一間...
  • 距 : Ⅰ名詞1 （距離） distance 2 （雄雞、雉等的腿的後面突出像腳趾的部分） spur （of a cock etc ）Ⅱ動詞...
  • 間距 : interval; separation; spacing; espacement; space; spacing; space length; range; unpack; step
  1. Several methods of determining the optimal space and depth of subsurface plastic drainage tubes are explicated and summarized in this paper

    本文介紹了農田塑料暗管埋深和間距的確定方法，並對之進行了評述。
  2. Determining optimal space and depth of the subsurface plastic drainage tubes is a main task in planning and design of a drainage system

    農田塑料暗管埋深和間距的確定，是塑料暗管排水系統規劃設計的主要任務，關繫到排水效果和投資效益。
  3. ( 4 ) the maximum water quantity becomes greater, the better is the filtering bed permeability, the higher the river hydraulic conductance, the higher the river level, the larger the water - collecting area and the bigger the distance between collecting pipes. the water quantity varies directly with drawdown

    （ 4 ）濾床的滲透性能越好，河床水力傳導系數越高，河水水位越高，取水面積越大，取水管之間的間距越大，則最大取水量越大；水位降深與取水量成正比關系。
  4. For hoods with shutters in four sides, the results show : 1 ) the hoods positively placed boards are called hoods used for venting airflow ; hoods negatively placed boards are called hoods used for leading airflow ; 2 ) among the hoods used for venting airflow, the most effective hoods should have positive declining angle value of 30, the ratio 4 of areas between the four windward faces and the gular section ( fy / fj = 4 ), the value of b range from 70 mm to 120 mm and the value of b / h range from 0. 5 to 0. 6 ; 3 ) the most effective hoods should have negative declining angle value of 60, the ratio 4 of areas between the four windward faces and the gular section ( fy / fj = 4 ), the value of b range from 100 mm to 170 mm ( the optimum value is 120 mm ) and the value of b / h range from 1. 4 to 2. 2 ( the optimum value is 2. 0 )

    對於四面設百葉型風帽，計算表明: l ）正裝傾斜擋板的百葉型風帽可認為是排風型風帽，倒裝擋板傾斜的百葉型風帽可認為是進風型風帽; 2 ）排風型風帽中，擋板正裝30 」 、風帽四個迎風面的有效面積fy和風管凈斷面積fj的比值（ fy腸）為4 、擋板寬度b在70inln到120inln之間、板間距比值隴在0 . 5到0 . 6的百葉型風帽排風效果最好; 3 ）進風型風帽中，擋板倒裝裝60 「 、風帽四個迎風面的有效面積和風管凈斷面積的比值（ fy例）為4 、擋板寬度b在100咖到170mm之間（ 120mm為最佳） 、板間距比值隴在1 . 4到2 . 0的進風型風帽（ b爪= 2 . 0為最佳）的百葉型風帽進效果最好。
  5. To the spacing of icons in windows explorer

    ） ，到windows資源管理器中圖標的間距（
  6. Many factors have effect on irrigation uniformity. with the growing of pressure, how is irrigation uniformity of trickle irrigation varying on different condition of the diameter of drip line, the distance of emitters, the length of drip line, the style of emitters, the flux ratio of emitters and the face gradient of little irrigation district. the consequence shows that pressure has puny effect on irrigation uniformity

    滴灌系統的灌水均勻度受眾多因素的影響，本文通過毛管的管徑、滴頭間距、毛管的管長、灌水器的類型和灌水器的流量系數不同的情況下，灌水均勻度隨壓力水頭變化模擬結果顯示，壓力水頭對灌水均勻度影響非常小。
  7. It is suggested that in the regions of aqueous soil with faster seepage velocity, either the tube - wells can be spaced adequately closer or for the same spacing the number of tube - wells and length of tubes can be reduced under the condition of assuring regular heat transfer effect

    在滲流速度較大的富水地區，在保證常規換熱效果的情況下，管井間距可適當減小，或在同樣管井間距下，可減少管井數量或減小理管長度。
  8. The studied factors respectively are : length of soil nailing, insert deepness of piles, friction force of soil nailing interface, declination angle of soil nailing, horizontal spacing of soil nailing, rows of soil nailing, unit weight of soil, friction angle, unit cohesion, overload of slope, diameter of soil nailing

    這11個因素分別為：土釘（錨管）長度、土釘直徑、土釘界面摩擦力、土釘下傾角、土釘水平間距、土釘排數、土體重度、內摩擦角、粘聚力、坡頂超載、板樁插入深度。
  9. On the contrary, the length of drip line, the diameter of drip line, the distance of emitters and the face gradient of little irrigation district have remarkable effect on irrigation uniformity

    在田間工程中，毛管長度、毛管的管徑、滴頭間距和地形坡度對灌水均勻度影響非常顯著。
  10. When other factors are unchangeable, with the growing of the diameter of drip line and the distance of emitters, irrigation uniformity of trickle system is increasing. the face gradient of little irrigation district has complex effect on irrigation uniformity. in a word, we tries our best to make the face of little irrigation district flat in order to improve the quality of drip - irrigation system

    灌水均勻度由某一因素決定，而其它因素不變的條件下，隨管徑增大，滴灌系統的灌水均勻度增大；隨滴頭間距增大，灌水均勻度也在增大；地形坡度對灌水均勻度影響比較復雜，為了提高低壓滴灌的灌水質量，土地必須整平。
  11. The experimental results of air heat transfer show that the relative fin height, relative fin width, relative fin pitch and density of 3 - d ift with staggered arrangement fins all have an effect on heat transfer and flow friction. especially, the effect of fin density is bigger

    空氣換熱實驗的結果表明：肋叉排三維內肋管的相對肋高、相對肋寬、相對肋間距以及肋密度均對其對流換熱特性有影響，其中肋密度的影響較大。
  12. The simplified dynamic models for radiant floor heating are developed. the effect of row distance between the tubes on temperatures are analyzed by using the models

    摘要給出了低溫地板輻射供冷暖的簡化動態模型，作為模型使用的實例，研究分析了地板供冷時管間距對各項溫度的影響。
  13. The results show that for all of parameters considered in this study, the friction factor of fin surface without vgs is smaller than that for fin surface with vgs ; the increase of friction factor under low reynolds number is large, but with reynolds number increasing, the increase of friction factor is quite small

    實驗結果表明：在不同管間距、板間距時，板芯裝渦產生器阻力系數均比光板板芯的阻力系數大，並且在低雷諾數時的增幅比較大，隨著雷諾數的提高，阻力系數逐漸降低並趨于平緩，且阻力系數增幅大大減少。
  14. The influence of different structural parameters ( diameter and shape of cooling water pipes, distance between cooling water pipes, thickness of stave and cast in bricks ) on the steady state highest temperature and thermal stress of cooling stave was numerically simulated and analyzed by engineering software ansys

    摘要採用有限元分析軟體ansys計算並分析了不同結構參數（冷卻水管形狀和直徑、冷卻水管間距、冷卻壁鑲磚厚度及冷卻壁壁體厚度）對冷卻壁最高溫度及熱應力分佈的影響。
  15. Abstract : in the light of the problem of multiple variables restrain in the design of pipe heat exchanger, it is proposed taking three variables, the pipe length, ratio between the table flap space and the shell outer diameter, and ratio between the pipe space and the pipe outer diameter, as optimization criterion

    文摘:針對管式換熱器設計過程中幾何關系的多自變量約束難題，提出了以管長、折流板間距與殼外徑之比、管間距與管外徑之比三個設計變量作為優化判據。
  16. ( 3 ) based on the experiments data, it has been found that if the emitter discharge of sdi was little, the depth of pipe buried should be shallow, and the distance between two micro holes should be chosen to equal or close the distance between two lateral pipes, if the emitter discharge of sdi was great, the pipe may be buried deeper, and the distance between two micro holes could be greater than the distance between two lateral pipes

    根據一維土柱近似的濕潤輪廓線初步選定了工程設計參數。在地下滴灌灌水器出流量較小情況下，埋深應淺，孔距應選擇和毛管間距相等或接近；出流量大時，埋深可深，孔距大於毛管間距仍可獲得較均勻的土壤水分分佈。
  17. Dilution and dispersion in constant horizontal flow and bottom multi - port discharging was studied in accordance with the hydraulic model test. the influence of diffusion parameters ( jet angle, jet velocity, number of nozzle, riser space ) and environmental parameters ( water depth, water velocity ) on dilution were analyzed. the experimental results show that environmental parameters have prominent effects on wastewater dilution and dispersion, in addition to that, diffuser design parameters have significant influence on wastewater dilution and dispersion. for bailonggang outfall zone, jet angel is 10 or so, nozzle number is 16 or so

    藉助於人工模型試驗，分析了恆定橫流底部多孔排放時擴散器設計參數（射流角度、射流速度、噴口個數） 、上升管間距）及環境參數（環境水深、環境流速）對污水近區稀釋擴散效果的影響，實驗結果表明，除了環境條件對污水稀釋擴散效果影響明顯之外，擴散器設計參數對污水的近區稀釋擴散也有顯著的影響，針對白龍港排放口水域，噴口射流角度宜控制在10左右，噴口個數取16個
  18. To make the thermal efficiency best, y, a, av / as should be : r : [ 60 - 75 ] a : [ 1 - 1. 5 ] av / as : [ 0. 8 - 1 ] in this paper, numerical model of solar radiant floor heating system is also built. the model of numerical model is solved by finite differance method. the smaller the distance to the tube is, the higher the temperature on the surface of the floor is

    地板表面相鄰兩管間水平方向的溫度分佈：距離加熱管越近，溫度越高；兩管中間處溫度最低；供回水溫差越小，地板表面溫度分佈越平緩；在供回水溫度和排管間距均一定的情況下，地板覆蓋層厚度越大，其溫度分佈越為平緩，對應的地板表面溫度分佈越均勻。
  19. The smaller the the difference of the temperature of feedwater and backwater is, the more evenly and slowly the temperature distribution is. the smaller the thickness of overburden layer and the distance of two tubes are, the more evenly and slowly the temperature distribution is

    在供回水溫度和覆蓋層厚度均不變的條件下，排管間距越小，其溫度分佈越為平緩，地板表面的溫度分佈也越為均勻，地板表面平均溫度也越高。
  20. Characteristic of flow - fields at throat of oxidant nozzle, way to separate the equivalent three - nozzle, ejecting effect of different parameters and engineering situations have been demonstrated. effect of distance between secondary flows, the jet angle and the total pressure on the status of flow - fields, has been studied. reactive flow in a hyten nozzle with dimension that was primarily determined has been simulated

    研究了喉部引射主噴管的流場特徵、主噴管等效的三噴管分離方法和不同參數的引射結果以及相關的工程問題；同時還研究了hyten的流場特徵，不同副噴管間距、注入角度和總壓對流場參數的影響。
分享友人
分享到 Line

分享到臉書