節流式量熱器 的英文怎麼說

中文拼音 [jiéliúshìliángrèqì]
節流式量熱器 英文
throttling calorimeter
  • 節 : 節構詞成分。
  • 流 : Ⅰ動1 （液體移動; 流動） flow 2 （移動不定） drift; move; wander 3 （流傳; 傳播） spread 4 （向壞...
  • 式 : 名詞1 （樣式） type; style 2 （格式） pattern; form 3 （儀式; 典禮） ceremony; ritual 4 （自然科...
  • 量 : 量動1. （度量） measure 2. （估量） estimate; size up
  • 器 : 名詞1. （器具） implement; utensil; ware 2. （器官） organ 3. （度量; 才能） capacity; talent 4. （姓氏） a surname
  • 節流 : 1. （節省經費開支） reduce expenditure 2. [工業] orificing; choke; throttle down, throttle back; throttle
  1. The afterheat, which is collected by recovery devices, in winter can be used as the low level thermal source of heat pump, and in summer can preheat feed water, thus equivalent an economizer. because energy flows in the system so reasonably that energy is used to the most, therefore, its energy conservation effect is significant, and the operating expenditure declines consequently. the sewage can be reused after due treatment, thua it has a certain social and ecological benefit, too

    本研究中選用分離式熱管裝置提供洗浴用水，利用水源熱泵裝置，一機兩用，進行空間供熱和製冷，並通過余熱回收器對系統內的余熱進行回收，冬季可作為水源熱泵的低位熱源，夏季可對鍋爐給水進行預熱，起到「省煤器」的作用。這樣實現系統內的能量合理流動，從而達到節能的目的，同時洗浴污水經適當的處理后可以回用，因而還具有一定的社會和生態效益。
  2. The new device consists of paint - drying box, heat carrier boiler, heating pipe, expansion tank, gas separator and oil tank, etc. the data of two applied examples shows that heat carrier paint drying method is able to make painting - drying cost drop by 88 %, compared with the conventional one, that it has some advantages such as uniform temperature field, good appearance and lower costs, compared with conventional hot air convection mode

    該裝置主要由熱載體烤漆爐、輻射加熱管，熱載體爐、膨脹器、油氣分離器和儲油槽等組成。應用實例的測試數據表明，與傳統的遠紅外電加熱鋼瓶烤漆方式相比較，鋼瓶熱載體烤漆節能和降低能耗費用十分顯著，能耗費用降幅達到88 。與熱風爐對流烤漆方式相比較，熱載體烤漆方法不僅節能，而且烤漆爐溫度場均勻穩定，同時烤漆的外觀質量也得到了明顯提高。
  3. Abstract : the in servie tubular heaters built early in refineries and chemical plans have low thermal load and low heat efficiency, therefore measures for technical reform are offered, including ( 1 ) enlarging the surface area of convection tubes to increase the thermal load of rhe convection section ; ( 2 ) increasign the heat interchanging area of radiant tubes ; ( 3 ) changing the height of the chimney ; ( 4 ) using new burner with forced air supply to increase calorific capacityu ; ( 5 ) adding air preheater between the convection section and chimney to enhence the temperature of the air entering the furnace ; ( 6 ) adopting high temperature radiant coating to improve the effect of radiant heat interchanging

    文摘:針對早期建造的煉油廠和化工廠在役管式加熱爐熱負荷和熱效率低的狀況，提出了若干技術改造措施包括，增大對流管表面積以增大對流段的熱負荷；增加輻射管的換熱面積；修正煙囪高度；換用新型燃燒器，變自然通風為強制供風，以增大燃燒器的發熱量，減小過剩空氣系數，節省燃料2 % 3 % ；在對流段和煙囪之間增設空氣預熱器以提高空氣入爐溫度；採用高溫輻射塗料增強輻射換熱效果，從而增加熱源對爐壁的輻射傳熱量和爐管的傳熱量等。
  4. The in servie tubular heaters built early in refineries and chemical plans have low thermal load and low heat efficiency, therefore measures for technical reform are offered, including ( 1 ) enlarging the surface area of convection tubes to increase the thermal load of rhe convection section ; ( 2 ) increasign the heat interchanging area of radiant tubes ; ( 3 ) changing the height of the chimney ; ( 4 ) using new burner with forced air supply to increase calorific capacityu ; ( 5 ) adding air preheater between the convection section and chimney to enhence the temperature of the air entering the furnace ; ( 6 ) adopting high temperature radiant coating to improve the effect of radiant heat interchanging

    針對早期建造的煉油廠和化工廠在役管式加熱爐熱負荷和熱效率低的狀況，提出了若干技術改造措施包括，增大對流管表面積以增大對流段的熱負荷；增加輻射管的換熱面積；修正煙囪高度；換用新型燃燒器，變自然通風為強制供風，以增大燃燒器的發熱量，減小過剩空氣系數，節省燃料2 % 3 % ；在對流段和煙囪之間增設空氣預熱器以提高空氣入爐溫度；採用高溫輻射塗料增強輻射換熱效果，從而增加熱源對爐壁的輻射傳熱量和爐管的傳熱量等。
  5. In order to improve measurement precision and display fidelity of the instrument, three new methods of nonlinear calibration of thermal instruments, which are based on intelligent control theory, are presented in this paper, such as nonlinear compensation of zr02 oxygen measurement instrument using bp nn, nonlinear calibration of temperature measurement sensors using cmac nn and nonlinear identification of throttle flow meter using ga. these methods prove to be not only simple but also effective

    火電廠熱工儀表普遍存在非線性特性，為了提高參數測量的準確度和儀表顯示的精確度，基於智能控制理論，文中提出了熱工儀表非線性校正的新方法： bp神經網路補償氧化鋯氧量計非線性特性的方法、 cmac神經網路校正測溫傳感器非線性特性的方法、遺傳演算法辯識節流式流量儀表非線性特性的方法。
  6. It can be used for water return of radiator, balance water flew and cut off system. available for : 3 / 4 ", 1 / 2 " / style : straight valve, angle valve

    散熱器回水節流閥，應用於散熱器回水口，可平衡系統流量，並可關斷系統。規格及型號： 3 / 4 」 、 1 / 2 」型式：直型、角型。
  7. This system is utilized the programmable controller ( plc ) bearing of substitution rule ( the figure is apparent the form, writing instrument, individual loop controller, the hand is holded the utensil and is reached to assist the bearing unit and await ), achieve the 29mw ' s cycle stream of water warmhearted water boiler, oxygen remover, warmhearted net system control system together with monitoring voluntarily of electric section together with control being living, the rule to call off greats quantity displays the bearing in that system, boiler, oxygen remover, the warmhearted net operation is achieved crt and is supervised completely, manipulates personnel staff is living inner place the control cabin completely completees failure - free operation and trouble removal operation. the predictive target of putting ino production queen is the boiler, oxygen remover, the warmhearted net is achieved comprehensive self - regulation, moreover be able to be over a long period of time, steady secure operation

    本系統利用可編程式控制制器（ plc ）替代常規的儀表（數顯表、記錄儀、單迴路控制器、手操器及輔助儀表裝置等） ，實現29mw循環流化床熱水鍋爐、除氧器、熱網系統控制系統與電氣部分的自動監測與控制。在該系統中取消大量的常規顯示儀表，鍋爐、除氧器、熱網的運行實現crt全面監控，操作人員在控制室內全部完成正常運行及事故處理操作。投產后的預期目標是鍋爐、除氧器、熱網實現全面自動調節，並能長期、穩定、安全運行。
  8. And the controlling method of pi makes the temperature control quick and stable. at the same time, the paper completes the mutual communication between temperature control equipment and computer by way of serial interface and usb interface, so as to realize the remote control of computer to the temperature control equipment. finally, the performance test of the semi - conductor temperature control equipment researched in this paper is carried out, and the results show that the precision of the temperature of the controller of semi - conductor can reach to 0. 2, and the degree of temperature stablization is less than 0. 05

    整個系統採用閉環控制結構，使系統的抗干擾能力大大增強;為半導體製冷器量身定做的驅動電路，可以方便的調節通過tec電流的大小和方向，使tec加熱製冷靈活迅速的特點得到充分發揮;使用比例積分（ pi ）的控制方法使得溫度控制快速穩定;同時，本文還實現了溫控儀與上位機通過串列口和usb口兩種方式的通訊，實現了上位機對溫控儀的遠程控制;最後，對所研製的半導體溫度控制儀進行了性能測試，測試結果表明，半導體溫度控制儀溫控精度達到0 . 2 ，溫度穩定度小於0 . 05 ，滿足了系統設計的要求。
  9. Manual operating hot water flow through the radiator to control the room temperature, its most economical of thermostatic radiator valve. available for : 3 / 4 ", 1 / 2 " / style : straight valve, angle valve

    散熱器手動調節閥，通過手動調節散熱器的熱水流量，以達到控制室內環境溫度的目的，是最經濟的散熱器溫控閥。規格及型號： 3 / 4 」 、 1 / 2 」型式：直型、角型。
  10. The monitoring and controlling system adopts a total distributed control system ( dcs ) constituted by a programmable logic controller ( plc ), a computer ( pc ) and thermal power engineering signal sensors, sender, controller, etc. plc is used to collect data and perform automatic control mostly, while pc is adopted to monitor the operation process, analyze, display and store data

    本項研究中採用可編程式控制制器（ plc ）作下位機、工業控制計算機（ pc ）作上位機與熱工參數測量傳感器、變送器、操作控制器等組成集散型控制系統（ dcs ） ，上位機和下位機自動監測垃圾焚燒鍋爐的各運行參數，並對異重循環流化床垃圾焚燒鍋爐實行自動控制與調節。
分享友人
分享到 Line

分享到臉書