粉末氧化劑 的英文怎麼說

中文拼音 [fěnmòyǎnghuàjì]
粉末氧化劑 英文
powder oxidizer
  • 粉 : Ⅰ名詞1 （粉末） powder 2 （用澱粉製成的粉條或粉絲） noodles or vermicelli made from bean potato o...
  • 末 : Ⅰ名詞1 （東西的梢;盡頭） tip; terminal; end 2 （非根本、非重要的事物） nonessentials; minor detai...
  • 氧 : 名詞[化學] （氣體元素） oxygen （o）
  • 劑 : Ⅰ名詞1 （藥劑; 制劑） a pharmaceutical or other chemical preparation 2 （某些有化學作用的物品） a...
  • 粉末 : powder; flour; stive; smalls
  • 氧化劑 : oxidant; oxygenant; oxidizer; oxidizing agent
  • 氧化 : [化學] oxidize; oxidate; oxide; burning; rust; oxygenize; oxido-; oxy-
  1. The product is a chief material for high temperature insulant, used mainly for the producing of polyimid resin, thin film, and insulating paint. it is also a high temperature curing agent and plasticizer. some kinds of curing agents of powder coating are made from it

    主要用於制聚酰亞胺樹脂，聚酰亞胺在廣泛的溫度范圍內具有優良的電氣絕緣性能，亦可做耐高溫環氧樹脂固化劑聚氯乙烯增塑劑及皮革柔軟劑，還可用做某些粉末原料。
  2. Lead hydrogen phosphite superfine powder, lead oxide phosphite hydrate superfine powder and tribasic lead sulfate superfine powder were prepared by micro - liquid - phase synthesis method ( mlps method ) in this paper. at room temperature, acetic acid worked as catalyst, lead oxide and phosphite or sulfate were blended thoroughly, then were ground for tens minutes

    本文採用微液相合成法制備了亞磷酸鉛、二鹽基亞磷酸鉛和三鹽基硫酸鉛超細粉末，以氧化鉛和亞磷酸或硫酸為原料，以醋酸為催化劑，在室溫下充分混合、研磨幾十分鐘，乾燥后即可得到產物。
  3. This research uses dicyandiamide as firming agent in epoxy powder coating and sodium fluoride as additive in epoxy

    摘要採用磷酸雙氰胺鹽作環氧粉末塗料的固化劑、氟化鈉作添加劑。
  4. Determination method of particle size and its distribution of the jargonia catalyst powder

    氧化鋯催化劑粉末粒度及其分佈的測定方法
  5. In light of various pollution situations and various water treatment processes of two water factories, better solved the problems about throwing doses, throwing localities, throwing forms of composite potassium permanganate and powder activated carbon, as well as compared the enhanced coagulation efficacy of combined process of composite potassium permanganate and powder activated carbon, composite potassium permanganate pre - oxidation and pre - chlorination

    針對兩水廠不同的源水污染狀況和現有的水處理工藝，通過室內和生產性試驗，很好地解決了高錳酸鉀復合藥劑、粉末活性炭最佳投加點、投加量和投加方式的確定問題，並對兩者聯用的強化混凝效果與預氯化、單獨高錳酸鉀復合藥劑預氧化進行了對比。
  6. The authour investigate the dosing conditions and effect of the pac to the huanghe water - source, which includes the following four parts : the selection of the pac ; the confirmation of dosing scheme and effect of the pac ; the research of application of potassium permanganate in combination with pac ; the research of the pac ' s modification and the modified effectiveness. the experiment is mainly carried out on the pilot system in the jieyuan water plan of tianjin. the results of the reseach include the following : l ) the pac from zunhua plant is selected as the better carbon for the source water of tianjin through the experiment ; 2 ) through the pilot experiment we conclude that the pac ' s best adding point is the mixing tank and the better dose is 10mg / l, on which the codmn of filtered water can be decreased to 40 % and the effluent have no problem of odour and color ; 3the adsorbing experiment show that pac mainly adsorb the organic matters which molecular wt., distribution between 500 and 3000, and can adsorb organic matters whose molecular wt., distribution are bigger than 6000 if the dose of it is adequent ; 4 ) pac together with potassium permanganate can remove the organic matter more effectively than each of them alone, and reduce the rising trend of turbidity of the flotation ' s effluent due to adding pac ; 5 ) the thesis made a research on the surface properties and the adsorbing capability of the modified carbon by oxidizer : the modified carbon with 20 % h2o2 can remove more organic pollutants than the untreated one by 12 % when we add a higher dose of coagulant ; 6 ) the modification of reduction and loading metal ions are also sttldied, and drow the following conclusions : the modified carbon with 5 % ammonia can enhance the organic matter ' s removal effectiveness by 10 % to the tianjin source water than the untreated one, and the modified one with loading metal ion remove the organic matters from the tianjin source water better ( 8 % ) than the untreated one due to the strong affinity betwween the humic acid and copper ion

    本文的實驗主要是在天津芥園水廠的中試系統上完成的，論文的成果和結論主要包括： 1 ）通過靜態實驗選定河北遵化活性炭廠生產的煤質炭為適合天津原水的炭種； 2 ）中試實驗確定粉末活性炭的較佳投加點為混合池投加，較佳投加量為10mg l ，此時可使濾后水的cod _ （ mn ）降低40 ，且可較好地控制濾后水的嗅味和色度； 3 ）初步確定粉末活性炭對原水中有機物的吸附主要集中在分子量在500 - 3000范圍內，投量增大時可吸附部分分子量大於6000的有機物4 ）中試實驗表明：粉末活性炭與高錳酸鉀聯用可取得較兩者單獨應用時對有機物更好的去除效果，且對因投加粉末活性炭而造成的氣浮出水濁度升高有一定的改善作用； 5 ）研究並初步確定氧化改性對粉末活性炭表面性質和有機物的去除效果的影響：粉末活性炭的氧化改性會使其表面的酸性官能團大量增強，表面極性增加；經20的過氧化氫改性的活性炭在增大混凝劑投加量（ fecl _ 3投量為15mg l ）時對有機物的總體去除效果較原活性炭提高12 ， 1次氯酸鈉改性活性炭對有機物的去除效果較原活性炭提高6 ； 6 ）研究並初步確定還原改性、負載金屬離子對原水中有機物的去除效果的影響：經5氨水改性的活性炭可提高天津源水中有機物的去除率達到10 ；負載銅離子后的活性炭可提高對腐殖酸類物質的去除能力，一般可提高8左右。
  7. The preparing process is as follow : mixing the nickel salt, zirconium salt and stabilizer in the solvent ( distilled water ) to prepare mixing solution according to a certain ratio ; commingling the mixing solution and coordination solution of carboxylic ammonia in accordance with a certain rate to form sol, drying the sol and turning it into gel, pre - sintering the gel to get the zro2 - nio powders and the zro2 - ni nanocrystalline composite powders were gained by reducing the zro2 - nio powders

    方法如下：將鎳鹽、鋯鹽、穩定劑和水溶劑按所需成分配成混和溶液，再將混和溶液、外加劑按比例混和形成溶膠，溶膠經乾燥成為凝膠，凝膠經預燒得到ysz - nio氧化物納米粉末，將該氧化物粉術還原得到ysz - ni納米復合粉術。絡合。
  8. In this study, the preparing processes of zro2 - ni nanocrystalline composite powder aremixing the nickel salt, zirconium salt and stabilizer, solvent ( distilled water ) together to prepare the mixing solution according to certain ratio ; commingling the mixing solution, coordination solution of carboxylic ammonia, intrusion aid in accordance with certain rate to form sol, drying the sol and turning it into gel, pre - sintering the gel to get the zro2 - nio powder and gaining zro2 - ni nanocrystalline composite powder by reducing the zro2 - nio powder. xrd, x - ray wide - angle diffractometer, bet, sem, tem, hrtem analyses are used to study the zro2 - ni nanocrystalline composite powder and zro2 - ni cermet. the sintering temperature is determined

    本研究的zro _ 2 - ni納米復合粉末的制備方法如下：將鎳鹽、鋯鹽、穩定劑和溶劑（水）按所需成分配成混合溶液，再將混合溶液、外加劑和氨羧絡合劑按比例混合形成溶膠，溶膠經乾燥成為凝膠，凝膠經預燒得到zro _ 2 - nio納米粉，將該氧化物粉還原得到zro _ 2 - ni納米復合粉。
  9. Specification for solventless polymerisable resinous compouds used for electrical insulation. part 3 : specifications for individual materials. sheet 11 : epoxy resin - based coating powders

    電絕緣用無溶劑可聚合樹脂化合物規范.第3部分:專用材料規范.活頁11 :環氧樹脂基塗料粉末
  10. Specification for solventless polymerisable resinous compounds used for electrical insulation. part 3 : specifications for individual materials. sheet 11 : epoxy resin - based coating powders

    電氣絕緣用無溶劑可聚合樹脂化合物規范.第3部分:單項材料規范.第11活頁:環氧樹脂基粉末塗料
  11. 2 resin with bad wetness systems such as epoxy resin, polyester, alkyd, acrylic resin, operate as the following process : add the solvent - add organic bentonite powder mix and stir 10 minutes, wet enough - add the polar active agent mix and stir 5 - 10 minutes, make it swell and disperse - add resin and stir - add the surface active agent - add pigment, stir and disperse to the needed granularity - dilute to the needed viscosity main points for use methods

    2當使用潤濕性差的樹脂系統環氧，聚酯，短油酸樹脂，丙烯酸樹脂操作如下：加入溶劑混合加入有機膨潤土粉末攪拌混合10分鐘，使其完全潤濕加入極性活化劑攪拌混合5 - 10分鐘，使其膨脹，分散加入樹脂混合攪拌加入表面活化劑攪拌分散至所需細度稀釋至所需粘度。
  12. The power prepared was examined by many kinds of analytic measures, like as xrd, xps, tem, sem and x rays fluorescence, etc. the sol - gel method was used to synthesize dy - doped titanium oxide, the impact of elements such as solvent ' s quantities, temperature, ph value, calcination temperature on the course of sol - gel is studied, and the quantities of mixed rare earth is also studied on the influence about the structure of phase, thus established the best technology parameter

    本文對摻雜稀土元素鏑的氧化鈦和氧化鋯超微陶瓷粉末的制備的工藝過程進行了研究，並用xps 、 xrd 、 tem 、 sem和x射線熒光等多種測試手段對制得的粉末進行了分析。用溶膠-凝膠法合成氧化鏑/氧化鈦的陶瓷粉末，研究了溶劑量，溫度， ph值，煅燒溫度等對溶膠-凝膠過程的影響，以及摻雜稀土量對相結構的影響，從而確立了最佳的工藝參數。
  13. Ep epoxy powder coating are thermosetting powder coating based on epoxy resin, with modified of diversiform curing agent, and are characterized of anti corrosive, excellent impact toughness, and used in pipeline corrosion protection, family fitting etc

    Ep粉末塗料是一種以環氧樹脂與多種固化劑改性而成的熱固性粉末塗料，具有較好的耐化學腐蝕性，極佳的沖擊韌性，廣泛應用於重防腐的管道，家庭用具等領域。
分享友人
分享到 Line

分享到臉書