粉面改進劑 的英文怎麼說

中文拼音 [fěnmiàngǎijìnjì]
粉面改進劑 英文
flour improvers
  • 粉 : Ⅰ名詞1 （粉末） powder 2 （用澱粉製成的粉條或粉絲） noodles or vermicelli made from bean potato o...
  • 面 : Ⅰ名詞1 （頭的前部; 臉） face 2 （物體的表面） surface; top 3 （外露的一層或正面） outside; the ri...
  • 改 : Ⅰ動詞1 （改變） change; transform 2 （修改） revise; alter; modify 3 （改正） rectify; correct 4 ...
  • 進 : 進構詞成分。
  • 劑 : Ⅰ名詞1 （藥劑; 制劑） a pharmaceutical or other chemical preparation 2 （某些有化學作用的物品） a...
  • 改進 : improve; make better; better; mend; improvement; perfection; melioration
  1. Aiming at improving the lipophilic property of the conductive fillers, surface modification of conductive tio2 powders and conductive mica powders has been researched by 5 kinds of coupling agents

    摘要為了提高無機導電填料的表面親油性，選擇5種偶聯劑分別對導電二氧化鈦粉體及導電雲母粉體進行了表面改性，活化指數評定了改性效果。
  2. The surface of ultrafine tio2 is treated with aluminium zirconium organic metal coupling agent

    摘要利用鋁鋯有機金屬偶聯劑對超微二氧化鈦粉體進行表面改性。
  3. In this paper, a high performance sma system applied to steel bridge deck is put forth in allusion to the pavement project of the wuhan junshan yangtze river highway bridge. it comprises steel slab, zn coating layer, closing layer, adhesive, pre - mixed asphalt stone and dual layer sma from bottom to top. it is based on the fea results of the forces and deformation of the pavement layer by means of the algor feas, according to this bridge ' s traffic and the ambient temperature varying range of the pavement layer

    本文針對武漢軍山長江公路大橋鋼箱梁橋面鋪裝工程，從鋪裝層環境溫度變化范圍、交通量等使用條件出發，在用algorfeas有限元分析軟體分析鋪裝層受力變形基礎上，提出了（即鋼板+金屬鋅塗層+封閉層+粘接劑+預拌瀝青碎石+雙層sma ）的高性能鋼橋面sma鋪裝體系，並對這種sma的組成材料，包括改性瀝青、集料、礦粉、纖維進行了比較研究，設計了這種sma的配合比，對sma混合料的性能進行了對比試驗，對這種sma方案進行了疲勞性能研究，驗證了所選擇sma方案的可行性。
  4. In this paper, the method of rubber regeneration to modify the grt was investigated in order to decrease the crosslink density of ground rubber tyre ( grt ) and try to improving the interfacial contact state between grt and waste polypropylene ( wpp ), mechanism of proton - transfer devulcanization was studied in the first time

    本文研究了兩類再生劑de - link和乙撐胺對廢膠粉（ grt ）的改性效果，來適當降低膠粉的交聯度並試圖改善其與廢聚丙烯（ wpp ）之間的界面接觸情況，並首次對質子轉移法脫硫的機理進行了探討。
  5. The grade composite, road performance and its mechanism are systemically studied. 1 ) the aggregate grade of ogfc is studied through the volume method base on the analysis of the aggregate grades. then the grade is verified and the relation between the grade and pore rate is studied statistically, the typical grades of ogfc are developed ; 2 ) the reasonable pore rate of ogfc is studied on the basis of the balance of mechanics and function performance ; 3 ) the mineral fiber is added to the ogfc mixes to increase asphalt content, thus the anti - water performance of ogfc mixes are improved ; 4 ) high viscous asphalt fit for the preparation of ogfc is prepared through composite modification by sbs and rubber powder ; 5 ) the mechanics mechanism of ogfc is studied in the paper, it shows : asphalt paste, as well as the coarse aggregate skeleton, is essential to the mechanics of ogfc

    在分析各國ogfc級配的基礎上，運用礦料體積法進行ogfc級配設計，用正交實驗對礦料級配進行了優化設計，運用數理統計方法分析礦料級配和孔隙率之間的關系，並回歸出礦料關鍵篩孔通過率與ogfc骨架空隙結構關系的數學方程，進而提出了ogfc的合理級配；通過對不同孔隙率典型級配混合料的性能研究，綜合力學和功能性能，得出了ogfc的合理孔隙率范圍：針對高速公路面層對ogfc力學性能方面的要求，本文從瀝青膠結材料、纖維穩定劑兩方面對ogfc的性能進行改善：通過sbs和橡膠粉復合改性的方法開發出了適合ogfc的高粘度改性瀝青，摻加聚合物纖維，提高ogfc的最佳瀝青用量，進而改善了混合料的高溫性能和抗水損害性能，優化設計出能滿足高速公路路用性能，車轍動穩定度達5000次/ mm以上，動融劈裂強度比90 ，透水系數31ml / s ，並具有防滑降噪功能的開級配瀝青磨耗層（ ogfc ）混合料。
  6. Its research contains the preparation and technical index of application of h9110 solventless impregnating resin of the ansatured polyester - imede. it analyses reactivity of the resin by dsc and provides the research process of 9547 - 1 single glass cloth reinforced dry mica tape and the alteration of mica tape michines. it also characterizes the structure of h9110 solventless impregnating resin and the resin to dry mica tape by infared spectroscopy and nuclear magnetic resonance hydrogen spectroscopy

    研究內容包括h9110不飽和聚酯亞胺無溶劑浸漬樹脂的制備及使用工業參數的確定，用dsc分析了該樹脂的反應活性； 9547 - 1單面玻璃布補強少膠粉雲母帶的研製過程和雲母帶製造設備的改進；用紅外光譜和核磁共振分析表徵了h9110不飽和聚酯亞胺無溶劑浸漬樹脂和少膠粉雲母帶粘合樹脂的結構。
  7. After surface modification of zno nanoparticles by titance coupling agent, the product were more dispersed because their surface were associated with organics anion. the effects of the dosage of titance coupling agent on surface modification of zno nanoparticles were studied, the optimal dosage of titance coupling agent ( 9 % ) have been investigated

    本文對制備出的納米氧化鋅用鈦酸酯偶聯劑進行表面改性處理，在納米氧化鋅表面形成有機結構，得到更為分散的粉體。實驗中考察了不同用量對改性效果的影響，得到了本實驗條件下的較佳用量9 。
  8. The relative factors on gloss of the metallic pigment were analyzed with glossmeter and sem. through surface modification of bronze powder, the effect of different surfactants on the wetting property and the leafing property of bronze powder were established. the polishing technique of powder was also studied

    利用光澤儀和掃描電鏡分析了影響銅金粉光澤度的主要因素，通過對銅金粉的表面改性，考察了不同種類的表面活性劑對銅金粉潤濕性和漂浮性的影響，並對銅金粉在拋光過程中的影響因素進行了初步分析。
  9. The intermediate - temperature sofc ( solid oxide fuel cell ) ’ s electrolyte with perovskite - type lsgm ( la _ ( 0. 9 ) sr _ ( 0. 1 ) ga _ ( 0. 8 ) mg _ ( 0. 2 ) o _ ( 3 - ) ) was synthesized using advanced pechini method and solidification method. the thermal and electrical properties of the sintered samples ( synthesized by two different methods ) were measured and compared by thermal expansion and ac impedance spectroscopy ; the phase transformation process and inner structure were measured and compared by xrd, dta - tg and ac impedance spectroscopy. the research results show that the electrolyte synthesized by advanced pechini method has several advantages, such as fine pre - powders, low sintering temperature, reduced or eliminated impurity phases and high conductivity etc. so, the apm is ideal method to synthesize lsgm

    採用改進的檸檬酸法（以檸檬酸和edta乙二氨四乙酸為復合絡和劑，檸檬酸為燃料）和固相法分別制備了具有鈣鈦礦結構的中溫固體氧化物燃料電池的電解質材料lsgm （ la _ （ 0 . 9 ） sr _ （ 0 . 1 ） ga _ （ 0 . 8 ） mg _ （ 0 . 2 ） o _ （ 3 - ） ） ，用差熱?熱重分析（ dta / tg ） 、 x光衍射分析（ xrd ） 、交流阻抗譜技術（ ac - impedancespectra ） 、比表面積分析（ bet ）和燒結收縮率曲線等手段對產物的熱分解過程、物相轉變和內部結構等進行了表徵，並對由這些粉體燒結而成的固體氧化物燃料電池的電解質材料的電導率進行了檢測。
  10. Changing the grading of sic particles not only affects the strength and pile density, but also modifies the phase compositions and microstructure of the material. with the reducing of sic particles, the strength of the material increases obviously. the nitrification scheme has the greatest influence on phase compositions and microstructure " of si3n4 ( si2on2 ) - sic, after two continuous nitrification reacting peak and short - time high - temperature treating, the best properties can be obtained ; and the residual strength of the composite is much higher after the thermal shock resistance test, which shows that the material possesses excellent thermal shock resistance

    本論文較全面地探討促進強度和顯微結構良好的si _ 3n _ 4 （ si _ 2on _ 2 ）結合相的實驗條件，實驗數據顯示：引入適量的燒結助劑能夠促進si _ 3n _ 4 （ si _ 2on _ 2 ）的生成和晶粒的長大，而過量時，其促進作用反而下降；隨著si粉加入量增加，生成的結合相明顯增多，復合材料的性能顯著提高；改變sic顆粒級配不僅影響復合材料的強度與堆積密度，而且對復合材料的物相與顯微結構也有影響，隨著顆粒逐漸細化，材料的強度有較大的提高；對復合材料的強度、物相與顯微結構影響最大的是氮化制度，經過兩個氮化高峰連續的反應和短時間的高溫后處理得到的復合材料性能最好；通過抗熱震性能實驗后復合材料的殘余強度較高，顯示出較好的抗熱震性能。
  11. Extra - fine wool powders were surface modified with coupling agent, and turned into mixed membranes with polyurethane

    摘要用偶聯劑對超細羊毛粉體進行了表面改性，然後製成羊毛粉體與聚氨酯共混膜。
  12. For this reason synthron decided to develop a synthetic additive that allows a significant improvement in mechanical properties ( cmt, burst factor, sct ) above the maximum levels that can be achieved with the classical use of starch in the mass and or on the surface

    因此， synthron （法國公司）決定開發一種合成添加劑，該添加劑在機械性能（ cmt （瓦楞材料試驗） 、破裂系數、 sct （短期壓縮試驗）方面的巨大改進性能優于澱粉作為基材和/或表面材料的傳統使用所獲得的最佳性能。
分享友人
分享到 Line

分享到臉書