粗粒碳 的英文怎麼說
中文拼音 [cūlìtàn]
粗粒碳
英文
coarse grained carbon-
Many research such as clay minerals, suspend in the sea, the grain size trend analysis of surface sediment, poc 6 cu and 8 c13 in bottom sediments etc. showed that : the yellow sea warm current divided the south yellow sea into two, the terrestrial material of modern sediment on the west shelf plain mainly came from the modem yellow river suspend carried by the alongshore current, and the sediment difference between the west and east side of yellow sea trough was represented by the sedimentation thickness in postglacial period, sedimentation stratum, and oxygen isotope record
粘土礦物、碳酸鹽、粗碎屑、海域懸浮體、表層沉積物粒度趨勢分析、 poc c ~ （ 13 ）及底質沉積物的c ~ （ 13 ）等多方面研究表明：以黃海暖流為主導，南黃海堆積陸架平原西側現代沉積物陸源物質主要源於黃海沿岸流攜帶的現代黃河懸移物質，黃海槽東西兩側的沉積差異主要表現在冰消期以來沉積厚度、沉積層序、氧同位素記錄上。The quality of buffer layer and thin films was analyzed by afm, xrd, rheed and xps respectively. the effect of the experimental parameters such as carbonization time, working pressure, c source gas flow rate, carbonization temperature, different carbonization gas and substrate on the carbonization process was studied firstly. it was observed that the size of particles was increased with the increase of carbonization time and the rms was opposite, but the trend was reduced while the carbonization time was long enough ; the size of particles was increased with the increase of working pressure too, and choosing a proper working pressure could get a smooth surface ; the size of particles was unobviously changed while the gas flow rate was low, but it was notability increased with the increase of gas flow rate while the gas flow rate was high enough, and a smooth surface could be also obtained by choosing a proper gas flow rate ; with the increase of carbonization temperature, the size of particles was increased, the rms is decreased and a good single - crystalline carbonization layer could be obtained, but a rough surface was formed at a excessive high temperature ; the rms of
對于碳化工藝，側重研究了碳化時間、反應室氣壓、 c源氣體的流量、碳化溫度以及不同種類的c源氣體、基片取向等因素對碳化層質量的影響，研究結果表明:隨著碳化時間的增長，碳化層的晶粒尺寸隨之變大，表面粗糙度隨之降低，但當碳化到一定時間之後，碳化反應減緩，碳化層的晶粒尺寸以及表面粗糙度的變化幅度變小;碳化層的晶粒尺寸隨反應室氣壓的升高而變大，適中的反應室氣壓可得到表面比較平整的碳化層;在c源氣體的流量相對較小時，碳化層的晶粒尺寸隨氣體流量的變化不明顯，但當氣體流量增大到一定程度時，碳化層的晶粒尺寸隨氣體流量的增大而明顯變大，同時，適中的氣體流量得到的碳化層表面粗糙度較低;碳化溫度較低時，碳化層的晶粒取向不明顯，隨著碳化溫度的升高，碳化層的晶粒尺寸明顯變大，且有微弱的單晶取向出現，但取向較差，同時，適中的碳化溫度可得到表面平整的碳化層;相比于c _ 2h _ 2 ，以ch _ 4作為c源氣體時得到的碳化層表面平整得多;比起si （ 100 ） ，選用si （ 111 ）作為基片生長的碳化層的晶粒取向一致性明顯更好。The organic matter, total n, hydrolytic n were increased, then reduced with the increase of abandoned time. the loss of organic c got up to 59. 4 % in abandoned land. in 0 - 20cm, the sand content of 0. 25 - 0. 05mm was increased gradually, the average content of sand in the abandoned land was up to 76. 84 %, the sand contents of silt and sand was gradually reduced, the soil mechanic compose became coarse
隨撂荒年限的增加，土壤有機質、全氮、堿解氮等主要養分均表現出先降低后增加的趨勢；撂荒地有機碳的損失平均達到59 . 4 ；在撂荒地表面0 - 20cm范圍內， 0 . 25 - 0 . 05mm粒徑的砂粒含量逐漸增加，各撂荒地砂粒平均含量達76 . 84 ，粉粒和粘粒含量逐漸降低，土壤機械組成出現粗化現象。Influence of ti content on austenite grain size and grain coarsening temperature in medium - carbon boron steel
鈦含量對中碳硼鋼奧氏體晶粒度及晶粒粗化溫度的影響The results show that under the same lapping conditions the si3 n4 ball has the lowest material removal rate and the best roundness and roughness, followed by zro2, al2o3, and sic ball
結果表明：在相同的研磨條件下，具有長柱狀晶粒的氮化硅陶瓷球加工速率最低，但圓度和表面粗糙度最容易控制；氧化鋯和氧化鋁陶瓷球表面質量次之，碳化硅陶瓷球加工速率最高，圓度和表面粗糙度最難控制。Abrasive grains and crude - chemical analysis of silicon carbide
磨料顆粒和粗料.碳化硅的化學分析分享友人