粘度控制系數 的英文怎麼說

中文拼音 [niándùkòngzhìxìshǔ]
粘度控制系數 英文
viscosity controlled coefficient
  • 粘 : 粘動詞（粘附） glue; stick; paste; adhere to; bond
  • 度 : 度動詞[書面語] （推測; 估計） surmise; estimate
  • 控 : 動詞1 （告發;控告） accuse; charge 2 （控制） control; dominate 3 （使容器口兒朝下 讓裏面的液體慢...
  • 制 : Ⅰ動詞1 （製造） make; manufacture 2 （擬訂; 規定） draw up; establish 3 （用強力約束; 限定; 管束...
  • 系 : 系動詞（打結; 扣） tie; fasten; do up; button up
  • 數 : 數副詞（屢次） frequently; repeatedly
  • 控制 : control; dominate; regulate; govern; manage; check; cybernate; manipulate; encraty; rule; rein; c...
  • 系數 : [數學] coefficient; ratio; modulus; quotient; factor
  1. The way to get ko was given in this paper. by this way, the turbulence control equations were constructed from reynold equations with static pressure supposition and boussinesq ' s turbulence viscidity coefficient supposition and the salinity transportation equations, which are representative of the matter transportation equations, are given. the integrated deduction and corresponding boundary conditions are also given

    根據上述思想，從雷諾方程出發，採用靜壓假定和包辛內斯克的紊動粘性系數假說，建立了新坐標系中的紊流控制方程組，同時給出了對物質輸運過程具有代表性的鹽度輸運方程、相應的邊界條件及完整的推導過程。
  2. And. the test research on the restrained beams strengthened by epoxy - glued cfrp which is glued in term of different angle is presented. based on the test of shear strengthening by cfrp - bonded, qt. ality control standards of the design and construction is established

    作者對cfrp加固用材料性能、結構受力特徵進行了系統的論述，對按不同角度粘貼cfrp加固的約束梁進行了試驗研究，得到大量數據，並在試驗的基礎上，得出了有關的構造要求、錨固要求等設計施工質量控制條件。
  3. The relationships of modal damping versus the stiffness of cables, the attachment height of damper and damping constant are obtained. with the optimal structural control method, a new approach to determine the optimal damping constant of viscous damper is presented. the first a few modal damping can be optimized simultaneously under the optimal damping constant of damper, which is more convenient than the existed design method

    4 、對拉索-粘性阻尼器系統的動力特性進行了研究，得到了拉索剛度、阻尼器安裝高度及阻尼系數等參數對拉索系統模態阻尼比的影響規律；根據最優控制原理，提出了一種確定阻尼器優化阻尼系數的方法，該方法確定的阻尼系數能保摘要證前幾階模態阻尼比得到整體優化，改進了現有的設計方法。
  4. The research showed that pam could improve soil structure, and greatly increase the stabilization of soil aggregates, so soil crust development would be decreased. fifthly, soil grain that controls rainfall splash erosion was obtained, the influence of soil clay was very great during initial stages of rainfall. with rainfall going on, soil coarse sand and fine sand would control the splash erosion

    五、控制土壤濺蝕的主要土壤粒級：在降雨初期土壤的的粘粒對濺蝕速率的影響較大，隨著降雨歷時的延長，土壤中的細砂和粗砂成為濺蝕速率影響較大的因子；六、對土壤濺蝕影響較大的土壤結構特徵因子：降雨5分鐘時，土壤的滲透系數對濺蝕速率的影響較大，隨著降雨的繼續進行，土壤的團聚度一直對土壤濺蝕速率影響較大。
  5. The particles aggregation was simulated using particle - cluster and cluster - cluster aggregation model. several type of floes was reached and its morphological characteristics was analyzed the fractal dimension, density and porosity of floes was studied by changing sticking probabilities, sticking position, particle number, particle concentration, difrusion coefficient and motion trajectory. the parameters by which special floes growth were determined. in the study of morphology, floes of yellow river ' s loess particles was observed by tv - microscope. its morphological characteristics were obtained by image analysis. the effect of fractal dimensions by stirring time strring speed, macromolecule flocculant dosage, flocculant concentration and particle concentration was studie. its rule of change was obtained. on the basis of other studies, the flocculation kinetics and floes structure was studied

    本文應用計算機模擬技術，在二維空間內採用單體凝聚和集團? ?集團凝聚兩種模型對顆粒凝聚過程進行了模擬，得到了多種形態的絮體，並對絮體進行了形態分析，通過改變粘附概率、粘附位置、顆粒數量、顆粒濃度、擴散系數和運動路徑等模擬參數，我們考察了絮體分形維數、密度和孔隙率隨模擬條件變化的影響規律，得到了形成特定形態絮體的控制參數。
  6. For the present two les models, adopting the subgrid eddy viscosity concept and introducing the transport equation of turbulence energy k, the subgrid scale turbulence is parameterized by the turbulence energy k and the length scale of turbulence / ( k - 1 model ). in addition, vegetation is considered as an internal source of resistant force and turbulence energy

    在應用大渦模擬方法求解數值計算模型控制方程時，亞網格雷諾應力項沿用了亞網格渦粘性系數思路，引入亞網格紊流脈動動能k的輸運方程，建立了關于亞網格紊流脈動動能k和紊流特徵長度l的k - l模型求解。
  7. The dynamics behaviors of the flexible jeffcott rotor system supported by unsteady short dynamic bearing are investigated. based on nonlinear unsteady - state dynamic n - oil film force model described by three functions the local stability of the periodic solutions with the controlling parameters, rotational speed ratio, imbalance amount, damping ratio and viscidity, are predicted by using the floquet multiplier. it is found that the period doubling bifurcation is caused by a certain imbalance amount and the hopf bifurcation is created by the lost stability of the oil - film

    研究了非穩態動載短軸承支撐的jeffcott柔性轉子系統的動力特性，基於可用三個函數表示動態油膜的非穩態非線性油膜力模型，將轉速比、不平衡量、阻尼比、粘度作為控制參數，利用floquet乘子預測周期解的局部穩定性，發現倍周期分叉是由一定量的不平衡引起的，而hopf分叉是由油膜失穩造成的。
  8. Taking the bending stiffness, cable sag and cable inclination into consideration, the space vibration control of the cables using the visco - elastic dampers in cable - stayed bridges is investigated by joining the center difference method and the state space strategy. both the maximum modal damping ration and the optimal damper size are obtained, then the practical suggestions are proposed for the design of the dampers. the space nonlinear vibration equations of the cable - damper system are derived, and a new hybrid method for solving the cable - damper system is presented by combing the newmark method and pseudo - force technology

    綜合考慮了拉索抗彎剛度、垂度的影響，研究了粘彈性阻尼器對斜拉橋拉索的空間振動控制，聯合中心差分方法及狀態空間法，得出了拉索麵內、外振動各階模態可能達到的最大阻尼比及相應的最優阻尼器系數，並對斜拉橋拉索的阻尼器設計提出了參考建議：考慮拉索抗彎剛度、垂度及幾何非線性，導出了索-阻尼器系統的空間振動非線性方程組，結合newmark方法及偽力（ pseudo - force ）方法，創新地提出了求解非線性方程組的雜交方法，根據拉索-阻尼器系統的阻尼特性，在各種荷載作用下，對索-阻尼器系統的非線性瞬態振動響應進行了研究，從系統響應的角度更加直接地驗證了阻尼器的控制效果。
  9. Automatic thickener preparation system can solve the problem of controlling the viscosity of thickener when printing, guarantee thickener fresh, smooth, avoid screen blocking and cost saving, realize high precision dispensing through database management system and quantitative dispensing technic

    愛麗印花糊料準備系統解決了印花過程中的糊料粘度控制問題，保證糊料新鮮度，糊料均化性，糊料的細膩度，減少堵網，降低消耗，並通過數據庫管理系統和定量分配技術實現高精度的定量分配。
  10. This article brings forward a way of computer control system. it can not only control resin viscosity online and display control curve, but also change target value through friendly control interface. it can be operated easily and it will greatly improve control effect

    本文提出樹脂粘度計算機控制系統方案不但能在線測量和控制樹脂粘度，實時顯示粘度控制曲線、粘度值，方便地實現樹脂粘度的設定、傳感器的標定、模糊控制器參數的改變，而且能通過控制界面隨時改變粘度的設定值。
  11. The contents include as follows : the influencing factors of the displacement ductility factor of the unbonded partially prestressed concrete frame structures, such as stirrup reinforcement characteristic value, nominal shear span ratio, axial compression ratio, the appearing order of plastic hinges and partial prestressing ralio ( ppr ) are discussed. the formula of displacement ductility factor of the unbonded partially prestressed concrete frame structures is suggested by regression analysis. with regard to the aseismic design and the request of ductility and energy dissipation, the restriction of the flat - beam / column sectional size and aseismic reinforced design are discussed

    本文主要包括以下內容：討論了配箍特徵值、名義剪跨比、軸壓比、塑性鉸出現順序、預應力度等因素對無粘結部分預應力混凝土框架位移延性系數的影響，回歸了考慮影響因素的位移延性系數計算公式；對無粘結部分預應力混凝土扁梁框架結構，闡述了抗震設計對扁梁、柱截面尺寸的要求與限制；對滿足延性和耗能要求的無粘結部分預應力混凝土扁梁控制截面抗震配筋進行了探討；通過對無粘結部分預應力混凝土扁梁梁端的受力分析，改進了以往扁梁梁端扭矩設計值計算公式。
分享友人
分享到 Line

分享到臉書