粘度控制系統 的英文怎麼說

中文拼音 [niándùkòngzhìxìtǒng]
粘度控制系統 英文
viscosity control system
  • 粘 : 粘動詞（粘附） glue; stick; paste; adhere to; bond
  • 度 : 度動詞[書面語] （推測; 估計） surmise; estimate
  • 控 : 動詞1 （告發;控告） accuse; charge 2 （控制） control; dominate 3 （使容器口兒朝下 讓裏面的液體慢...
  • 制 : Ⅰ動詞1 （製造） make; manufacture 2 （擬訂; 規定） draw up; establish 3 （用強力約束; 限定; 管束...
  • 系 : 系動詞（打結; 扣） tie; fasten; do up; button up
  • 統 : Ⅰ名詞1 （事物間連續的關系） interconnected system 2 （衣服等的筒狀部分） any tube shaped part of ...
  • 控制 : control; dominate; regulate; govern; manage; check; cybernate; manipulate; encraty; rule; rein; c...
  • 系統 : 1. （按一定關系組成的同類事物） system 2. （有條理的;有系統的） systematic
  1. And. the test research on the restrained beams strengthened by epoxy - glued cfrp which is glued in term of different angle is presented. based on the test of shear strengthening by cfrp - bonded, qt. ality control standards of the design and construction is established

    作者對cfrp加固用材料性能、結構受力特徵進行了系統的論述，對按不同角度粘貼cfrp加固的約束梁進行了試驗研究，得到大量數據，並在試驗的基礎上，得出了有關的構造要求、錨固要求等設計施工質量控制條件。
  2. By using the larger magnetic permeability, magnetic fluid was used to improve the magnetic circuit efficiency in torque motor, enlarge the output torque and displacement of torque motor, and the output flow of servo valve. correspondingly, the ability of noise - overcoming and system damping was enhanced due to the property of magnetic fluid. as a result, the stability of servo valve and servo - control system can be improved

    由於磁流體具有較大的導磁率，可提高力矩馬達磁路效率、增大力矩馬達的輸出力矩和位移，從而增加伺服閥的輸出流量;同時，利用磁流體的粘度特性，可增強力矩馬達阻尼及抗干擾能力，從而增強伺服閥及伺服控制系統的穩定性。
  3. The relationships of modal damping versus the stiffness of cables, the attachment height of damper and damping constant are obtained. with the optimal structural control method, a new approach to determine the optimal damping constant of viscous damper is presented. the first a few modal damping can be optimized simultaneously under the optimal damping constant of damper, which is more convenient than the existed design method

    4 、對拉索-粘性阻尼器系統的動力特性進行了研究，得到了拉索剛度、阻尼器安裝高度及阻尼系數等參數對拉索系統模態阻尼比的影響規律；根據最優控制原理，提出了一種確定阻尼器優化阻尼系數的方法，該方法確定的阻尼系數能保摘要證前幾階模態阻尼比得到整體優化，改進了現有的設計方法。
  4. Die bonder is a kind of microelectronics encapsulation device that welds transistors to the base. temperature control system is one important part of it

    粘片機是一種將晶源焊接到底座的微電子封裝設備，溫度控制系統是其較為重要的組成部分。
  5. The dynamics behaviors of the flexible jeffcott rotor system supported by unsteady short dynamic bearing are investigated. based on nonlinear unsteady - state dynamic n - oil film force model described by three functions the local stability of the periodic solutions with the controlling parameters, rotational speed ratio, imbalance amount, damping ratio and viscidity, are predicted by using the floquet multiplier. it is found that the period doubling bifurcation is caused by a certain imbalance amount and the hopf bifurcation is created by the lost stability of the oil - film

    研究了非穩態動載短軸承支撐的jeffcott柔性轉子系統的動力特性，基於可用三個函數表示動態油膜的非穩態非線性油膜力模型，將轉速比、不平衡量、阻尼比、粘度作為控制參數，利用floquet乘子預測周期解的局部穩定性，發現倍周期分叉是由一定量的不平衡引起的，而hopf分叉是由油膜失穩造成的。
  6. Taking the bending stiffness, cable sag and cable inclination into consideration, the space vibration control of the cables using the visco - elastic dampers in cable - stayed bridges is investigated by joining the center difference method and the state space strategy. both the maximum modal damping ration and the optimal damper size are obtained, then the practical suggestions are proposed for the design of the dampers. the space nonlinear vibration equations of the cable - damper system are derived, and a new hybrid method for solving the cable - damper system is presented by combing the newmark method and pseudo - force technology

    綜合考慮了拉索抗彎剛度、垂度的影響，研究了粘彈性阻尼器對斜拉橋拉索的空間振動控制，聯合中心差分方法及狀態空間法，得出了拉索麵內、外振動各階模態可能達到的最大阻尼比及相應的最優阻尼器系數，並對斜拉橋拉索的阻尼器設計提出了參考建議：考慮拉索抗彎剛度、垂度及幾何非線性，導出了索-阻尼器系統的空間振動非線性方程組，結合newmark方法及偽力（ pseudo - force ）方法，創新地提出了求解非線性方程組的雜交方法，根據拉索-阻尼器系統的阻尼特性，在各種荷載作用下，對索-阻尼器系統的非線性瞬態振動響應進行了研究，從系統響應的角度更加直接地驗證了阻尼器的控制效果。
  7. Viscosity control system

    粘度控制系統
  8. Several problems are resolved in this paper : firstly, the control system for viscosity of the mr fluid is developed. the variation of current in the armature of mixed electromotor is monitored real time to calculate the variation of the viscosity of the mr fluid

    首先，研製了磁流變液的粘度控制系統，採用檢測攪拌電機電樞電流變化的方法實時檢測磁流變液粘度的變化。
  9. Automatic thickener preparation system can solve the problem of controlling the viscosity of thickener when printing, guarantee thickener fresh, smooth, avoid screen blocking and cost saving, realize high precision dispensing through database management system and quantitative dispensing technic

    愛麗印花糊料準備系統解決了印花過程中的糊料粘度控制問題，保證糊料新鮮度，糊料均化性，糊料的細膩度，減少堵網，降低消耗，並通過數據庫管理系統和定量分配技術實現高精度的定量分配。
  10. This article brings forward a way of computer control system. it can not only control resin viscosity online and display control curve, but also change target value through friendly control interface. it can be operated easily and it will greatly improve control effect

    本文提出樹脂粘度計算機控制系統方案不但能在線測量和控制樹脂粘度，實時顯示粘度控制曲線、粘度值，方便地實現樹脂粘度的設定、傳感器的標定、模糊控制器參數的改變，而且能通過控制界面隨時改變粘度的設定值。
  11. Aiming at the essential defect of pneumatic medium, pneumatic hydraulic combination control ( phcc ) servo system is formed, in which the liquid medium with low compressibility and high viscosity is introduced into a normal pneumatic servo system and is closed - looped controlled simultaneously

    氣液聯控伺服系統正是基於克服或者補償氣體介質的根本缺點，將可壓縮性小、粘度較大的液體介質引入到常規氣壓伺服系統中，並進行控制而構成的一種新型的氣、液介質復合控制系統。
  12. Currently most domestic break - test - plateform adopt the liquid - pressure - servo technique, which possesses the advantages of higher frequency - response and higher controlling exactness, but in the same time, the disadvantages of higher cost, variation of function with the change of oil viscousness produced by the fluctuation of temperature. moreover, the liquid - pressure system is sensitive to the pollution of oil, so it is necessary to take protective and filtrating steps

    目前，國內的制動器試驗臺大多採用的是液壓伺服控制，這種控制具有響應頻率高、控制精度高等優點，主要缺點是系統成本高、油液粘度隨溫度變化引起工作性能的變化、且液壓系統對油液的污染比較敏感，必須要有良好的保護和過濾措施。
  13. According to the characteristic of fermenter, we designed the control system based on single chip computer and personal computer, realizing the measurement and control over do, ph, temperature, pressure, ventilating rate and the speed of the stirring motor

    根據發酵罐的特點，本文基於單片機和pc機結合，設計了發酵過程自動控制系統，實現do 、 ph 、溫度、罐壓、通氣量和攪拌電機轉速的測控以及發酵液的粘度的在線測量。
分享友人
分享到 Line

分享到臉書