粘度曲線 的英文怎麼說

中文拼音 [niándùqūxiàn]
粘度曲線 英文
viscograph
  • 粘 : 粘動詞（粘附） glue; stick; paste; adhere to; bond
  • 度 : 度動詞[書面語] （推測; 估計） surmise; estimate
  • 曲 : 曲名詞1 （一種韻文形式） qu a type of verse for singing which emerged in the southern song and ji...
  • 線 : 名詞1 （用絲、棉、金屬等製成的細長的東西） thread; string; wire 2 [數學] （一個點任意移動所構成的...
  • 曲線 : [數學] curve; bight; bought; profile; net曲線板 french curve; irregular curve; curve board; splin...
  1. This clay shows an endotherm due to dehydroxylation near this temperature.

    這一粘土的曲線在此溫度附近出現一個由脫羥基吸起的吸熱峰。
  2. 3. a space bond slip relation of reinforcements in either end of a member is proposed, based on one - dimensional bond slip model of reinforcements proposed by teng zhiniirmg from tsinghua university, the first - time loaded ascending stage ? curve of which model is modified as the line which parameters are not changed so as to simply the computation. the bond, slip is regarded as the boundary nonlinearity of a member

    3 、採用清華大學滕智明建議的一維鋼筋粘結滑移恢復力模型，但從簡化計算的角度出發，將首次加載的上升段曲線改為直線，並假定構件端部的諸多縱向鋼筋的滑移服從平截面假定，考慮由節點錨固區粘結滑移引起的構件端截面軸向和兩轉角附加變形。
  3. To meet the demands for large space and flexible compartmentation of buildings, laminated vierendeel trusses are adopted in high - position transfer story structures. first the bearing characteristics are analyzed, in which reasonable stiffness ratio of the upper chord, middle chord, and lower chord is derived. then combined with an actual engineering model ( 1 8 similar ratio ), the static loading and pseudo - dynamic tests of two models for laminated vierendeel truss used in transfer story structures are conducted, in which one model adopts reinforced concrete, and the other adopts prestressed concrete and shape steel concrete. seismic behaviors are analyzed, including inter - story displacement, base shear - displacement skeleton curves, and equivalent viscosity - damping curves. a program is programmed to carry out the elasto - plastic dynamic analysis, and displacement time - history curves of the two models are derived. the test and analysis results show that the laminated vierendeel truss with prestressed concrete and shape steel concrete has excellent seismic behaviors. it can solve the disadvantages of laminated vierendeel trusses used in transfer story structures. finally, some design suggestions are put forward, which can be referenced by similar engineering

    為滿足建築物大空間和靈活隔斷要求，在高位轉換層結構中採用迭層空腹桁架結構.首先分析了其受力性能，得出了空腹桁架各構件合理的截面剛度以及布局形式.然後結合一實際工程，進行了兩榀迭層空腹桁架轉換結構模型（ 1 : 8相似比）的豎向荷載下靜力試驗以及擬動力試驗.其中一榀為普通混凝土迭層空腹桁架，另一榀配置了預應力和鋼骨混凝土，對比分析了兩模型的層間位移比、骨架曲線以及等效粘質阻力系數等抗震性能的比較，並進行了彈塑性動力分析.試驗和分析結果表明，配置預應力和型鋼混凝土的迭層空腹桁架轉換結構具有良好的抗震性能，可以成功地解決迭層空腹桁架作為轉換層結構所產生的弊端問題，最後對這類轉換層結構提出了相應的設計建議
  4. Among the properties which do not show a leveling-off are the viscosities of solutions and melts.

    溶液和熔體的粘度等性能曲線並不呈現平坦。
  5. A method is provided to measure the friction parameters of the bed. the maximum friction torque, coulomb friction torque, viscous friction coefficient and moment of inertia can be gotten by fitting the free reduced rate curve of the gimbals and measuring the motor current when the motor begins to rotate

    提出了一種測量轉臺摩擦特性的方法，通過對轉臺在無外推力作用下的速度衰減曲線的擬合以及電機啟動過程電流和轉速的測量，可以得到最大靜摩擦力矩、庫侖摩擦力矩、粘滯摩擦系數及轉動慣量。
  6. The theoretical study of the recovery percent vs. water cut of thin and bottom water reservoir in luliang oilfield is based on developing its geologic and flow models, obtaining oil - thickness ratio, oil - water viscosity ratio, relative permeability curve parameter and chart of effect of bottom water toning, etc., on water - yielding pattern of the reservoir

    摘要在建立了陸梁薄層底水藏地質及滲流模型基礎上，採用理論研究的方法，研究了薄層底水油藏采出程度與含水率關系式，並獲得了油厚比、油水粘度比、相滲曲線特徵參數以及底水錐進等對油藏產水規律的影響關系圖版。
  7. Determination of viscosity - temperature charts for crude oil with rotational viscometers

    原油粘溫曲線的確定.旋轉粘度計法
  8. By analyzing parameters of the model, we find out that shale distribution largely affects water saturation calculated by the model, the less the resistivities of sand grains or clay grains, the more largely the resistivities of grains affect the relation between ct and swt, the effect of m on the relation between ct and swt is increased with swt

    通過對該模型的影響因素分析，發現泥質分佈形式對模型計算的含水飽和度有很大影響；砂巖顆粒或粘土顆粒的電阻率越小，顆粒電阻率對c _ t與sw關系影響越大； m （ m = n ）對c _ t與s _ （ wt ）關系曲線的影響隨s _ （ wt ）的增大而增大。
  9. The response of mmcs has a turning point, associated with the initiation of interfacial debonding, which is decided by the interfacial strength. unlike the two predecessors, the evolving complaint interface ( eci ) model allows unloading of interfacial stresses

    在常響應界面情況下，復合材料橫向拉伸應力?應變曲線存在明顯的轉折點，對應于界面分離的始發點，轉折點的位置取決于界面粘結強度。
  10. The specimen of the test was stimulated by viscoelastic model and the wheel load was stimulated by special function, which are brought into viscoelastic equation. after solving the equation, we can work out the theoretical answer. thus we can figure out the ds and the deformation curve

    本文應用粘彈性理論研究車轍試驗，應用粘彈性模型模擬車轍試驗的試件，擬合車轍試驗的輪載，帶入粘彈性本構方程，獲得理論解，從而獲得車轍試驗的變形曲線和動穩定度值。
  11. Based on the method of limitation analysis of soil plasticity, researching from the soil arching mechanism of soil - nailing retaining, the upper limit of the critical height of soil - nailing slopes and the minimum horizontal length from coping of the potential slide surface to the edge of deep excavation are obtained through the analysis to weight of soil and vertical loading and the mechanism of soil and soli - nailing acting reciprocally

    摘要基於土的塑性極限分析方法，以均質土坡為例，從土釘支護結構的準粘聚力理論出發，綜合考慮土體自重、坡頂的條形荷載，以及土釘與土體的相互作用的機理，推導出了土釘支護的臨界高度的上限值和潛在螺旋曲線滑動面在坡頂方向距基坑邊沿的最小水平距離解析表達式，可供基抗支護設計參考。
  12. In all these 20 specimens, the embedded electronic steel - concrete slip transfer were respectively embedded on the steel shape webs and inside and outside of the flanges at certain intervals along the embedment length to measure the distributions of the interior slip, and the electronic strain gauges were also installed on the shallow grooves of each steel shape web and flanges at close intervals along the length to measure the distributions of the steel shape web and flanges strain, from which the distributions of bond stress were obtained. with these methods of measuring the distributions of slip and bond stresses, the establishment of the bond - slip constitutive relations were ensured

    用力的平衡方程，得到推出試驗中型鋼混凝土粘結應力的大小及其分佈規律;根據鋼一混凝土電子滑移傳感器的滑移量測結果，分析了沿型鋼埋置長度的內部滑移分佈規律，並對試驗量測的特徵滑移值進行了統計回歸;根據粘結應力和內部滑移測量結果，得出沿型鋼埋置長度方向上各截面的局部粘結應力一滑移關系曲線，建立了局部粘結滑移本構模型嘆x ）一s仁， ， … ， c ， … c 。
  13. The tendons of unbounded ppc have smaller fraction force and are easier to bend to many shapes, so it is more suited for building these rooms whose span are large

    無粘結預應力筋摩擦力小，且易彎曲成各種形狀，特別適合建造需用復雜的連續曲線配筋的大跨度樓蓋和屋蓋。
  14. And the calculated results closely coincide with experimental results. furthermore, the paper, through applying the improved algorithm to the load - deflection curve and secondary load, also the calculated curves closely coincided with experimental results ( showed as chart 3. 17 - 3. 20 )

    本文還將改進的演算法運用於粘貼加固受彎構件的荷載?撓度曲線和二次受力問題的計算中，得出與試驗結果吻合較好的計算曲線（圖3 . 17 3 . 20 ） 。
  15. Then, by analyzing the extensive test data of load - displacement and bear - curvature, we can conclude that the crack resistance, bearing capacity of normal section and short - dated rigidity will be improved a lot when the strength of concrete is not so low

    然後，通過對各組試件的荷載-撓度曲線的進一步分析表明：對于混凝土強度等級高於c15的鋼筋混凝土梁，採用這種粘角鋼加固法能有效提高鋼筋混凝土梁的正截面承載力和短期剛度。
  16. In the paper, by using bp ( back propagation ) method of ann, we can get the relationship between grading, asphalt - aggregate ratio, bulk density, percentage of voids, test temperature and ds. at the same time, we can get the relationship between grading, asphalt - aggregate ratio, bulk density, percentage of voids, test temperature and viscoelastic parameter. at last, we can estimate the ds and draw the deformation curve

    本文應用bp人工神經元網路，建立瀝青混合料的礦料通過百分率、瀝青用量、毛體積密度、空隙率、試驗溫度與瀝青混合料粘彈性參數的關系，或建立瀝青混合料的礦料通過百分率、瀝青用量、毛體積密度、空隙率、試驗溫度與車轍試驗動穩定度值的關系，從而預估車轍試驗的動穩定度值和繪制車轍試驗變形曲線。
  17. The results showed that process parameters varied with time in fermentation was distinct for different agitator and the hydrofoil impeller instead of the disc turbine impeller might significantly reduce power consumption under the same condition

    研究結果表明： （ 1 ）與傳統的渦輪攪拌槳相比，翼形軸流槳攪拌其發酵過程參數（粘度、溶氧、效價等）隨時間的變化曲線有明顯的差異； （ 2 ）在相同的生產條件下，用冀形軸流槳代替渦輪槳可有效提高生產效率。
  18. Glass - viscosity and viscometric fixed points - part 4 : determination of viscosity by beam bending iso 7884 - 4 : 1987

    玻璃.粘度和粘度固定點.第4部分:射線束彎曲法測定粘
  19. Glass - viscosity and viscometric fixed points - part 7 : determination of annealing point and strain point by beam bending iso 7884 - 7 : 1987

    玻璃.粘度和粘度固定點.第7部分:射線束彎曲法測定退
  20. Standard viscosity - temperature charts for liquid petroleum products

    液體石油產品粘度-溫度曲線圖標準
分享友人
分享到 Line

分享到臉書