粘接試驗 的英文怎麼說
中文拼音 [niánjiēshìyàn]
粘接試驗
英文
adhesive test-
Testing methods for alpha - cyanoacrylate adhesives
-氰基丙烯酸酯粘接劑的試驗方法First, a simple discussion for the mechanism about electrostatic atomization of the liquids has been given ; then the paper theoretically analyzed waving course, liquid drop producing course, and the liquid drop diffusing course in electrostatics atomization process., gave an analysis about the methods about carrying charges to the liquid drop, and analyzed that liquid with high electrical conductivity can be carried charges and atomized by electric field, while the isolated liquid with low electrical conductivity can be charged fully with the soakage electrode and inducing charge methods. at last the paper designed and configured the experimental equipment, conducted the atomization experiment to the three liquid medium - kerosene, emulsifier and alcohol under the same environment, handled the experimental results, then summarized the relationship between liquid electrostatic atomization effect and liquid surface tension, electronic conductivity and viscosity, along with the influence of voltage to electrostatic atomization and so on, found out the liquid atomization rule in high voltage electrostatic field
首先,對液體介質的靜電霧化機理作了初步的探討,理論上分析了液體霧化過程中射流區、波紋區、霧滴區和霧滴擴散區;然後對液體荷電方法進行了研究分析,對于高電導率的液體,場致荷電和接觸荷電可以使其霧化,而對于電導率較低的絕緣液體,需用浸潤電極荷電和感應荷電方法使其充分帶電;最後,根據前面的研究分析,設計和組裝試驗裝置,在同一環境下對煤油、乳化劑、酒精三種不同液體介質進行高壓靜電霧化試驗,並對試驗結果進行分析處理,總結出液體靜電霧化與液體表面張力、電導率和粘度的關系及電壓對液體靜電霧化的影響等,得出高壓靜電場中液體霧化的一般規律。Jointing products. mastics for bonding of connex or concave tiles. test methods
填縫用品.凸凹磁磚粘接膠合.試驗方法Testing of adhesives for metals and adhesively bonded metal joints ; creep test on single lap joints
金屬和粘結的金屬接點用的粘合劑的試驗.單搭接粘膠點Jointing products - mastics - test cone penetrability
接縫產品.膠粘劑.試驗圓錐貫入度Indirect methods to measure the interface bond strength include the interlaminar shear strength test.
測量界面粘結強度的間接方法包括層間剪切強度試驗。The histologic lesions were characterized by the remarkable atrophy of intestinal villi, basal vacuolation of enterocytes, increment of the crypt and the villus - to - crypt ratio had significantly decrease. compared with that of noninoculated control chicks. besides. intestinal villi become thin and flat. or cubic, also accompanied with necrosis. many villous enterocytes were detached from the lamina propria and the lamina propria contained a diffuse infiltrate of lymphocytes, plasma cells, macrophages. the characteristic ultrastructural changes observed by electronmicroscope were swelled mitochondria and dilated endo - plasticreticulum. ribosome on the surface of endo - plasticreticulum fall off and the number of ribosome within the cell decrease
動物回歸試驗中接種兩周齡spf雞, 24h后陸續發病,表現為持續性水樣腹瀉;剖檢可見病雞脫水、小腸內有大量的液體和氣泡、腸粘膜變薄;組織學變化為腸絨毛上皮壞死、脫落,絨毛平均長度減少而隱窩深度增加,固有層中淋巴細胞浸潤。其臨床癥狀及病理組織學變化與自然發病相同。Test method for measuring strength and shear modulus of nonrigid adhesives by the thick - adherend tensile - lap specimen
用厚粘附體拉力搭接樣品測定軟質膠粘劑的強度和剪切模數的試驗方法Standard test method for thick - adherend metal lap - shear joints for determination of the stress - strain behavior of adhesives in shear by tension loading
拉伸載荷法測定剪切中膠粘劑應力-應變性能用厚被粘物金屬搭接-剪切接頭的標準試驗方法The fem analysis for the three structures of sling screw - thread - based, namely the circle, rectangle and that with strengthen plate, and the tensile test for sling screw - thread - based in torpedo body show, that the bonding with strengthen frp plate between load - bearing metal parts and frp hull with hatch can reduce the stress concentration and significantly decline the local stress in frp hull with hatch. this structure can also be used in the similar produces. ( 3 ) the effects of parameters for bonding process on the adhesive strength and leakproof are discussed, such as the bonding interface reduce, bonding surface treatment, match of adhesive surface, protect for adhesive seam and so on
本文通過某型號雷體吊耳螺紋座結構的三種方案,即圓形昂耳螺紋座、長方形吊耳螺紋座、具有增強板的吊耳螺紋座的有限元分析及雷體吊耳螺紋座拉力試驗結果證明:金屬承力件與開口玻璃鋼殼體粘接採用玻璃鋼增強板補強,緩和了應力集中,使開口殼體局部應力明顯降低,類似的水下兵器用金屬承力件與開口復合材料殼體膠接均可採用此種結構形式。Standard test method for bond strength of adhesive systems used with concrete as measured by direct tension
用直接拉力測量與混凝土一起使用的膠粘系統的粘合強度的標準試驗方法Gummed tape - testing methods for adhesive strength
膠帶.粘接強度試驗方法In this paper, a high performance sma system applied to steel bridge deck is put forth in allusion to the pavement project of the wuhan junshan yangtze river highway bridge. it comprises steel slab, zn coating layer, closing layer, adhesive, pre - mixed asphalt stone and dual layer sma from bottom to top. it is based on the fea results of the forces and deformation of the pavement layer by means of the algor feas, according to this bridge ' s traffic and the ambient temperature varying range of the pavement layer
本文針對武漢軍山長江公路大橋鋼箱梁橋面鋪裝工程,從鋪裝層環境溫度變化范圍、交通量等使用條件出發,在用algorfeas有限元分析軟體分析鋪裝層受力變形基礎上,提出了(即鋼板+金屬鋅塗層+封閉層+粘接劑+預拌瀝青碎石+雙層sma )的高性能鋼橋面sma鋪裝體系,並對這種sma的組成材料,包括改性瀝青、集料、礦粉、纖維進行了比較研究,設計了這種sma的配合比,對sma混合料的性能進行了對比試驗,對這種sma方案進行了疲勞性能研究,驗證了所選擇sma方案的可行性。Testing of mortars containing mineral binders - part 9 : hardened mortars ; determination of the mortar compressive strength in the bed joint
含礦物粘合劑灰漿的試驗.第9部分:凝固灰漿.層間接縫In the aspect of improving the cracking feature, compatibility and flexibility, the author has done experiments, including strength, modulus of elasticity experiments, and design some experiments similar to the practical structure and circumstance including adhesion strength between fresh mortars and old ones, between mortar and polystyrene board, mortar shrinkage in concrete circle, mortar shrinkage at different strength and different polymer - cement ratio, and temperature deformability at different strength and different polymer - cement ratio on mortars, on different type of formwork and on mortars with different type of formwork
在改善砂漿抗裂性、提高柔韌性和協調變形能力方面,進行了不同聚合物摻量的強度試驗、彈性模量試驗;設計了與模網混凝土實際結構和情況相接近的新老砂漿粘結強度試驗、砂漿與苯板的粘結試驗以及混凝土環中的砂漿收縮試驗;進行了不同強度、不同聚合物摻量下的砂漿干縮變形試驗、溫度變形試驗,以及不同結構形式的鋼網自身溫度變形試驗和配有鋼網的砂漿溫度變形試驗。Testing of plastics sheets ; adhesion test
塑料薄板材的試驗.粘接試驗Hot applied joint sealants - test method for the manufacture of concrete test blocks for bond testing recipe methods
熱用接縫密封膠.粘結試驗用混凝土試驗塊生產的試驗方法Testing methods for paints - part 5 : mechanical property of film - section 6 : adhesion test cross - cut test erratum 1
塗料試驗方法.第5部分:薄膜的機械特性.第6節:粘接試驗Testing methods for paints - part 5 : mechanical property of film - section 7 : adhesion test pull - off methods erratum 1
塗料試驗方法.第5部分:薄膜的機械特性.第7節:粘接試驗Adhesives - test methods for floor coverings and wall coverings - determination of dimensional changes of a linoleum floor covering in contact with an adhesive
膠粘劑.地板覆蓋物和墻壁覆蓋物用膠粘劑試驗方法.與膠粘劑粘接的油氈地板覆蓋物尺寸變化測定分享友人