糙度參數 的英文怎麼說
中文拼音 [cāodùshēnshǔ]
糙度參數
英文
roughness parameter-
Based on the diopter status of myopia and hypermetropia, the paper presented the principle of excimer laser refractive surgery, the change of impacting cornea curvature on the cornea diopter. in this chapter, we also discussed excimer laser - corneal tissue interactions and photoablation. determine the relationship between the fluence of arf excimer laser and the cornea ablation rate, attain the relationship between the energy density and the ablation depth
研究了激光與生物組織相互作用、光蝕作用及準分子激光消融角膜的機理；首次定量研究193nm準分子激光高斯光束的切削量與能量密度的關系，計算單個激光脈沖角膜切削量；發現了角膜曲率對切削效果的影響，首次提出了角膜曲率半徑、切削位置與切削深度的關系；首次定量確定了激光光斑參數及其排列方式對術后角膜表面粗糙度的影響，為更精確實現角膜切削和提高切削后角膜表面光潔度、減少手術后角膜渾濁及角膜表面術后不規則提供了理論依據。Integrating tynman system with polarized system together, the laser interferometer is compatible for the surface with different reflectance. first, on the basis of synthesizing different interferometric microscope, the author introduced a kind of lase interferometer combining polarized interferometry and real - time phase detection algorithms. first, a kind of optical configuration is introduced, which is realized in the above interferometer
本文在分析了國內外不同干涉顯微系統的基礎上，根據干涉顯微測量方面的需求提出了採用偏振干涉和條紋掃描方式實時檢測波面位相的激光干涉顯微系統，提出了一種可用於表面微觀輪廓及粗糙度參數測量的光學顯微干涉系統的光路，然後介紹了條紋掃描波面位相實時檢測技術以及四步移相法，並在此基礎上完成了光學系統及相關的機械結構。Therefore, in principle the scattering may be predicted from measurements of the surface profile. in this paper the author also discussed nonspecular scattering for mo / si multlayer coated primary and secondary mirrors of the measured schwarzschlid optics based on power spectral density of these mirrors measured by both optical profilometer ( wyko ) and atomic force microscopy ( afm )
因此，我們可以通過檢測多層膜反射鏡基底的粗糙度來表徵多層膜反射鏡非鏡面散射對光學系統性能的影響，亦即通過檢測多層膜反射鏡基底的粗糙度調整拋光工藝參數，獲得低散射的多層膜反射鏡。A transfer model is established, which can be used to study the interaction between the land surface physical processes of inhomogeneous region and the structure of atmosphere boundary - layer over urban and rural terrains. the model has simulated surface heat flux, surface temperature, temperature profiles, height of mixture layer and so on. and the differences between urban area, suburban area and rural area have been compared. this model mainly depends on the parameters below : surface albedo, surface roughness coefficient, moisture available coefficient of soil, thermal capacity and thermal diffusion coefficient of errain, cloudage. the result shows that this model can simulate the structure and eigenvalues of atmosphere boundary layer and their changes in a day. parameters used in this model aim at beijing city, and the time is at the beginning of september. to other cities, or other time, the parameters should be adjusted accordingly. in addition, being adjusted, the model can also be used for other homogeneous and inhomogeneous terrains
模式主要依賴于以下參數和物理量：地面反照率下墊面粗糙度土壤的可含水量下墊面的熱容量和熱擴散系數雲量等參數。結果表明，本模式能合理地模擬不同地表熱量平衡地表氣溫混合層高度湍流交換系數湍流動能位溫廓線等，以及它們的日變化。該模式所取參數主要針對北京市，時間為九月初，對于其他城市，參數應作相應的調整。In the current criteria, the principal parameters are given from linear elasticity analysis. the effects of cumulation in elasto - plastic working stage is hardly analysis. the stiffness calculation of current eccentric compression member is not specialy stipulated, with the result that the calculation of internal forces are crude
指出《規范》公式中的主要參數均基於線性（彈性工作階段）分析，對結構實際工作階段（包括彈塑性、塑性工作階段）由於損傷累積而引起結構性能的變化涉及較少，對常見的偏壓構件的剛度計算也未作專門規定，這使得以往內力計算較為粗糙。For parameter a, there is a close relationship exist between a ( 9, sr ) in two different radar incident angle that can be expressed as : with considering the effects of soil texture, we get the final expression of the inversion model : where mv ( t1 ), mv ( t2 ) is volumetric soil moisture content in two different temp, c, d is soil type related parameters, and v ( t1 ), s ( t2 ) is coresponding bare soil radar backscattering coefficients. inversion results show that for the c band hh polarized radarsat scansar data with a range of incidence angle from 20 to 40, the soil moisture change value can be derived with an acceptable accuracy using the above model. the temporal and spatial soil moisture change patterns are associated with rainfall and vegetation cover, as well as the soil hydraulic characteristics
利用最新發展的電磁波散射模型研究了不同植被覆蓋地表雷達波對地表土壤水分的敏感性，建立了半經驗植被雷達後向散射模型; 2 ） .研究發現在農作物等矮小植被覆蓋地表，植被層直接後向散射與植被類型相關，且在植被生長期，雷達後向散射系數對植被含水量的敏感性要高於對植被高度變化的敏感性; 3 ） .解決了單參數雷達地表土壤水分反演問題中，雷達入射角和地表粗糙度的影響這一難點問題; 4 ） .利用土壤介電模型校正了不同土壤類型對反演地表土壤體積含水量的影響; 5 ） .在以上成果基礎上，建立了完整的單參數雷達地表土壤水分變化探測反演演算法，經地表驗證，模型反演地表土壤水分變化值的精度為rmse = 0( 3 ) for parameterization of the sensible heat, the positively correlation between surface temperature and bulk transfer coefficient lead to a positive additional sub - scale flux. its magnitude is determined by the grid average roughness and average wind velocity on the reference level
（ 3 ）對區域感熱通量的計算而言，由於地表溫度和整體輸送系數產生一個正的次網格通量項，它主要由網格平均粗糙度和參考高度平均風速所決定。Aluminum products with shing uniform surface was prepared by electrochemical graining process, including alkaline cleaning, 1 % naoh etching, electrochemical roughing in hcl, naoh treating and anodizing in 5 % h2so4 etc
摘要研究了鋁材無掛灰電化學砂化處理工藝。以鹽酸作為電解液的主成分，控制合適的電流密度和電解時間等工藝參數，通過6步處理，得到砂化均勻、粗糙度適中及光亮的砂面。Ito substrate with an smooth surface of 0. 2nm rms roughness measured by afm was obtained by the developed pre - cleaning processing procedure. mbe growth of znsxse1 - x thin films on ito coated glass substrates were carried out using zns and se sources. the xrd 9 / 29 spectra resulted from these films indicated that the as - grown polycrystalline znsxse1 - x thin films had a preferred orientation along the ( 111 ) planes
採用分子束外延技術在ito導電玻璃上低溫沉積了zns _ xse _ （ 1 - x ）多晶薄膜，詳細研究了薄膜制備的工藝參數，在最佳沉積條件下，制備獲得了晶型為立方閃鋅礦，並具有（ 111 ）面高度定向生長結構的柱狀zns _ xse _ （ 1 - x ）多晶薄膜，其rms表面粗糙度最小可達1 . 2nm 。Firstly, the influence of reaction time between laser and material on the roughness is studied by changing the speed of laser beam. secondaly, the optimized parameters are found by adjusting laser power and defocus
一方面，通過改變激光加工頭的運動速度，考察激光與晶元材料的相互作用時間對側壁表面粗糙度的影響;另一方面，調整激光的功率和離焦量，找出最優化參數。Choice of parameter based on vprs with asymmetric bounds
基於不對稱邊界的變精度粗糙集的參數選擇The basic rough set theory is introduced in brief. the method of how to get the decision rules through the rough set and recent popular arithmetic methods are mentioned. finally, a real - life example is given to explain the basic notions and get the decision rules to illustration the problem
3 .引入非參數式可變精度粗糙集模型，介紹一些基本的概念和性質，並給出證明;用分佈一致性方法來對多屬性決策問題進行多屬性約簡，引入相關的概念，並對所得到的性質和判定定理，給予理論上的證明，得出最後的決策步驟，並且最終獲得多屬性決策問題的決策規則。One dimension river flow roughness parameter inverse analysis kalman filter is introduced into the model to solve stochastic error in observed data. applying kalman filter automatism revising system, dynamic roughness course is obtained. using dynamic roughness course the model result precision is improved, it is more consistent with observed data
對於一維河道糙率參數反分析，針對觀測資料存在的隨機誤差，引進卡爾曼濾波器的自動校正系統，求解出河道糙率變化的動態過程，使用動態糙率計算，明顯改善模型的模擬精度，使模擬過程和觀測過程很好吻合。Surface ronghness parameters and their values
表面粗糙度參數及其數值Surface roughness of tooth flanks ; roughness parameters, surface grades
齒面表面粗糙度.粗糙度參數.表面等級Powder metallurgy products - surface roughness - parameters and their values
粉末冶金製品表面粗糙度參數及其數值The roughness coefficient experiments indicate that the change in tropical cyclone intensity will be varied with different coefficient. also the experiment indicates the wind of tropical cyclone is reduced by the land and the effect of an tropical cyclone landfalling process could result in the height increasing of tropical cyclone boundary layer
通過不同的陸地粗糙度參數數值試驗，結果表明，粗糙度越大，熱帶氣旋強度減弱越多，其造成的非對稱結構也越明顯；而且，由於登陸作用，陸地一側的地表風減小，登陸的摩擦作用將可能導致邊界層的高度增加。By means of a mass of shear strength test of rough cement face of concrete - bedrock, influences of cement face roughness of two mediums on shear strength parameter, shear deformation characteristics, shear failure mechanics are systemically studied. empirical relationship between fractal dimension of cement face roughness and shear strength parameters is established
通過大量的混凝土?基巖粗糙膠結面抗剪強度試驗，系統研究了兩相介質膠結面粗糙度對其抗剪強度參數值大小、剪切變形特徵、以及剪切破壞機理的影響，建立了膠結面粗糙度分維數與抗剪強度參數之間的經驗關系式。Studying deeply on shear strength characteristics of rough cement face has an important meaning for precise determination of shear strength parameter and analysis on failure mechanics
深入研究粗糙膠結面抗剪強度特性對準確確定其抗剪強度參數值及分析其破壞機理具有重要意義。The extracted values of 3 surface parameters i. e., the roughness w, lateral correlation length, and roughness exponent a are in good accordance with the set values
所得到三個表面參量粗糙度w ，橫向相關長度和粗糙度指數的值與所設定的值符合得較好。分享友人