紊流標度 的英文怎麼說

中文拼音 [wènliúbiāodù]
紊流標度 英文
scale of turbulence
  • 紊 : 形容詞（紊亂） disorderly; confused
  • 流 : Ⅰ動1 （液體移動; 流動） flow 2 （移動不定） drift; move; wander 3 （流傳; 傳播） spread 4 （向壞...
  • 標 : Ⅰ名詞1 [書面語] （樹梢） treetop; the tip of a tree2 （枝節或表面） symptom; outside appearance; ...
  • 度 : 度動詞[書面語] （推測; 估計） surmise; estimate
  • 紊流 : burble
  1. The way to get ko was given in this paper. by this way, the turbulence control equations were constructed from reynold equations with static pressure supposition and boussinesq ' s turbulence viscidity coefficient supposition and the salinity transportation equations, which are representative of the matter transportation equations, are given. the integrated deduction and corresponding boundary conditions are also given

    根據上述思想，從雷諾方程出發，採用靜壓假定和包辛內斯克的紊動粘性系數假說，建立了新坐標系中的紊流控制方程組，同時給出了對物質輸運過程具有代表性的鹽度輸運方程、相應的邊界條件及完整的推導過程。
  2. The nonlinear exponent is a function of the radial distance from the pumping well. the two - regime well flow problems being in the steady state. in the fourth chapter, the problems of two - regime well flow have been discussed concentrating on a kind of special seepage law

    第四章對一種特殊的非線性滲流規律即充分紊流的情況，進行了全面、詳細地討論，推導出了該情況下井流問題的滲流速度、水頭降深和井流函數的解析表達式，作出了些具有代表性的標準曲線。
  3. Abstract : based on the turbulent flow kinetics theory the paper describes astudy on two - region flocculation model, the turbulent region is the dominant effect of fiocculation speed, the transition region is the dominant effect of scale and compactness of floculating body, and the order magnitude of available energy disipation and controlling index is put forward

    文摘:應用紊流動力學原理，分析紊流條件下兩區絮凝模型，提出紊流區主導絮凝速率，過渡區主導絮凝體的成長尺度及密實度，導出了有效能耗的量級及絮凝控制指標。
  4. The standard k - e turbulence model was employed in the core region of the cavity. two low reynolds number turbulence models, single equation model and launder and sharma low - reynolds number k - e model, were used in the near wall regions

    在紊流核心區採用標準k -模型，近壁區分別採用單方程模型和launder ? sharma低雷諾數k -模型，採用simple演算法，求解並獲得了盤腔中的速度和壓力場、全域的溫度場以及流固界面上的換熱系數和努謝爾數分佈。
  5. In this paper, based on the navier - stokes equation and the k - turbulent model, the numerical simulation of the 3d turbulent flow in a centrifugal impeller, of which specific speed is 93. the distribution of the velocity and pressure in the blade - to - blade passage are presented at the design and off - design operating conditions. the simulation results were verifiable with the results measured by piv

    本文基於n ? s方程和標準的k ?雙方程紊流模型，採用商用cfx - tascflow計算軟體對一離心泵葉輪模型進行了葉輪內部三維紊流數值模擬，得到了三個典型工況下、從輪轂到前蓋板每一個斷面上的速度和壓力分佈。
分享友人
分享到 Line

分享到臉書