程數熱變換器 的英文怎麼說

中文拼音 [chéngshǔrèbiànhuànqì]
程數熱變換器 英文
number of passes
  • 程 : 名詞1 （規章; 法式） rule; regulation 2 （進度; 程序） order; procedure 3 （路途; 一段路） journe...
  • 數 : 數副詞（屢次） frequently; repeatedly
  • 換 : 動詞1. （給人東西同時從他那裡取得別的東西） exchange; barter; trade 2. （變換; 更換） change 3. （兌換） exchange; cash
  • 器 : 名詞1. （器具） implement; utensil; ware 2. （器官） organ 3. （度量; 才能） capacity; talent 4. （姓氏） a surname
  • 程數 : number of passes
  1. Performance for a piezoresistive transducer pressure sensor to thermal and pressure environments can be predicted by finite element method. a simplified 1 / 8 model, considering silicon dioxide and nitride process as well as stack anodic bonding and adhesive bonding processes, was developed. the fem results were found to be comparable to experimental data. case studies suggested that pyrex stack induces certain amount of non - linearity, while it isolates hard epoxy nonlinear effect. flexible epoxy bonding or soft adhesive bonding is preferred to the packaging process. the viscoelasticity and viscoplasticity of bonding material will result in hysteresis and drift errors to sensor output. however, soft adhesive s influence on sensor can be ignored under relative stable environments. more over, detailed design and process information will help to improve modeling application

    熱、壓環境下壓阻變換壓力傳感器的性能可以通過有限元方法預測.這里研究了簡化的1 / 8模型，模型考慮了二氧化硅和氮化硅生成過程及堆陽極鍵合和膠粘結合過程.結果發現有限元預測結果和實驗數據具有可比性.範例研究表明，硼硅堆導致產生一定的非線性，但它隔離了硬環氧樹脂的非線性.在包裝過程中最好使用柔性環氧黏合或軟黏膠性結合.黏合材料的黏彈性和黏塑性將會導致傳感器輸出的滯后和漂移誤差.然而，在相對穩定的環境下，軟黏合劑對傳感器的影響可以忽略.此外，詳細的設計和過程信息有助於提高模型的適用性
  2. According the characteristics of heat exchanger, the number of flow phases and the flow structure in the heat exchanger vary when heat transfer area, heat transfer coefficient or pressure change. subsection models was founded respectively, and that the simulation model has been set up through advanced continuous simulation language ( acsl ) correspondingly

    針對換熱器動態工作過程中各相區的換熱面積、換熱系數、壓力的變化會引起製冷劑相區數目和相區組合發生改變的特點，分別建立了各種組合結構的數學模型，並運用acsl實現了它們的模擬模型。
  3. The resistance furnace microcomputer automatic procedure temperaturecontrol system is rises, the temperature decrease speed and thesoaking time through the monolithic integrated circuit to the heatingfurnace carries on the strict control the installment, it changes thetemperature delivers, the demonstration and the numerical controlcollection to a body, take the microcomputer control as thefoundation, take the a / d switch as the core, and matches by thesuitable periphery connection electric circuit, realizes to theresistance furnace temperature automatic control

    電阻爐微機自動程序溫度控制系統就是通過單片機對加熱爐的升、降溫速率和保溫時間進行嚴格控制的裝置，它將溫度變送、顯示和數字控制集於一體，以微機控制為基礎，以a / d轉換器為核心，並配以適當的外圍介面電路，實現對電阻爐溫度自動控制。
  4. The first successful industrial application of absorption heat transformer ( aht ) has been put into practice in yanshan petrochemical corporation in china. on the background of this engineering, the thesis sets up the methods of absorber ' s enhanced heat and mass transfer, process simulation and finite time thermodynamics analysis. the main research work is followed as : 1

    本論文以北京燕山石化公司上的國內第一套吸收式熱變換器（ aht ）系統為工程背景和研究對象，建立了包括吸收器強化傳熱傳質、過程模擬和有限時間熱力學在內的分析手段，並在此基礎上開發出了模擬優化軟體ass ，最後利用工廠的實測數據對軟體的計算結果進行了測試和對比，具體工作： 1
  5. Examinations of steady status and analysis of dynamic experiments have been conducted on band - tube evaporator and parallel - flow condenser using r134a refrigerant. the steady examination show that the model error was under the allowable error, the inlet mass and enthalpy disturb experiments indicate that the subsection model, be good at reflecting the change of parameters of the heat exchanger, accord with the basic principle of thermodynamics theory and the actual work status. hence, the subsection simulation model research has important benefits both on theory and engineering application

    在進行模擬試驗時，以使用r134a作製冷劑的管帶式蒸發器和平行流式冷凝器為對象，完成了穩態模擬計算、試驗和動態模擬分析，穩態計算結果和試驗數據對比表明，其誤差在允許范圍內；進口質量和焓值的擾動試驗結果表明：本文所建的區段式換熱器模擬模型，能很好的反映換熱器性能參數的動態變化，與系統熱動力學理論和冷凝器、蒸發器的實際工作過程基本一致。
  6. The system can simulate the transfer process of photo - thermal and thermal - electric at a given parameter setting of structure, environment and circuit. on the basis of circuit structure, the calibration, parameter adjusting and signal readout can be simulated, the vary process of readout circuit, readout voltage, optical gain, optical gain rate, and uniformity can be given. in addition, all kinds of character parameters of device can be forecasted

    本論文根據umbirfpa的原理，建立它的軟體模擬系統，它可以根據給定的結構、環境、電路設置等參數首先模擬光熱、熱電轉換過程，並可根據電路結構，模擬校準、參數調節並讀出信號，給出讀出電流和電壓、光學增益、光學增益比、非均勻性等各特徵量的定量變化過程，預測製成后器件的各種性能參數。
  7. The system is described mathematically on the basis of mass balance, energy balance, and phase equilibrium. the model of process simulation of the aht system is set up. the solution system of mathematical model of absorption cycles was put forward

    對吸收式熱變換器（ aht ）的基本原理和行為特徵在系統層次上進行了分析，進而根據質量平衡、能量平衡和相平衡方程對系統進行數學表述，建立了系統的過程模擬模型，並提出了aht吸收循環數學模型的求解機制。
  8. Also discussed the methods on how to realize the cwt both in time - domain and frequency - domain and how to design the gm - c bandpass filter used in realization of cwt. in order to optimize the performance of gm - c filter, linearization techniques are investigated and proposed. due to process variation and parasitics, an automatic tuning is designed for center frequency / 0 and quality factor q also, in this thesis, 16 - channel analogue cmos cwt circuit has been realized

    論文圍繞連續小波變換的模擬電路實現這一熱點問題，討論了連續小波變換的時域和頻域實現方法；具體分析了并行結構與串列結構的優缺點；研究了頻域法中的跨導-電容帶通濾波器的設計；給出了改善跨導輸入級傳輸特性的線性程度並擴大線性范圍的具體方法；設計了片內自校正（可調諧）環節使濾波器參數自動調整到設計標準值；最後給出了16通道濾波器組實現小波變換的方法。
  9. They are agricultural productive materials price growth rate, sown area of grain crops growth rate, grain yield per area growth rate -, natural disaster covered grain areas growth rate, net grain import change rate, grain reserve change rate, population growth rate, per income growth rate, city and town population growth rate, food industry production value growth rate, year - end pig number growth rate, medical & pharmaceutical and textile industry production value growth rate, grain marketization degree, inflation rate using the previous year as base year ( preceding year = 100 ), public grain purchases price growth rate, investment in agricultural science and technology growth rate, investment in agricultural infrastructure growth rate, growth rate of graduates number from agriculture, forestry, science & technology universities and colleges and specialized secondary schools, government expenditure for agriculture and agricultural credit growth rate, international grain price growth rate, rmb exchange rate growth rate, last grain price growth rate, economic crop price growth rate, meanwhile, a new method is attempted to be used in this paper and the grain price early - warning problem is transformed into machine learning problem by introducing statistic learning theory and svm method which are gaining popularity in machine learning field at present in the world

    在此基礎上，篩選出23個警兆指標：農用生產資料價格增長率、糧食播種面積增長率、糧食單產增長率、糧食受災面積增長率、糧食凈進口量變化率、糧食儲備變動率、人口增長率、人均收入增長率、城鎮人口增長率、食品工業產值增長率、豬年末頭數增長率、醫藥紡織工業產值增長率、糧食市場化程度、以上年為基年的通貨膨脹率、國家糧食定購價格增長率、農業科技投入增長率、農業基礎設施投入增長率、農、林、科技高校大、中專畢業生人數增長率、財政支農資金比重及農業信貸增長率、國際糧食市場價格增長率、人民幣匯率增長率、上期糧食價格增長率、經濟作物價格增長率。同時論文在預警方法上作了新的嘗試，把糧食價格預警問題轉換成一個機器學習問題，引進當前國際上機器學習領域中比較熱門的統計學習理論和支持向量機方法，用順序回歸演算法對歷史數據進行學習建立了糧食價格預警模型。
分享友人
分享到 Line

分享到臉書