絕熱功率 的英文怎麼說
中文拼音 [juérègōnglǜ]
絕熱功率
英文
adiabatic horsepower-
It is designed according to electrical stove or microwave oven request. heating pipe adopts high temperature resistance mgo powder as the insulation medium and the stainless steel case is passed oxidation deal through the advanced web band protection oven 1050c in order to become the a special oxidation layer and improve the high temperature oxidation and bittern corrosive performance of the heating pipe. the heating tube has high power density and strong heat radion. this product with good safe performance can work normally after 3000hrs life test
加熱管選用耐高溫氧化鎂作絕緣介質,不銹鋼外殼經過先進的網帶氣體保護爐1050的氧化處理,形成一種特殊的氧化層,提高電熱管的抗高溫氧化及鹽鹵的腐蝕性能。電熱管的功率密度較高,熱輻射能力強。產品經長達3000h的壽命試驗后,仍能正常工作,安全性能好。Energy consume, electric strength, insulation resistance, ground conductivity, leakage current, microwave leakage, power input, normal temperature, humidity treatment, glow wire, horizontal flame, vertical flame, tracking, ball pressure, rainproof, water splash, dustproof, salt fog, endurance, motor load test, cord flexing, cord pulling, pull & torque test, lamp replacement, construction check etc
能耗、電氣強度、絕緣電阻、接地連續性、泄漏電流、微波泄漏、功率、溫升、濕熱試驗、灼熱絲、水平燃燒、垂直燃燒、漏電起痕、球壓試驗、防雨淋、防濺水、粉塵、鹽霧、耐久性(壽命)試驗、電機負載試驗、電源線彎折、電源線提拉、拉扭力測試、燈頭互換性、安全結構檢查等。It has low power and can defrost or heat in the refrigerator and expositing cabinet. both the ends of the heater adopt the imported resin glue and vulcanizate for seal ment and high ni - cr stainless steel as the case. it has good corrosive resisting performance and the insulation resistance is still more than 1000 after immersing in the water and being electrified for a long time
本加熱器的特點為表面功率較小,在冰箱,展示櫃中起加熱化霜作用。電熱管兩端採用進口樹脂膠及硫化橡膠封口,外殼採用高鎳鉻不銹鋼,具有很好的耐腐蝕性能產品經長時間浸入水中通電試驗,其絕緣電阻仍1000m 。Due to good chemical stability and electrical resistivity, high thermal conductivity and mechanical intensity, wide band gap and low thermal expansion coefficient, aln thin films can be applied for insulating chips for semiconductor devices with high power, thermal dissipation lagers for large and super - large scale integrated circuits, insulating layers or passivation layers for semiconductor
超薄鋁膜由於其特殊的的光學性質,在光學多層膜上有廣泛應用。氮化鋁薄膜化學穩定性高、熱傳導率高、機械強度高、電絕緣性能佳、高能隙、熱膨脹系數低,光學特性優良,可以用作大功率的紫外光學器件的散熱材料。The demonstration of heat - transfer measuring techniques and prospect of infrared thermal mapping techniques, main parts and performance indexes of a infrared camera, functional blocks and implementation of infrared processing software, experimental facility and measuring system of the wind tunnel has been made. the model emittance was experimentally determined and the three methods correcting directional emittance were compared. those problems of the infinite - slab model thickness and constant wall heat rates hypothesis, the determination of adiabatic wall temperature were discussed in a 1 - d heat conduction analysis
本文對紅外熱圖測熱技術與應用前景、紅外熱像儀主要部件與性能指標、紅外測熱數據處理軟體功能模塊與實現、風洞試驗設備與測量系統等進行了論述,測量了模型表面發射率並對發射率隨極角變化的三種修正方法進行了對比,對一維熱傳導分析中模型壁厚半無限假設、壁面熱流定常假設、絕熱壁溫選取等進行了探討。Rotating electrical machines - part 18 : functional evaluation of insulation systems - section 33 : test procedures for form - wound windings - multifactor functional evaluation - endurance under thermal and electrical stresses of insulation systems used in machines up to and including 50 mva and 15 kv
旋轉電機.第18部分:絕緣系統功能評定.模繞組的試驗步驟.功率小於等於50mva , 15kv絕緣系統的電氣應力和熱應力的強度Rotating electrical machines ; part 18 : functional evaluation of insulation systems ; section 31 : test procedures for form - wound windings ; thermal evaluation and classification of insulation systems used in machines up to and including 50 mva and 15 kv
旋轉電機.第18部分:絕緣體系的功能評定.第31節:模繞繞組線的試驗程序.機器最大功率為50mva ,電壓為15kv的絕緣系統的熱測定和分類Rotating electrical machines. part 18 : functional evaluation of insulation systems. section 31 : test procedures for form - wound windings. thermal evaluation and classification of insulation systems used in machines up to and including 50 mva and 15 kv
旋轉電機.第18部分:絕緣體系的功能評定.第31節:模繞繞組線的試驗程序.機器的最在功率為50mva電壓為15kv的絕緣系統用的熱測定和分類Rotating electrical machines - part 18 : functional evaluation of insulation systems - section 31 : test procedures for form - wound windings - thermal evaluation and classification of insulation systems used in machines up to and including 50 mva and 15 kv ; amendment 1
旋轉電機.第18部分:絕緣體系的功能評定.第31節:模繞繞組線的試驗程序.機器最大功率為50mva ,電壓為15kv的絕緣系統的熱測定和分類.修改件1Abstract : a previously proposed approximate quasi - static theoretical method is employed herein to examine the deformation and perforation of a simply - supported circular plate struck by a flat - faced projectile at normal incidence. based on the principle of virtual work, static load - displacement relationships are first obtained and then used to predict the energy - absorbing capacity of the plate subjected to relatively low speed impact. it is shown that good agreement is obtained between the theoretical predictions and the available experimental data, provided that adiabatic shear plugging failure does not occur, but the influence of strain rate sensitivity is taken into account
文摘:採用準靜態近似理論方法分析簡支圓板在平頭彈丸正撞下的變形和穿透.首先基於虛功原理得到了靜態荷載位移關系,並將其用於預測低速沖擊下圓板的能量吸收能力.當考慮了材料的應變率敏感性,並且不發生絕熱剪切沖塞破壞的前提下,理論預測和實驗結果吻合良好分享友人