線路偏置 的英文怎麼說

中文拼音 [xiànlùpiānzhì]
線路偏置 英文
line bias
  • 線 : 名詞1 （用絲、棉、金屬等製成的細長的東西） thread; string; wire 2 [數學] （一個點任意移動所構成的...
  • 路 : 1 （道路） road; way; path 2 （路程） journey; distance 3 （途徑; 門路） way; means 4 （條理） se...
  • 偏 : Ⅰ形容詞1 （不正; 歪斜） inclined to one side; slanting; leaning 2 （只側重一面） partial; prejudi...
  • 置 : 動詞1. （擱; 放） place; put; lay 2. （設立; 布置） set up; establish; arrange; fix up 3. （購置） buy; purchase
  • 線路 : 1. [電學] circuit; line 2. [交通運輸] line; route
  1. We can use the mm5 model in definite time, definite area weather forecasting. we conclude that : : the moving route of this necw in its developing progress was direct - south along latitude, the cold air is rough, and just this made the rough vertical velocity ; the necw southern moving and conflicting with the west pacification sub - tropical high makes rough jet steam. the plenty south - west warm and wet air made by the jet stream gave the rainstorm demanded vapor ;. the rough vertical velocity by jet stream is a main reason in this rainstorm ; the mm5 model uses four - direction analysis data as its input, this avoids some errors occurred in observe and transfer, thus made the result more useful

    綜合分析認為： （ 1 ） 、這次冷渦在其發生發展過程中，其移動路徑是沿經圈直線南壓，攜帶的冷空氣勢力較強，形成槽后較強的垂直運動； （ 2 ） 、西太平洋副熱帶高壓偏北位置與東北冷渦南壓形成的急流軸，把源源不斷的西南暖濕氣流輸送到遼西地區，也就是急流軸的左前方位置，為這次暴雨的產生提供了充足的水汽來源； （ 3 ） 、低空急流不但為暴雨輸送水汽，其造成的較強的垂直環流也是產生強降水的一個主要原因； （ 4 ） 、 mm5模式以四維同化資料作為初始場，最大限度地避免了觀測誤差可能造成的積分不穩定，提高了模擬結果的參考價值。
  2. Abstract : a new clock - driven eco placement algorithm is presented for standard - cell layout design based on the table - lookup delay model. it considers useful clock skew information in the placement stage. it also modifies the positions of cells locally to make better preparation for the clock routing. experimental results show that with little influence to other circuit performance, the algorithm can improve permissible skew range distribution evidently

    文摘:提出了一種新的時鐘性能驅動的增量式布局演算法，它針對目前工業界較為流行的標準單元布局，應用查找表模型來計算延遲.由於在布局階段較早地考慮到時鐘信息，可以通過調整單元位置，更有利於后續的有用偏差時鐘布線和偏差優化問題.來自於工業界的測試用例結果表明，該演算法可以有效地改善合理偏差范圍的分佈，而對電路的其它性能影響很小
  3. The bias magnetic field of the bias coil driven by bias current and small signal test current, results in the induced signal of the control coil. the terminal voltage of the control coil is detected by the test circuit. then the signal containing the information of rotor displacement is obtained, from which we can get the dc voltage signal proportional to the rotor displacement through half - wave rectification circuit and low pass circuit. this dc signal is put into a pid controller to get the control signal of the rotor displacement

    偏置測試電路向偏置線圈輸入偏置電流和小信號測試電流，兩者產生的偏置磁場在控制線圈產生感應信號，檢測電路檢測控制線圈端電壓並提取含有轉子位移信息的電壓信號，該信號經半波整流電路和低通濾波電路后得到與轉子位移成正比例的直流信號，再由pid控制器轉換為轉子位移的控制信號，最後控制信號輸入功放電路產生控制電流，實現閉環控制。
  4. On the one hand, the design uses low voltage cascode op framework to improve its gain ; on the other hand, it applies self - bias and cascode structure to the whole sensing circuit. by using the improved method, we have successfully obtained low power consumption, low offset, high linear and high psrr ptat current generator under low power supply

    在電路設計上一方面改進運放結構，採用低壓共源共柵結構以提高其增益，另一方面整體傳感電路採用自偏置結構和共源共柵電流鏡結構，在低電源電壓下成功設計了低功耗、低失調、高線性度和高電源電壓抑制比的ptat電流產生電路。
  5. It was also investigated and analysed on the styles of cross section in road green space, the rate of green space, the kind of green space, the quantity of plant spaces in green space, the format of planting. on the base of these, the planning designs of road green space in the blocks of heze city were also studied in combination with the practical situation which the city of heze were building to be a plain - plantation city with the flowers and water. the main results were as follows : 1. there were some problems about road green space in blocks of heze city, which were detected and researched. ( 1 ) the rate of road green space was low and the styles of cross sectionin road green space were simple

    本研究以菏澤城區道路綠地及街頭綠地為研究對象，對其綠地斷面形式、綠地率、綠地類型、綠地植物種類、數量、種植形式等現狀進行了全面的調查和分析，在此基礎上，結合菏澤近年創建以「花城水邑」為依託的平原森林城市建設的實際，對菏澤城區道路綠地規劃設計進行了研究，主要結果如下: 1 .菏澤城區道路綠地存在以下問題: （ 1 ）道路綠地率低，綠地斷面布置形式單一，中心島面積偏小; （ 2 ）植物種類少，景觀效果差; （ 3 ）植物配置形式單一，地方特徵不突出; （ 4 ）某些植物選擇不當，如遮陰功能差，影響交通安全等; （ 5 ）行道樹與架空線存在矛盾，影響樹木生長，景觀效果差; 2 .根據荷澤實際情況進行了城區道路綠地規劃設計研究: （ 1 ）提出了菏澤城區道路綠地規劃設計的依據、原則、總體布局、布局形式。
  6. According to the fact that power factor of low voltage power networks is very low in china and field bus technology is developing in the world, in order to enhance power factor of low voltage power networks, on the basis of central transmitting and controlling information among every compensation equipment, the author of this dissertation studies systematically the design principles of power factor dynamic compensation system. based on analyzing structure of control system at present, the author of the dissertation puts forward a distributed completely and multi - layer structure framework based on field bus technology and builds a power factor intelligent dynamic compensation system. the functions of compensation unit, intelligent node, host computer, are presented

    根據目前低壓電網用電負載功率因數偏低和國內外現場總線技術的應用現狀，立足於提高交流電機的功率因數，基於將每個補償裝置進行集中監控、信息集中傳遞的思路，本文作者在分析現有的控制系統體系結構的基礎上，提出了基於現場總線技術的全分散式多層控制系統的體系結構，構建了功率因素智能動態補償系統；對補償執行單元子系統、智能節點子系統、上位機子系統三部分進行了功能分析。
  7. A novel self - bias high - voltage device structure for the start - up circuit of an off - line switching model power supply ic is described

    摘要設計了一種新的用於離線式集成開關電源啟動電路的自偏置高壓器件結構。
  8. This paper describes a transistorized low consumption and fast recovery photomultiplier bases. the base developed for detector dissipates less power and recovers faster than its resistor - only ( or rc ) counterpart

    摘要介紹了由電晶體化的光電倍增管偏置電路的研究，該電路具有功耗低、穩定可靠、輸出脈沖上升時間快、能量分辨高、脈沖線性好、恢復時間快等優點。
  9. Greatly different from previous works, the matching circuits and dc bias networks are bent many times, for minimizing the lna

    與以往同類工作有很大不同，為了實現lna小型化的目的，對匹配電路和直流偏置網路採用多次曲折線的形式。
  10. Specifically analysed and presented the common - mode differential input stage, linear transconductance control circuit of input stage, current sum circuit, floating ab - class control output stage, the bias circuit of op amps and the bandgap reference current source circuit

    具體對運放的共模差分輸入級、輸入級線性跨導控制電路、電流和電路、浮動ab類輸出級電路、運放的偏置電路和帶隙參考電流源電路進行分析設計。
  11. A sensing magnetic field and displacement type of giant magneostrictive microdisplacement actuator with the functional of sensing driving magnetic field and microdisplacement is developed, and the design theories and approaches being applicable this type of microdisplacement actuator are pointed out : a circular diaphragm type of flexible construction that acts as integration mechanism of microdisplacement transferring and sensing of giant magnetostrictive microdisplacement actuator is adopted, sheet flexure theory of elasticity mechanics and approach of finite element are applied to design and calculate it, corresponding deflection and analytic formula and distribution curve of stress are given, and the specific achieving approaches of measuring principle and magnetic field sensing function of driving field in giant magnetostricitive rod are pointed out the magnetic field sensing function of the actuator is used to practically measure driving magnetic field of actuator and to obtain the relationship of driving magnetic field and coil current, which is also analyzed and studied

    其中，採用圓形膜片式柔性結構作為超磁致伸縮微位移執行器的微位移傳遞、感知一體化機構，應用彈性力學中的薄板彎曲理論、有限元方法對其進行了設計、計算，並給出了相應的撓度和應力解析式及分佈曲線；應用電磁理論給出了超磁致伸縮棒內驅動磁場的測量原理及磁場感知功能的具體實現方法，並利用執行器的磁場感知功能對其驅動磁場進行了實際測量，得出了驅動磁場與線圈電流之間的關系，並對其進行了分析和研究；對執行器內部的電磁路和偏置磁路結構進行了設計計算與實驗研究，為了減小驅動線圈的發熱，對其形狀進行了優化設計。
  12. Abstract : many rural systems are short of compensation devices of reactive power. it results in low quality of voltage and excessive loss in power lines. this paper proposes to install capacitors on power lines and theoretically analyzes the optimal scheme of compensation and obtained benefits

    文摘:針對許多農網缺乏無功補償裝置，造成電壓質量低劣、線損偏大的問題，提出了在線路上加裝電容器進行補償，並理論分析了補償的最佳方案及其取得的效益
  13. First, we analyse the power amplifier in theory in the circuit mode, biasing point linearity, thermal stability, input and output matching circuit

    論文首先從理論的方面對放大器的設計進行分析，對放大器的電路模型、偏置點、線性、熱穩定性、輸入輸出匹配進行理論上的分析。
分享友人
分享到 Line

分享到臉書