緩形變模量 的英文怎麼說
中文拼音 [huǎnxíngbiànmóliáng]
緩形變模量
英文
modulus at slower deformation-
The paper described the building process of model that can identify the shock - absorber parameter of landing gear and at the same times optimize performance of system. in this paper, there are also some debate, it include identifying parameter which can not be measured, such as the air polytropic exponent and the orifice discharge coefficient of shock - absorber
本文利用復合形優化演算法建立了起落架緩沖系統參數識別與系統優化模型，對緩沖器空氣壓縮多變指數和油孔流量系數等不可測參數的識別和著陸、滑跑載荷多目標優化問題進行了討論。When the isotropic waveguide is under the isotropic disturbances, the coupling term due to polarization, which is presented in the coupled - mode theory of the wei - ping huang, is n ' t included in this rigorous vectorial coupled - mode theory, exactly, the rigorous vectorial cmt does n ' t contain the coupling term due to polarization which is include in the scalar coupled - mode theory because this term is counteracted with the other coupling term neglected under weakly guiding approximation. as for anisotropic disturbances, we get the coupled - mode equations with arbitrary dielectric tensors. from them, we obtain the coupled - mode equations of the slowly varying term c ( z ) which is more simplicity
當受到各向同性微擾時，我們發現嚴格的矢量理論所得到的耦合系數表達式中並不包括wei - pinghuang的理論中的偏振耦合項，更確切的說，偏振耦合項正好與因弱導近似而忽略的項相抵消，這就是標量理論所得到結果（有偏振耦合項）與矢量理論在標量近似下的結果（不含偏振耦合項）不一致的原因所在；當各向異性微擾時，我們得到了包含微擾介電張量各個分量的橫電磁場耦合波方程，討論了微擾介電張量各個分量對耦合的影響，而且從橫電磁場耦合波方程出發得到了形式更加簡單的只含有橫電場系數的緩變分量c _ （ z ）的耦合波方程和耦合系數表達式，並以弱導近似下的單模光纖兩正交偏振模耦合為例對耦合系數在不同條件下的取捨做了定性的分析。In this part, the high - frequency series inverter with resonant pole capacitor is introduced mainly. the current - exchanging processes of the inverter in different working modes are analyzed, how to reduce the switching loss is discussed, and the calculating methods of snubber capacitor c, factor angle switching frequency and pulse width pw are given in optimum switching process. and results of simulation and experiment verify the validity of theoretic analysis
接著重點研究了含有諧振極無損緩沖電容的逆變器，對其換流過程中的不同工作狀態進行分析，討論了如何減小逆變器的開關損耗，給出了最佳工作狀態下緩沖電容c 、感性角、開關頻率、觸發脈沖的脈寬pw的詳細計算方法，並通過大量的模擬和實驗波形證明了理論分析的正確性。Firstly, by the method of laplace transform, one dimensional consolidation of one - layer gibson soils under time - depend loading is studied and the analytical solutions in frequency domain are obtained. on the basis of the solutions obtained and the computation through programming, the influence of some parameters and loading conditions on the consolidation behavior under trapezoidal, triangular and rectangular cyclic loading, is investigated. secondly, one - dimensional consolidation of one - layered gibson soils with semi - pervious boundaries is studied in this paper, and according to numerical examples, some characters of consolidation such as the effective stress and settlement in the soils under arbitrary loading are found
首先運用了laplase變換獲得了單層gibson地基（壓縮模量隨深度線性增加的地基）在任意荷載下頻域內的一維固結解析解，通過laplace逆變換，基於以上解答用數值方法編製程序對單層地基在常見荷載（驟加荷載、緩加荷載、矩形波載、三角形波載）作用下的一維固結性狀進行了討論，並與傳統的太沙基理論進行了比較。Abstract : a numerical model for wave propagation in water of varying topography and current is proposed, and time - dependent wave mild - slope equation with a dissipation term and corresponding equivalent governing equations are presented. two different expressions of parabolic approximations for the case of the absence of current are also given and analyzed. examples of numerical simulation for wave transformation in large estuarine water areas are provided
文摘:提出了水深與流場緩變水域波浪傳播數學模型水流中依賴時間變量並考慮能耗的波浪「緩坡方程」及其等價的控制方程組，分析比較了無水流情況此理論模型與其相應的兩種拋物型近似的差別，提供了長江口波浪變形數值模擬計算工程實例.實例表明，該模型能適應河口三角洲大范圍水域波浪傳播數值計算The simulation results show that the shaped degree is decreasing when the spinning temperature and intrinsic viscosity are increasing ; the spinning speed has little effect on the shaped degree when the pump mass throughput is constant ; the shaped degree is increasing with the increasing of pump mass throughput when the spinning speed is constant ; the cross air - blow conditions have much effect on the shaped degree ; the scope of shaped cegree is increasing when the aspect ratio of spinneret hole is increasing ; the shaped degree has obvious decreasing tendency in the small zone of spinning path and this decreasing became gently when the pump mass throughput is increasing
模擬的結果表明：扁平纖維的異形度隨著紡絲溫度及特性黏度的升高而降低；泵供量一定時，紡速對異形度的影響不大；紡絲速度一定，異形度隨著泵供量的增大而增大；吹風條件對異形度的影響較大；隨著噴絲孔的長寬比的增大，異形度增加的幅度也較大；異形度在紡程上較小的區間內有明顯的下降趨勢，並隨著泵供量的增加其下降的趨勢變緩。First of all, this article takes the cubic function elastomer in nonlinear system for examples, taking advantage of the method of state space and the dynamic simulation environment of matlab / simulink to convert the dynamics model into simulation model and choosing a suitable simulation arithmetic. at the meantime, the model parameter graphical can be prepared by use of the matlab ' s callback functions and will conveniently modify the parameters of system
首先，以三次函數型非線性緩沖包裝系統為例，從求解緩沖包裝系統動態響應的角度出發，採用matlab simulink模擬環境，利用狀態變量法將系統動力學模型轉化為模擬模型，選擇模擬演算法，利用matlab中的回調函數，編制緩沖包裝系統的參數圖形界面，可以方便修改系統的參數。分享友人