緩沖器的行程 的英文怎麼說

中文拼音 [huǎnchōngqìdehángchéng]
緩沖器的行程 英文
buffer stroke
  • 緩 : Ⅰ形容詞1 （遲; 慢） slow; unhurried 2 （緩和; 不緊張） not tense; relaxed Ⅱ動詞1 （延緩; 推遲） d...
  • 器 : 名詞1. （器具） implement; utensil; ware 2. （器官） organ 3. （度量; 才能） capacity; talent 4. （姓氏） a surname
  • 的 : 4次方是 The fourth power of 2 is direction
  • 行 : 行Ⅰ名詞1 （行列） line; row 2 （排行） seniority among brothers and sisters:你行幾? 我行三。where...
  • 程 : 名詞1 （規章; 法式） rule; regulation 2 （進度; 程序） order; procedure 3 （路途; 一段路） journe...
  • 行程 : 1 （路程） route or distance of travel; distance of run; length of travel; distance travelled; jo...
  1. First, it is compressible and cushiony ; second, it can be transported to a long distance with a little power loss ; the last, its flux and velocity of flow are quite high, so the reaction time of the operators can been considerably shortened. aiming to solve the problems of vibrating machinery such as short life - span, poor cushion and high energy consumption, the writer, on the basis of characteristic of pneumatic mentioned, contrives a set of valve controlled pneumatic vibrator, which has larger output vibrating force and longer life - span with simple structure. then, it is applied to drive a vibrating screen and the result is fairly well

    文中針對氣動技術本身的特性及優點，如：可壓縮，具有緩沖性；能耗損失小，便於遠距離輸送；流量大、流速高，執行元件響應速度快等，以解決振動機械在應用過程中的緩沖、能耗以及使用壽命等問題為目的，設計出一套輸出激振力大、結構簡單、使用可靠的閥控氣動激振器，並將其成功地運用到振動篩上，取得了較好的效果。
  2. Then a vsc controller using on - off valve and two potentiometers are designed for cushioning control system. it can realize the balanced, no shock, no reversing cushioning. experiments under different air pressure, load mass are carried out, and the results prove that the vsc controller can be used in pneumatic cushioning

    第五章首先介紹了變結構控制的原理和應用發展情況，然後針對本實驗系統設計了一個使用開關閥和端位位移傳感器的變結構控制方案，實現緩沖過程的平穩無沖擊和無回彈要求，並在不同氣源壓力、不同負載質量下分析了控制性能的變化，實驗結果證明緩沖控制採用變結構控制是可行的，並具有很強的魯棒性。
  3. The predigested calculating model about lunar soft - landing damping system is established in the course of landing shock. the dynamic computer simulation model is established according to the structure parameters

    建立了磁流變阻尼器緩沖系統沖擊時的簡化模型，利用本文建立的動力學方程和所用阻尼器結構參數構建了動態模擬模型，並進行了計算機模擬。
  4. A general stack equation of mobile robot based on analyzing the motion of planar motion object and the mathematical models of four different kinds of common wheels is developed, accordingly, the mobility of mobile robot is addressed and the forward and inverse solutions to speed for specific configuration driven by differential speed are derived. utilizing the muir and newman convention, the description of the posture transformation matrices between different coordinate frames and the solution for the speed of point located on these frames are introduced. according to posture estimation, a more accurate method, dead reckoning algorithm, is developed for a specified configuration characterized by differential speed motorization, and simulations of this algorithm and other traditional methods are carried out using matlab while traversing a circular path

    本文對兩輪差速驅動移動機器人的運動學及其本體緩沖設計進行了探討，在對平面運動物體運動分析的基礎上結合四種常用車輪的數學模型，推導出了一個通用的移動機器人堆積方程，在此基礎上分析了移動機器人的移動能力、並針對兩輪差速構型推導了速度正解與逆解；使用muir和newman的運動學建模方法，推導了移動機器人上點及連桿坐標系位姿、速度變換關系矩陣及求解方法；在移動機器人位姿識別方法中結合差速驅動構型對航位推演算法進行了分析：推導了一種理論精度較高的航位推算演算法，並使用matlab對其與傳統的推算演算法在跟蹤圓弧軌跡情況下進行了模擬；最後針對本文所研究的機器人給出了一種比較系統、可靠的緩沖結構設計思路，較好地解決了移動機器人作業過程中外界因素及本身設計中引入的各種不確定誤差問題；本論文研究成果已在本實驗室所開發的樣機上得到實現，經過應用與考核證明其中的分析與設計是切實可行的。
  5. To use an intermediate storage ( magnetic disc ) when making a data transfer between highspeed storage ( usually main storage ) and a device that operates at a lower speed

    當高速存儲器（通常是內存）和低速運行的（外部）設備之間進行數據傳送時，利用中間存儲器（磁盤）作緩沖（的技術或過程） 。
  6. In this part, the high - frequency series inverter with resonant pole capacitor is introduced mainly. the current - exchanging processes of the inverter in different working modes are analyzed, how to reduce the switching loss is discussed, and the calculating methods of snubber capacitor c, factor angle switching frequency and pulse width pw are given in optimum switching process. and results of simulation and experiment verify the validity of theoretic analysis

    接著重點研究了含有諧振極無損緩沖電容的逆變器，對其換流過程中的不同工作狀態進行分析，討論了如何減小逆變器的開關損耗，給出了最佳工作狀態下緩沖電容c 、感性角、開關頻率、觸發脈沖的脈寬pw的詳細計算方法，並通過大量的模擬和實驗波形證明了理論分析的正確性。
  7. The principle of operation, the selection of snubber circuit, the design of the coupling inductor and the relationship between the dc / dc and dc / ac converters are illustrated and verified on a 1kw experimental circuit. a two - stage dc / dc converter consists of a boost and ppfc is presented in this paper through further research

    文章詳細分析了電路工作過程，給出了緩沖電路的選取原則及耦合電感的設計，討論了該ppfc與后級dc / ac逆變器連接工作時的相互影響，並通過模擬分析和一臺1000w實驗樣機進行了原理驗證。
  8. Such rounded and systematic research has been done in this thesis. it is significant in theory and engineering for the design, performance improvements and reliability of both the shock absorbers and the pneumatic product line

    本文對氣動緩沖器和氣缸用液壓緩沖器的結構原理和特性進行全面、系統的理論分析和實驗研究，對緩沖器的設計、性能改進和提高氣動生產線的性能及可靠性有著重要的理論和工程實際意義。
  9. Abstract : the design of a reverse recoil mechanism of naval gun, i. e the groove hydraulic buffer, was discussed. the hydraulic resistance formula was derived and the method for paremeter selection was put forward. the recoil distance is about 28 % shorter than the original one

    文摘:討論了艦炮的一種反后坐裝置，即溝槽式液壓緩沖器的設計問題，通過推導液壓阻力公式，給出了縮短緩沖引程的有關參數選擇及設計方法，使后坐行程比原來一段式縮短28 %左右
  10. To closely investigate the uncertain nonlinear factors in the cushion process and simplify their influence for the sake of the mathematic modeling, an experimental rig is designed and constructed, for which the mechanical, hardwired and software tasks have been done. 5

    為了研究氣動緩沖和液壓緩沖器緩沖過程中不確定的非線性因素，在可接受的范圍內進行簡化以方便建立相關的數學模型，設計、搭建了氣動緩沖和液壓緩沖器建模用實驗臺，完成了機械、電路、軟體等多方面的任務； 5
  11. The resource management also implements part of the jca1. 0 standard. thus, any eis system keeping to this standard can be easily added into istx1. 0. in addition, the resource management module combines with that of transaction processing, fulfilling the functions of resource enlist and delist in transaction managers

    Istx1 . 0中的資源管理模塊對系統中使用的所有數據庫進行了統一的連接緩沖和復用管理，有效提高了應用程序和istx1 . 0的性能；另外它對jca1 . 0規范進行了支持，任何遵循jca規范的eis系統都能方便地加入到istx1 . 0中；最後它和事務管理模塊結合在一起，共同實現了資源在事務管理器中的注冊和注銷功能。
  12. The results of the computer simulation show that lunar soft - landing damping system based on mrf dampers is effective and practical as well

    模擬結果表明，磁流變阻尼器應用於月球軟著陸緩沖過程中是可行的。
  13. We then consider the n policy m / g / 1 queueing model with two priorities. by using the supplementary variable method to analyze the state probability equations, we derive the generating function of queueing length distribution and the mean queue length in the buffer of the communications network. and through further discussing for the queue with various priorities, we derive the generating function of queueing length distribution and the stationary queueing length in queue models with various priorities

    其次研究帶有兩個優先權的n策略m g 1排隊模型，利用補充變量法對狀態概率方程組進行分析，得出了此排隊系統隊長分佈母函數及通信網緩沖器中的平均隊長，並對不同優先權隊列的進一步討論，得出了不同優先權隊列的隊長分佈母函數及穩態隊長。
  14. This parameter is used by the sql optimizer to help estimate how much buffer pool will be available at run - time for the access plan chosen since the buffer pool is shared by all active applications connected to the database

    Sql優化器使用該參數來幫助評估在運行時有多少緩沖池可用於所選擇的訪問計劃中（因為連接到數據庫的所有活動應用程序共享緩沖池） 。
  15. In a dpcx program, a type of form used to address data sent to the output full screen processing buffer

    在分散式處理控制執行程序（ dpcx ）中，一種用於對送到輸出全屏幕處理緩沖器的數據進行尋址的形式。
  16. Therefore, the dynamic loads should be considered and limited in designing landing gear. the traditional landing gear is a passive system and the parameters changes may produce an unsatisfactory performance

    傳統的起落架緩沖器是一種被動控制系統，其參數一經選定，在飛機起降過程中就無法進行改變，因而緩沖效果不理想。
  17. In order to deal with those problems above, a video surveillance scheme based on dsps was presented, which used high performance dsps to replace pc as central control unit. not only did we realize the hardware circuits of the system, but also we developed it ' s software. furthermore, three essential methods, for instance the data transfer method by extend direct memory access ( edma ), buffer management method by three buffer strategy and optimized data acquire method had been discussed

    為了彌補這些不足，論文採用高性能的dsps取代傳統的pc作為核心處理器，設計了一種基於dsps的交通視頻監控系統的圖像處理平臺，詳細的對其硬體實現和軟體調試進行了論述；在這個基礎上分析了視頻圖像採集和處理的流程，討論了一種利用edma的實時后臺傳輸數字視頻方法和三幀緩沖的存儲器管理方法，為系統的實時性提供了保障。
分享友人
分享到 Line

分享到臉書