纖維脫落 的英文怎麼說

中文拼音 [xiānwéituō]
纖維脫落 英文
fibre shedding
  • : 纖形容詞(細小) fine; minute
  • : Ⅰ動詞1 (連接) tie up; hold together; link 2 (保持; 保全) maintain; safeguard; preserve; keep ...
  • : Ⅰ動詞1 (脫落) cast; shed; drop; fall off 2 (取下; 除去) take off; strip; cast off 3 (脫離) ...
  • : 落名詞[方言] (北方對蓮花落的俗稱) a kind of folk song
  • 纖維 : fibre; staple; filamentary
  • 脫落 : 1 (掉下) drop; fall off; come off; shed; let go 2 [植物學] exfliation; abscission; abjection; e...
  1. Results the major morphologic changes were as follows : histologically, alveolar inflammation and interstitial fibrosis were observed. electron microscopic findings were : 1. alveolar type i cells were degenerated 、 broken - down and desquamated, endothelial cells were swelled, with inter cellular tight junction shortened, alveolar type ii cells hyperplastic, basement membrane thinned and deformed ; 2. alveolar macrophages and interstitial macrophages were hyperplastic ; 3. mast cells were infiltrated and degranulated ; 4. electron - dense deposits were present at alveolar wall ; 5. myofibroblasts 、 fibroblasts 、 collagen and basement membrane like material were hyperplastic

    電鏡觀察可見: ( 1 ) i型肺泡上皮細胞變性、崩解和,內皮細胞腫脹,細胞間緊密連接短小, ii型肺泡上皮細胞增生,基底膜變薄和破壞; ( 2 )肺泡巨噬細胞、間質巨噬細胞增多; ( 3 )肥大細胞浸潤並見顆粒現象; ( 4 )肺泡壁電子緻密物沉積; ( 5 )肌母細胞、母細胞、膠原原及基底膜樣物質增生。
  2. This paper discusses how to improve expand section ' s lining of heavy - calibre and high - tempreture, the steel - fibre lining is improved to be the lining of firebrick and fireproof material, to avoide the lining drop and meet the needs of production

    摘要闡述了如何將大口徑高溫膨脹節襯里由鋼雙層襯里改為耐火磚加耐火澆注料結構,避免了襯里,滿足了生產需要。
  3. Shock absorber d + max b109, 26. for high intensity sports. made from coolmax, which draws moisture away from the body. the cushioned shoulder straps stay in place well

    這是一款專為進行激烈運動設計的胸罩,售價26英鎊。吸濕排汗質地能讓你在運動過程中保持胸部乾爽,肩帶處的加墊設計能防止肩帶
  4. This paper discusses how to improve large taper lining, the steel - fibre liningis improved to be tortoise - shell net structure, to avoid the lining drop and remove a hidden danger

    摘要闡述了將沉降器大型錐體襯里由鋼單層襯里改造為龜甲網加耐火澆注料結構,避免了襯里,消除了安全生產隱患。
  5. Ge polyester wiper is made of 100 % continuous filament in interlock and double - knit pattern, to prevent the release of fibers and particles, four deges of the wiper are sealed by special technology

    Ge系列聚脂抹布,是用100 %完全連續的聚脂互鎖雙織而成,抹布的四邊採用了科學的封邊技術,最大限度地防止纖維脫落和微塵的產生。
  6. It can be concluded that the performance differences between the plate membrane and the hollow fiber membrane can be attribute to difference of the stresses in the membranes when they were under pressure and the difference of the strain caused in the membrane, besides the possible reason that the surface curvature difference between a plate substrate and a hollow fiber one may cause structure difference in the dense functional layer when coating. the stresses in a hollow fiber composite membrane under an outside pressure are quite different from that in a plate one in that they exert on the hollow fiber in both the radial and circular directions, and the compress strain of the hollow fiber is thus much more complex, which may cause the top layer crinkle and a decreased salt rejection

    分析認為造成平板復合膜( )和中空復合膜( )性能差異的主要原因,除了平板基膜與中空基膜因表面曲率不同可能引起在塗覆時形成的緻密功能層結構上的差異之外,由於中空膜受外壓時,膜內部承受的應力形式與平板膜不同,會同時在徑向(膜厚度方向)和環向(膜面內方向)兩個方向產生壓應力,因此,所發生的形變也較為復雜,可能造成表面復合層的起皺或,引起鹽率下降。
  7. Analysis for a broken and debonging fiber in ductile matrix composites

    金屬基復合材料斷裂後的應力分析
分享友人