置初值驗證 的英文怎麼說
中文拼音 [zhìchūzhíyànzhèng]
置初值驗證
英文
initialization verification- 置 : 動詞1. （擱; 放） place; put; lay 2. （設立; 布置） set up; establish; arrange; fix up 3. （購置） buy; purchase
- 初 : Ⅰ名詞1 （開始的部分） at the beginning of; in the early part of 2 （姓氏） a surname Ⅱ助詞（附著...
- 驗 : 動詞1. （察看; 查考） examine; check; test 2. （產生預期的效果） prove effective; produce the expected result
- 證 : Ⅰ動詞（證明） prove; verify; demonstrate Ⅱ名詞1 （證據） evidence; proof; testimony; witness 2 （...
- 驗證 : test and verify; checking; proving; testing; confirmation; [數學] corroboration; inspection; veri...
-
Also a test system is set up, and the work status of the system is controlled by single chip to download the data of initial registers and control registesr. and the logical analyzer is used to sampling the output signals
搭建了一個驗證系統，通過單片機來配置初始化寄存器和控制寄存器的值來控制系統的工作狀態，用邏輯分析儀採集輸出的信號。In order to reduce the adverse influence of nlos error to location performance, this algorithm firstly makes initial mobile position estimation by mean tdoa / toa measurements, then estimates nlos error within tdoa / toa measurements by parameters of tip 1 channel model, smoothes and reconstructs tdoa / toa measurements, and finally utilizes two step wls computation. the application of this algorithm under different cellular environments is also discussed and its effectiveness is demonstrated by simulation results. finally, the basic location method, location method implementation, network architecture, signaling protocol and interface, and location procedures of wcdma network mobile location are analyzed
百臼主回大學槽士扭允生攀幢伍丈第v頁接著，通過對tdo咖a測量值誤差的分析，本文提出了一種首先利用tdo咖a平均測量值對移動臺位置進行初始估計，並利用tipi通道模型參數估計出thoafl 』 oa測量值中nlos誤差的大小，然後對tdo … a測量值進行平滑與重構，再採用兩次wls計算，以降低nlos誤差對定位性能不利影響的的定位精度提高演算法，討論了這種演算法在蜂窩網路不同環境條件下的具體實施方法，通過詳細模擬驗證了這種演算法的有效性。
分享友人