耦合輸出 的英文怎麼說

中文拼音 [ǒugěshūchū]
耦合輸出 英文
coupling-out
  • 耦 : Ⅰ動詞[書面語] （兩人並耕） plough side by sideⅡ名詞1 （古農具名） plough2 [書面語] （兩人一組） a...
  • 合 : 合量詞（容量單位） ge, a unit of dry measure for grain （=1 decilitre）
  • 輸 : Ⅰ動詞1 （運輸; 運送） transport; convey 2 [書面語] （捐獻） contribute money; donate 3 （失敗） l...
  • 耦合 : [物理學] coupling; interconnection; catena; linkage; linking
  • 輸出 : 1 （從內部送到外部） export 2 [電學] output; outcome; outlet; out fan; fanout; 輸出變壓器 output ...
  1. Then after analysising each characteristics of phosphate glass material, the fiber rod - in - tube by invaginating core rod, inside cladding and outside cladding is used to fabricate the er / yb phosphate glass fiber successfully by polishing and vacuumizing fiber rod - in - tube. finally some techniques, such as cladding pump, prism coupling pump and fusing pump are used to measure the gain of fiber amplifiers

    最後對拉制出的光纖提出了包層泵浦、棱鏡耦合泵浦和熔接耦合泵浦三種可行的增益和傳輸特性測試測方案，並針對鉺鐿共摻磷酸鹽玻璃光纖的特性，指出了熔接耦合是測試增益和傳輸特性的最佳方案。
  2. Blank detail specification : ambient rated photocouplers with phototransistor output ; german version en 120004 : 1992

    空白詳細規范.與光電晶體管輸出匹配的環境級光電耦合
  3. Specification for harmonized system of quality assessment for electronic components - blank detail specification - ambient rated photocouplers with phototransistor output

    電子元器件質量評定協調體系規范.空白詳細規范.規定環境下有光電晶體管輸出的光電耦合器
  4. Semiconductor devices. harmonized system of quality assessment for electronic components. ambient rated photocouplers with phototransistor output. blank detail specification

    半導體器件.電子器件質量評估協調體系.帶光電晶體管輸出的特定環境溫度光電耦合器.空白詳細規范
  5. Based on an amplified spontaneous emission ( ase ) source, a ring - cavity fiber laser, in which sensor element acted as the reflector of the cavity, was achieved with high - signal noise ratio ( snr ) and high - power. it was demonstrated that the output power was maximum, when output coupler ratio of the coupler was seventy percent

    實驗證實耦合器的輸出耦合比選為某一個最佳值70 ，當980nm泵光工作電流為50ma時，其輸出功率達3 . 5mw ，且輸出激光波長與作為反射鏡的光纖光柵中心波長相同。
  6. The paper discusses dynamical conditions of the supercritical ore - forming fluid system based on study of regional geological background and analyses of physiochemical conditions of ore - forming process and puts forth the ore - forming mechanism : upper mantle uplift - mingling of meteoric water and magmatic hydrothermal fluid separated from acidic magma under tensile or transitional tensile environment - water / rock reaction - transportation - chemical coupling ore precipitation

    在分析超臨界成礦流體系統形成的區域地質背景和研究成礦物理化學條件的基礎上，探討了超臨界成礦流體系統形成的動力學條件，提出該系統的成礦機理：與燕山晚期酸性火山侵入巖漿有關的金銅礦床是在上地慢隆起、張性或向張性過渡背景下形成的，酸性巖漿經熔體流體分離作用形成的巖漿熱液與大氣降水混合，經水巖作用等復雜的輸運和化學反應耦合過程的動力學產物。
  7. The circuit is used in high resolution resistance measuring. the coupled chaotic circuit array composed of this circuit is researched by computer simulation and circuit experiment. results show that, it is feasible to improve the stability of orders of chaotic systems and reduce noise in measuring by coupling

    最後，對以這種單電源驅動的混沌電路為基本單元所構成的耦合混沌陣列在提高系統輸出的穩定性和抑制噪聲作用方面，進行了計算機模擬研究和實際的電路實驗研究，結果顯示通過耦合的方式，可以將信號檢測的精度提高近一個數量級。
  8. The general nonlinear propagation equations of four - lightwaves in birefringent fibers are deduced. the characteristics of polarization mode dispersion in 4 + 10gb / sdwdm system in dispersion - flattened fibers is studied. our results show that pmd exerts a detrimental influence on 4 x logb / sdwdm system in limiting transmission rate and the channel numbers

    本論文研究波分復用（ wdm ）系統中偏振模色散的影響，主要工作包括下面兩個部分：一、導出了四波長光波在雙折射光纖中傳輸所滿足的一般非線性耦合方程；在此基礎上，研究色散平坦光纖中4 10gb sdwdm系統的偏振模色散特性，並且進一步研究了偏振模色散對不同通道間隔的4 10gb sdwdm系統的影響。
  9. However, due to the elastic deflection and vibration of the links, the flexible manipulator becomes an infinite dimension mimo system with distributed parameters, and is highly nonlinear and strong coupling. therefore, the model and the control of flexible manipulator are of great significance both in theory and in application

    然而也正是由於連桿存在彈性變形和振動，使得柔性機械手成為一個高度非線性的、分佈參數的、強耦合的無窮維多輸入多輸出系統， ，因此其建模和控制也具有重要的理論意義和應用前景。
  10. Working on laser diode fiber - coupling modules was summed up, they are, setting up the model of far - field distribution of laser array and the far - field characteristics of difference structures ; designing the temperature - controlled laser diode fiber modules, that has been used as a laser system with temperature - controlled and fiber - output ; realization with high - brightness laser diode fiber - coupling modules ; the fiber ' s application in the field of high power laser

    總結了自己在光纖耦合輸出激光二極體模塊方面所做的一些工作，建立了半導體激光器列陣遠場光束分佈模型，並結合具體參數分析了不同結構的激光器列陣的光束遠場分佈特性，可以知道我們設計和優化激光器列陣的結構。設計並製作了光纖耦合模塊的溫度控制系統，並製作成溫控光纖輸出激光器半導體系統投入使用。
  11. High - power fiber laser produces coherent output

    高功率光纖激光器實現相干耦合輸出
  12. Based on the analysis of gas - solid multiphase catalytic reaction, the chemical reaction model is established. when the reaction is controlled by the chemical dynamic, the reaction rate is introduced by consideration of the adsorption and desorption effects. when the reaction is controlled by mass transfer, the diffusion coefficient is established which can present the flow rate increases in small reynolds domain ; for the internal diffusion, the internal diffusion coefficient is derived, and then the internal diffusion is coupled with chemical reaction to represent the phenomenon that the diffusion and the chemical reaction occur cocurrently

    本文在考慮催化轉化器載體內發生的傳熱傳質現象的基礎上，建立了催化轉化器的一維單孔道和三維多孔道傳熱傳質模型;在分析載體內以氣-固多相催化反應為特點的工作機理的基礎上，建立了催化轉化器的化學反應模型:當催化轉化處于化學動力學控制區時，引入了考慮吸附、表面反應和脫附的表面化學反應速率公式，當催化轉化處于質量輸運控制區時，引入了決定外擴散能力的擴散系數公式和和決定內擴散速率的內擴散系數公式，並與化學反應速率相耦合，得出由擴散過程決定的化學反應速率公式。
  13. High power diode laser array coupling with optical fiber not only make the use of diode laser easier, but also improve the dissymmetry of its output light beam and in the meantime, the output light coupling between the ld sources becomes easier and the power becomes higher

    大功率半導體激光器採用光纖耦合輸出方式不僅簡化了器件的應用，改善了輸出光束的非對稱性，同時還可以簡便地實現多個半導體激光器的光源之間的輸出光耦合或組合，得到更高的功率輸出。
  14. In this paper, the polarization in the fiber - optic depolarized gyros has been analyzed. several aspects are under discussion, such as the polarization evolution in the depolarizer and the single - mode fiber sensing coil, the depolarization in the polarization - maintain fiber, the birefringence and coupling in the single - mode fiber, the nonreciprocal phase error and the output intensity. firstly, the depolarization effect of the lyot depolarizer to the polarized light and the partially polarized light has been analyzed

    本文對消偏光纖陀螺中的偏振特性進行了分析，包括單模光纖環和消偏器中的偏振態演變、保偏光纖的消偏性能、單模光纖環的雙折射和耦合、輸出光強和非互易性相位誤差與偏振態的關系。
  15. Besides, each factor of parameter m influencing coupling - out amplitude of sensor has been summarized

    同時，總結了影響傳感器耦合輸出幅度的參數m的各個因素。
  16. In the fourth chapter, the coupling system between the fiber - coupled - output high power semiconductor laser acting as the pumping source and laser crystal is studied

    第四章研究了作為泵浦源的光纖耦合輸出大功率半導體激光器與激光晶體間的耦合系統。
  17. A diode pumped cr4 +, nd3 + : yag crystal self - q - switched laser is demonstrated with fiber coupled ld and the imaging system. the pulse laser with 1064 nm wavelength is obtained. the maximum average output power is 3. 36 w, and the pulse duration is 65 ns, and the repetition rate is 87 khz, the opto - optical efficiency is 15. 3 %, the slope efficiency is 23. 8 %

    用光纖耦合輸出的ld ，通過成像系統會聚，對二極體泵浦的自調q激光器進行了實驗研究，得到了平均功率3 . 36w ，脈沖寬度65ns ，重復頻率87khz的1064nm脈沖激光。
  18. Based on this arithmetic, the high frequency characteristics of five - cavity with open boundary is calculated by the code written in fortran language. then the transit effect of five modes of five - cavity with open boundary is also calculated using code mathcad and matlab. the results show that the working mode of five - cavity transit tube oscillator is 3 / 6 mode, and the analysis of the theory are in good agreement with the simulation results

    根據從基於四腔渡越時間效應的自調制出發，經過一段飄移，然後再採用雙間隙提取腔邊耦合輸出高功率微波的思路，採用粒子模擬方法優化設計出一種峰值功率為1 . 5gw ，頻率為9 . 3ghz的六腔渡越輻射振蕩器，並研究了它的一系列工作特性。
  19. With the cavity of output from zero - order diffractive beam, tunable range of about 70nm from 543 - 610nm had been achieved, and the highest slope efficiency of 17 % was obtained at 583nm wavelength. while using the cavity of output from a coupling mirror, tunable range of over 30nm from 553 - 585nm was obtained, and the

    在腔鏡耦合輸出的可調諧激光器實驗中，輸出調諧范圍超過30nm ，此結果與報道的p567固態染料調諧范圍相近；在光柵零級輸出實驗中，激光輸出調諧范圍近70nm ，此結果在已知報道的p567固態染料激光調諧范圍中是最寬的。
  20. First. adjust the fiber to get the interferogram, use the four - step phase shifting method control the change of phase, achieve phase shifting. in data processing, take the pzt ' linear influence into account, calibrae the pzt. unwrapping the phase, gain the continuity, get the actual phase. analyzing the data with zernike orthogonal methord, fit polynomials that are not orthogonal over the data points, through visual c + + program, obtain polynomial parameters. calculate the shape of the surface, compare the result with zygo, then achieve the better experimental result

    首先，經光纖耦合輸出調整得到干涉圖，採用四步相移方法，控制干涉圖位相變化，實現相移；數據處理過程中，考慮壓電陶瓷的非線性影響，進行標定；對位相進行模式展開連續性處理，得到實際位相；用zernike多項式正交化方法分析，在離散點上處理數據，經visualc + +程序設計，得到多項式系數，計算出面形分佈，同zygo所得結果進行比較。
分享友人
分享到 Line

分享到臉書