聚合度 的英文怎麼說

中文拼音 [jùgědù]
聚合度 英文
d= degree of polymerization
  • 聚 : 動詞（聚集; 聚積） assemble; gather; get together
  • 合 : 合量詞（容量單位） ge, a unit of dry measure for grain （=1 decilitre）
  • 度 : 度動詞[書面語] （推測; 估計） surmise; estimate
  • 聚合 : 1 （聚集到一起） get together2 [化學] （單體結合成高分子化合物） polymerization; polymerize 3 [生...
  1. The agglomeration of the particles has been found not to be a function of mix time.

    人們發現顆粒聚集度不是混合時間的函數。
  2. Study on gelation character of pvc with high degree of polymerization

    高聚合度聚氯乙烯凝膠特性的研究
  3. Testing method of degree of polymerization of ramie cellulose

    苎麻纖維素聚合度測定方法
  4. Different maltodextrins are distinguished by two indexes which are dextrose equivalent and degree of polymerisation

    不同麥芽糊精產品一般以葡萄糖當量和葡萄糖聚合度這兩個指標區分產品級別。
  5. The relations of the different characteristics of maltodextrin with dextrose equivalent and degree of polymerisation are also reviewed

    文章主要綜述葡萄糖當量和葡萄糖聚合度這兩個指標與麥芽糊精各性質的聯系。
  6. The results show here, ( 1 ) the best reaction condition determined by the change of film properties in life time with uv light irradiation are : the hydrolyzation temperature is 60, the reaction time is 60 minutes, the less amount of water is of benefit to increase the hydrophobic property, the film formed with high degree polymer is steady

    研究結果如下： （ 1 ）通過調節反應參數，可制得性能優異的疏水性硅酮樹脂塗覆材料。最佳反應條件為：水解溫度60 、反應時間60min ；水解用水量較少和聚合度較大時樹脂塗層的性能較好。
  7. Weight - average degree of polymerization

    重量平均聚合度
  8. Determination for average polymerization degree of polyvinyl alcohol resins

    聚乙烯醇樹脂平均聚合度測定方法
  9. Average degree of polymerization

    平均聚合度
  10. Mean degree of polymerization

    平均聚合度
  11. Measurement of the average viscometric degree of polymerization of new and aged cellulosic electrically insulating materials

    新的和老化的電工絕緣紙平均粘滯聚合度的測量
  12. White powdered homopolymer resin produced through suspension polymerization ( medium degree of polymerization )

    以懸浮聚合方式製造的單聚合物樹脂，是白色粉狀的中聚合度產品，消光效果優良。
  13. The length of the polymer chain is specified by the number of repeat units in the chain. this is called the degree of polymerization

    聚合物鏈的長度可以用鏈中重復單元數來表示，叫做聚合度。
  14. ( 5 ) the article also investigate the recrystallization condition of crude lactide and point out that it also an important factor have influence on the purification production ratio. ( 6 ) give the kinetics equation of depolymerization reaction. by determination the degree of polymerization ( dp ) of the reaction system, we can get the kinetics data of the reaction

    本文建議使用乙酸乙酯和異丙醇混合溶劑（ 6 ： 4 ）對丙交酯粗產物進行重結晶； （ 6 ）提出解聚反應的動力學方程，認為它是一個可近似處理為一級反應的連續反應，並可通過測定體系的平均聚合度的方法來得到包括活化能在內的反應動力學數據。
  15. When the dosage was 8 % aa, the effect was best. ( 2 ) the performance of pc was decided with the proportion of pea, aa, mma. the fluidity of copolymer would augment if the dosage of aa increase, but when dosage of aa was 75 %, it was hard to control the compose reaction, and dispersion of pc would depress ; when pea degree of polymerization augment the air - entraining of mma would increase ; it would produce floe and hard to control the compose reaction when the dosage of pea4 more than 15 %, pea23 more than 25 %

    （ 2 ） pea 、 aa 、 mma之間的比例關系決定了共聚體的性能：隨著丙烯酸用量的增加，共聚體的流動度增大，達到75時合成控制難度加大，共聚體分散性下降；而mma的引氣增穩作用，其用量隨著pea的聚合度的增加而增加， pea4體系的用量超過15 ， pea23體系超過25則會產生絮狀物，反應控制難度加大，理想的用量分別為不超過10和15 。
  16. Textiles. cellulose. determination of limiting viscosity number and determination of the average viscosimetric degree of polymerization

    紡織.纖維素.特性粘度的測定和平均粘度測定法聚合度的測定
  17. The gpc results indicated that the polymerization degree increased with the extension of reaction tine and the molecular weight distribution was tend to be monodispersity

    Gpc研究結果表明隨反應時間延長，聚合度增大，聚合物分子量趨于增大但分散性減小。
  18. Measurement of the average viscometric degree of polymerization of new and aged cellulosic electrically insulating materials iec 60450 : 2004 ; german version en 60450 : 2004

    新的和老化的纖維素電氣絕緣材料的粘均聚合度測量
  19. Based on the polymerization reaction mechanism of pet, the model includes all main reactions and major side reactions with measured operational variables as its input and polymerization degree ( dp ), average molecular weight and parameters of molecular weight distribution as its output

    模型從聚合反應機理出發，考慮了所有的主反應和主要的副反應，以實測的工藝操作參數為輸入，以各反應釜、特別是終端產品的聚合度、平均相對分子質量及相對分子質量分佈參數為輸出。
  20. Not only the dp, but also the type and the original source of cellulose pulp, affect the permeation properties of the membranes but has almost no effect on the rejection of bovine serum albumin ( bsa ) solution

    漿粕種類對纖維素膜的水通量影響較大，但對截留率（小牛血清蛋白溶液）影響不大。漿粕的聚合度、來源、組成對膜性能都有很大影響。
分享友人
分享到 Line

分享到臉書