脈動率 的英文怎麼說

中文拼音 [màidònglǜ]
脈動率 英文
percentage ripple
  • 脈 : 脈名詞1. （動脈和靜脈的統稱） arteries and veins2. （脈搏的簡稱） pulse 3. （像血管的組織; 連貫成系統的東西） vein
  • 率 : 率名詞（比值） rate; ratio; proportion
  • 脈動 : [物理學] [天文學] pulsation; pulsing; pulse; ripple; impulsive motion; pulsating; panting; loping...
  1. The thermal damping is maximum for frequencies corresponding to pulsations that are somewhere between isothermal and adiabatic.

    當脈動處于等溫和絕熱之間某個狀態時，相應頻率下的熱阻尼是最大的。
  2. If the coefficient of engagement overlap decreases, the flow aggrandize, trapping volume and the flow pulsating ratio decreases

    隨著齒輪嚙合重合系數的減小，齒輪泵的流量增大，困油容積和流量脈動率減小。
  3. Conclusion the hypertensive and hyperoximic arterial blood could damage the venous endothelial cells after the vein was arterialized if the flap was transplanted after the damaged endothelial cells recovered, the survival rate and the quality of the flap could be increased remarkably

    結論靜脈動脈化后高壓、高氧動脈血流可損傷靜脈內皮細胞，如先將靜脈原位動脈化，待損傷的靜脈內皮細胞修復並適應動脈血流后再行皮瓣移轉，可明顯提高皮瓣成活率及成活質量。
  4. This paper supplied a new way through variable frequency variable speed ( vfvs ) to change its output flow rate and adding a constant - pressure - drop valve, which could solve the defects in hydraulic pressure servo control system, such as low efficiency in control system, short life, poor ability in resisting pollution, low efficiency in driving system and flow rate, pressure pulse. and this way was proved to be effective

    本論文針對傳統伺服控制系統效率不高、元件壽命短、抗污染能力差、驅動系統效率低、存在流量及壓力脈動等缺陷，利用先進的交流變頻調速技術改變液壓泵轉速的容積調速新方法，提出了在液壓系統中加一個定差減壓閥的新思路，較好地解決了液壓伺服系統存在的上述問題。
  5. The coefficients of skewness ( cs ) and kurtosis ( ce ) have the feature of cs < 0, ce

    縱向脈動速度概率密度分佈的偏態系數0 0 ，峰態系數ce 。
  6. Compared with existing modulating method, torque ripple is greatly reduced by uniform modulating in one monocycle, increasing current slope of upcoming conducting phase instantaneously suppresses the torque ripple by 30 ’ during low speed with obviously lower initiating noise

    採用單周期內各功率管均衡調制的方式，不僅消除了反向電流，而且與其他調制方式相比，可使轉矩脈動較小。
  7. Research on wind is the precondition of wind response, then the section plane of static wind, intensity of onflow, psd function and correlativity of dynamic wind are involved in

    對風的研究是進行風振響應研究的前提，風的基本特徵包括平均風速剖面、湍流強度、脈動風功率譜密度函數、脈動風的空間相關性以及極端風速的概率統計特性。
  8. The algorithm of svpwm that is adopted by the system implements motor speed - regulation by control of magnitude and phase of motor flux. it can generate less harmonics in the output current of power inverter and less losses of ac motor, reduce pulsant component in output torque and raise availability of dc supply voltage

    系統採用的svpwm演算法通過對空間磁鏈矢量幅值和相位的控制來調節電機轉速，減少了逆變器輸出電流的諧波，降低了脈動轉矩，提高了電壓的利用率。
  9. By performing fourier transformation, the relationship between the turbulent intensity of the particle and that of the carrier fluid was obtained which makes clear that particle size, specific gravity, velocity gradient, and the characteristic frequency of energy - containing eddies are four basic influencing parameters. it is proven theoretically that under certain conditions, the stream - wise and transverse particle turbulent intensities exceed those of the carrier fluid. based on the equations of two - phase flow, the presence of fine sediment suspension is shown to attenuate the turbulent intensity of the water

    通過對細小顆粒在剪切流場中運動方程的fourier分析，得到了顆粒脈動強度和流體脈動強度之間的定量關系，表明顆粒粒徑、顆粒密度、流速梯度以及紊動場含能旋渦的特徵頻率是影響顆粒脈動強度的主要因素，首次從理論上證明了在一定條件下，顆粒在縱、垂向的脈動強度均會超過相應的流體脈動強度，為已有的實測資料提供了合理的解釋。
  10. The researchful results indicate that the flux pulse ration of ordinary helical gear pump without clearance is less than that of the gear pump with clearence under the condition that the main parameters are same, and the flux pulse ration of ordinary helical gear pump is less than that of whole profile meshing helical gear pump

    研究結果表明：在主要參數相同的情況下，普通斜齒齒輪泵無側隙時流量脈動率小於有側隙時的流量脈動率；全齒廓嚙合斜齒輪泵比普通斜齒輪泵的流量脈動略小。
  11. The study has completed the design of two - phase inverter and made up of the two - phase inverter - motor system for experimental use it is a variable frequency adjustable speed system with a open - loop control of rotational speed, which consists of voltage - controlled oscillator circulating assign device inverter circuit and two - phase induction motor a accurate mathematical model is set based on the whole system, and simulator program of dynamic and steady condition is established, which is used to calculate the dynamic and steady performance by kron and symmetrical coordinate converter by simulator calculation and experimental research with specific parameter of the system, a comparison is made between predicted and experimental characteristics, experimental measurements are shown to compare closely with corresponding theoretical result it is compared with some variable frequency adjus table speed system comprising inverter and single - phase induction motor from the system efficiency torque pulsation and the effect of two - phase inverter capacitance based on the conclusion, harmonic cancellation pulse width modulation control of a two - phase inverter - fed induction - motor drive system is researched, which cancelled the low harmonic and improve the system performance

    通過對電機的kron變換和對稱分量變換，建立了系統較精確的數學模型，編制了系統動態及穩態運行的模擬計算程序分別計算系統的動態和穩態性能。通過對系統的具體參數進行了模擬運算和實驗研究，實驗和模擬結果進行比較，說明實驗和理論較為一致，並從系統效率、轉矩脈動及兩相逆變器電容的影響等方面與各種逆變器和單相異步電動機組成的變頻調速系統加以比較。在此基礎上，對兩相逆變器供電-異步電動機系統使用諧波抑制pwm控制進行了研究，由於減少了低次諧波，改善了系統性能。
  12. What is mainly discussed in this dissertation is as follows : the fault mechanism and vibration frequency feature of hydroelectric vibration are analyzed, induced and reorganized. the select and placement of detecting positions of parameters such as vibration, swing and pressure pulsation are researched, and the corresponding sensors are selected to monitor

    本文主要進行了以下工作：分析、歸納和整理了水電機組振動的故障機理和振動頻率特徵，對機組的振動、擺度和壓力脈動測點進行了選擇和布置，並選用相應傳感器進行監測。
  13. On the basis of theory analysis, the average transmitted light intensity ( correspond to dc value ) was determined as characteristic parameter of raw water using photoelectric method for monitoring the fluctuation of transmitted light and photometric dispersion analyzer ( pda ). the dc value was closely related to both particle concentration and surface area of sand clay simultaneously. the experimental results shows that there is an exponential function relation between dc and surface area of sand clay in unit volume water ( sp ) : dc = asbp in which a and b are empirical coefficients. then the formula of macromolecule flocculant dosage is found to be d = f ( dc ) = e ( dc ) f in which e and / are empirical coefficients and the average correlation coefficient equal to 0. 981. so the model of automatical control system of water treatment plant was established using the formula

    應用透光率脈動檢測技術和光散射顆粒粒度分析儀（ pda ） ，通過理論分析，將pda的輸出信號之一? ?平均透光強度（對應于dc值）作為原水的特性表徵參數， dc值可以同時反映顆粒濃度和比表面積因素的影響，試驗結果證明， dc值與單位體積水中泥沙顆粒總表面積s _ p之間具有很好的冪函數關系： dc = cs _ p ~ d ，式中c 、 d為經驗系數，進而得到了以dc值為參數的高分子絮凝劑投藥量公式： d = f （ dc ） = e （ dc ） ~ f ，式中： e 、 f為經驗系數，平均相關系數達0 . 981 ，利用所建立的公式，建立了前饋? ?后饋聯合控制的在線自動投藥模型。
  14. The tooth shape of gear pump has important influence on machining and characteristics of pumps, such as flow rate, fluctuation rate and noise etc. first, the working principle of tatsuno combined pumps is analyzed in this article

    齒輪泵的齒形對泵的加工、性能（如：流量、脈動率、噪聲）等有很大的影響。本文首先分析了進口tatsuno組合泵的工作原理，並進一步分析了其採用一對雙圓弧齒輪的優缺點。
  15. Although the flux per revolution of the optimized pumps is a little smaller than that of tatsuno combined pumps, other characteristics, such as fluctuation rate, maximum pressure angle and velocity fluctuation rate etc, are much better. the methods to cut gears are proposed in the theory for the practical produce in the future

    雖然，在體積相等的條件下，優化出來的外圓弧包絡線內嚙合齒輪泵的排量略小於tatsuno組合泵的排量，但其它性能（如：流量脈動率、最大壓力角、速度波動量）都更優。
  16. Thrust fluctuation ratio

    推力脈動率
  17. In addition, a calculating method of parametrically designing hydraulic motor with non - circular planetary gear is proposed aiming at maximal unit displacement and the minimal pulsation ratio by means of visual c + + 6. 0 software

    此外，探討了以單位體積排量最大為設計目標，流量脈動率最小為約束條件對非圓行星齒輪液壓馬達的參數化設計方法。
  18. Secondly, based on the research of flow characteristic of hydraulic motor with multi cylindrical gear, optimal conditions of tooth number are got to minimal the pulsation ratio of motor in the design of hydraulic motor

    其次，通過對圓柱多齒輪式液壓馬達的流量特性進行研究分析，得出使其排量脈動率最小所必須的各齒輪齒數應滿足的設計準則。
  19. Then a formula about flow of the gear pump and the coefficient of engagement overlap to find is obtained by area method. through analysis contact ratio and overlap ratio has the effect on the volume oil and the flow pulsating ratio

    然後採用面積法求得齒輪泵流量與齒輪嚙合重合系數的關系式，研究了齒輪嚙合重合系數對齒輪泵困油和流量脈動率的影響。
  20. Then, under the condition of satisfied the output volume request, a designing method of parametrically designing hydraulic motor with multi cylindrical gear is proposed aiming at minimal cubage with by means of visual c + + 6. 0 software, a calculating method of parametrically designing hydraulic motor with non - circular planetary gear is proposed aiming at maximal unit displacement and the minimal pulsation ratio by means of visual c + + 6. 0 software, and some designing method examples are provided for verifying the accuracy and possibility of those design methods

    再次，在滿足排量要求條件下，以體積小為設計目標，利用visualc + + 6 . 0軟體對圓柱多齒輪式液壓馬達進行了參數化設計軟體的開發;另外，以單位體積排量最大為設計目標，以流量脈動率最小為約束條件，利用visualc + + 6 . 0軟體對具有圓柱行星齒輪的非圓行星齒輪液壓馬達的參數化設計軟體進行了開發。
分享友人
分享到 Line

分享到臉書