脈幅 的英文怎麼說

中文拼音 [màifú]
脈幅 英文
vein width
  • 脈 : 脈名詞1. （動脈和靜脈的統稱） arteries and veins2. （脈搏的簡稱） pulse 3. （像血管的組織; 連貫成系統的東西） vein
  • 幅 : Ⅰ名詞1. （布帛、呢絨等的寬度） width of cloth 2. （泛指寬度） width; size 3. （姓氏） a surname Ⅱ量詞（用於布帛、呢絨、圖畫等）
  1. After the section of right side nxiits in budgerigar in the original sound wave ' s expanded time window, the higher amplitude pulse and the lower amplitude pulse exchanged alternately and also the higher amplitude is approximately as twice as the lower amplitude

    虎皮鸚鵡在斷右側nxllts后，原始時間波形展開圖中出現了各脈沖振幅一高一低相間的交替更換，且高振幅脈沖的振幅約為低振幅脈沖的兩倍。
  2. Pulse height discriminator

    脈沖幅度鑒別器
  3. In this paper, the signal processing of sum and difference patterns of amplitude dual - plane monopulse radar and the effect of amplitude - plane non - consistency are analyzed from the coordinates relationship of four - horn antenna at length, and its corresponding simulation is verified, which bring convenience to engineering implementation

    文中從四喇叭天線的位置坐標關系，詳細分析了雙平面振幅和差式單脈沖雷達信號處理過程以及三通道幅相不一致性的影響，並且進行了相應的模擬，為工程實現帶來了很大的便利。
  4. Pbx pulse amplitude modulation

    脈沖幅度調制
  5. The transmitted information is coded into the amplitude of the pulses so that each predetermined value of pulse energy is associated with a message.

    把傳輸的信息編碼成脈沖的振幅，因而使每個預先規定的脈沖能量值對應於一個信息。
  6. The algorithm of svpwm that is adopted by the system implements motor speed - regulation by control of magnitude and phase of motor flux. it can generate less harmonics in the output current of power inverter and less losses of ac motor, reduce pulsant component in output torque and raise availability of dc supply voltage

    系統採用的svpwm演算法通過對空間磁鏈矢量幅值和相位的控制來調節電機轉速，減少了逆變器輸出電流的諧波，降低了脈動轉矩，提高了電壓的利用率。
  7. As the vectors go around, the amplitude of the sum vector gets bigger, and smaller, and the intensity pulsates.

    在矢量旋轉時，合矢量的振幅時而變大，時而變小，因而強度作脈動變化。
  8. In the two - photon resonance case, part of the input pulse energy is transformed into higher and lower frequency components through amplified spontaneous emission and four - wave mixing, and the medium shows strong optical power limiting effect

    在雙光子共振情況下，即入射脈沖頻率等於1 、 3能級之間的共振頻率的一半，由於介質中放大的自發輻射和四波混頻的作用，部分入射脈沖能量轉化為高頻和低頻電場成分的能量，分子介質表現出了很強的光功率限幅特性。
  9. Focusing on the tactical index of ew system - bearing accuracy, this article makes deep - through analysis, comparison and study of the theory basis for traditional direction finding method. a 16 - channel monopulse amplitude - comparison direction finding method and new phase - delay estimating method has been proposed to use, through computer ' s analog computation and relative measures in actual engineering practices, the bearing accuracy of traditional method has been increased and the service requirement of the ew weapon system and adaptability of equipment satisfied

    本文圍繞著電子戰武器系統的戰術技術指標?測向精度，對傳統的測向方法的理論基礎進行了深入的分析、比較和研究，提出了採用16通道單脈沖比幅測向體制和新的相位延時估算方法，通過計算機的模擬摸擬計算，以及在實際的工程實現中採取的相關措施，解決了採用傳統的測向方法提高測向精度，滿足電子戰武器系統的戰術技術指標要求和裝備的適裝性。
  10. Based on the study of transferring characteristics of the lcc - type resonant voltage, the parameter combinations, which make widths and magnitudes of voltage pulses of resonant network adjustable, arededucedo when the following requirements are met : fn > 3, k > 3 or cp / cs > 8, the above circuit is of natural voltage - stabilized characteristics, thus open - loop control method for bucking voltage is presented and the experimental results verify that the method is feasible.,

    實測整機在額定負載時效率達到88以上。在研究lcc諧振網路電壓傳輸特性的基礎上，推導出滿足可變寬度和幅度的諧振網路輸出電壓脈沖列的參數組合。設計f n 3 、 k 3或c _ p / c _ s 8時，諧振網路具有自然穩壓特性，因此本文提出並實驗驗證了一種整機為降電壓時的開環控制策略。
  11. Two nonlinear simulation methods are designed by curve fitting method and anfis which seem simply and right in the simulation experiment. based on the model different control strategies also were realized in detail such as chopped current control ( ccc ), angular position control ( apc ), amplitude - change ccc and pi control. a simple torque sharing function ( tsf ) method and a tsf controller were designed which decreases torque ripple effectively

    文章中還建立一種基於模糊神經網路的非線性模型，並對比分析了三種方法，模擬中確定了電機的最優開通關斷角，在此基礎上實現了電流斬波控制、角度位置控制、變幅值電流斬波控制以及分段雙閉環pi控制，模擬結果表明，它實現了電機的正常運行，很好的抑止了電機轉矩脈動，同時有效地降低了噪聲。
  12. 1 m 0. 5, the phase - shifted angle 6 is controlled in term of sine law which makes the magnitude of resonant voltage track a reference sine voltage, and the resonant voltage is rectified, filtered, inverted and then the better sine - voltage output is obtained, theoretical analysis and experimental results show that for the resistive load and inductive load, the switches of leading leg of the phase - shift - controlled circuit are always turned on at zvs, and ones of lagging leg are turned on at zvs ( < 0 ) or turned off at zcs ( ( > 0 ), moreover, all switches in the low - frequency inverter are always turned on and off at zvs, the measured circuit efficiency for rated load reaches up to 88 %

    從功率單向流動角度出發，提出了一種lcc諧振型恆頻移相單相高頻鏈逆變電路拓撲，在調制系數0 . 1 m 0 . 5情況下，控制移相角按正弦規律變化，使諧振電壓脈沖列的幅值追蹤參考正弦電壓信號，經過整流、濾波、低頻逆變，從而獲得正弦度較好的輸出電壓。理論分析和實驗結果證明對于阻性負載或阻感性負載，移相全橋具有超前橋臂零電壓開通，滯后橋臂或者零電壓開通（ _ 0 ）或者零電流關斷（ _ 0 ）的軟開關特性，而低頻逆變器的各個開關均實現零電壓條件下的開通與關斷。
  13. By using a counter and an operation microprocessor, this paper analyses the measuring method and designs an instrument of edm sinking process in discharge state. this instrument takes samples of voltage, current signal and strong and weak of high frequency signals of detecting voltage amplitude, translates them into various time pulses in discharging state. and a counting unit turns these pulses into digital signals, then send them to a microprocessor. finally various discharge time percentages are sent to the control tache

    通過采樣電火花加工放電間隙的電壓、電流信號和檢測電壓幅值上的高頻信號的強弱，得出反映間隙放電狀態的各種時間脈沖，利用計數器分別對其計數，再送給單片機運算處理，輸出控制環節所需的各種放電狀態時間百分數。
  14. Abstract : by using a counter and an operation microprocessor, this paper analyses the measuring method and designs an instrument of edm sinking process in discharge state. this instrument takes samples of voltage, current signal and strong and weak of high frequency signals of detecting voltage amplitude, translates them into various time pulses in discharging state. and a counting unit turns these pulses into digital signals, then send them to a microprocessor. finally various discharge time percentages are sent to the control tache

    文摘:通過采樣電火花加工放電間隙的電壓、電流信號和檢測電壓幅值上的高頻信號的強弱，得出反映間隙放電狀態的各種時間脈沖，利用計數器分別對其計數，再送給單片機運算處理，輸出控制環節所需的各種放電狀態時間百分數。
  15. In the experimental system apd transferred laser pulse to weak electrical current. after two - level amplification we got a voltage pulse that had a enough amplitude to be applied, the timing point was discriminated by the constant - fraction timing discriminator circuit. timing circuits transferred the pulse flight time to digital signal accurately

    實驗系統採用apd作為光電傳感器，將激光脈沖信號轉變為微弱電流脈沖，經過兩級放大后，信號變為幅度較大的電壓脈沖，經過時點鑒別電路分別確定計時起點和終點后，由計時電路來精確測量兩個時間點之間的時間間隔。
  16. Kicksorting of pulses

    脈沖振幅分析
  17. Application of pulse range analysis technique to sound - light effect experiment

    脈沖幅度分析技術在聲光效應實驗中的應用研究
  18. A very low ring of the antenna has been demonstrated with measurement results

    實際測試結果顯示，電阻加載漸變槽線天線拖尾脈沖的幅度非常低。
  19. The method can measure the following parameters, ( pulse attitude ) pa, ( pulse width ) pw, ( time of approach ) toa, snr, ( radio frequency ) rf, pulse envelope characteristic parameters and intra - pulse modulation parameters with a high precision and a high discrimination

    該演算法能夠分析雷達信號的脈沖脈幅、脈寬、到達時間、信噪比、載頻、脈沖包絡特徵參數和脈內調制特徵參數。
  20. Pam pulse amplitude modulation

    脈幅調制
分享友人
分享到 Line

分享到臉書