脈沖電子管 的英文怎麼說

中文拼音 [màichōngdiànziguǎn]
脈沖電子管 英文
pulse tube
  • : 脈名詞1. (動脈和靜脈的統稱) arteries and veins2. (脈搏的簡稱) pulse 3. (像血管的組織; 連貫成系統的東西) vein
  • : Ⅰ名詞1 (有電荷存在和電荷變化的現象) electricity 2 (電報) telegram; cable Ⅱ動詞1 (觸電) give...
  • : 子Ⅰ名詞1 (兒子) son 2 (人的通稱) person 3 (古代特指有學問的男人) ancient title of respect f...
  • : Ⅰ名詞1 (管子) pipe; tube 2 (吹奏的樂器) wind musical instrument 3 (形狀似管的電器件) valve;...
  • 電子 : [物理學] [電學] electron
  1. In the sub block circuit design, the contents that the author had introduced include : the principle of band gap voltage reference and the design technique in low power supply ; the analysis of spike pulse noise rejection, frequency divider and dead time in oscillator and control circuit ; the selection of the width and length ratio of four switches and 2x / 1x mode change point in driver and mode selection circuits

    路設計中,作者比較深入分析的內容有:基準路的原理及低壓下基準路的設計;振蕩器和控制路中尖峰噪聲抑制、兩分頻路及死區時間設定;驅動及模式選擇路中開關的寬長比的選擇及模式轉換點的設計。
  2. Measurements of the electrical properties of electronic tubes. part 20 : methods of measurement of thyratron pulse modulators

    性能的測量.第20部分:閘流調制器的測量方法
  3. Abstract : as the heart of twt , the structure stability of grided electron gun directly affect pulse output performance of twt , and the structural reliability under vibration stress are especial - ly important for today ' s manufacturers

    摘要:柵控槍作為行波的「心臟」 ,其結構的穩定性直接影響著輸出性能,特別是在振動應力下的結構可靠性更是當今生產單位關注的重點。
  4. Surface flashover across the insulators in vacuum is the major limitation of the performance of the high power system, such as high power microwave tube, pulse power switch, high - energy linear accelerator, etc. flashover studies are of considerable importance in many applications. alumina ceramics are used widely in vacuum insulation system. the flashover and charging performance have been systematically investigated on alumina ceramics in vacuum under pulse voltage ( 0. 7 / 4 ^ 8 )

    真空中絕緣沿面閃絡現象是制約高功率微波功率開關、高能粒加速器等系統性能的主要原因,這是因為真空中絕緣在一個比自身及相同真空間隙擊穿場低得多的場下就發生了表面閃絡的緣故,研究真空中絕緣沿面閃絡現象及其形成機理對于改善和提高系統性能有重要意義。
  5. Aqueous fluid volume and [ c1 ~ j were assayed in samples withdrawn by micropipettes. intraocular pressure ( top ), pressure - dependent outflow, and anterior chamber compliance were determined from pressure measurements in response to pulsed and continuous fluid infusions into the anterior chamber using micropipettes. result : in wildtype mice ( gdi genetic background, age 4 - 6 weeks ), iop was 16. 0 ? 0. 4 mmhg, aqueous fluid volume was 7. 2 ? 0. 3 ul, aqueous fluid production was 3. 6 ? 0. 2 ul / hr, aqueous fluid outflow was 0. 36 ? 0. 06 ul / hr / mmhg, and anterior chamber compliance was 0. 036 ? 0. 006 ul / mmhg ( mean ? se, 8 - 10 eyes )

    實驗方法包括:將熒光物質用滲透的方法穿透角膜導入活體小鼠的前房中,然後應用共聚焦顯微鏡根據熒光強度變化測量房水生成率;通過顯微注射針吸取房水檢測房水容積和氯離濃度;顯微玻璃刺入前房測量眼內壓,並將生理鹽水分別以連續和兩種方式注入前房,測量房水間隙的順應性和房水排出與眼內壓的相關性。
  6. Regard how to structure the control system of sensorless bldcm with dsp - tms320f240 as the centre in this paper, the detailed argumentation course of the motor startup, bemf terminal voltage measurement and control strategy is given out, give and pay concrete details for the software and hardware realization and experimental result. in order to treat the bldcm control system with dsp clearly, the full paper divides into six chapters altogether : chapter one, introduceing the development course, the structure characteristic and operation principle, etc. of bldcm in the introduction ; chapter two, directed against the startup issue of bldcm, the chapter give and publish the rotor measure pulse orients technology for motor startup in detail ; chapter three, proceed with mathematics model of the bldcm, expounding the control schemes ; chapter four, two important devices introducing : dsp ( 240 tms320f ) and power invertor control chip ( ir2131s ) ; chapter five, give and publish the detail of hardwares of control system ; chapter six, by ccs ide of ti, realize the control schemes in the front chapters with software, offere the procedure flow chart of main subroutine and some key place of programming, the experiment result in addition

    全文共分六章:第一章、緒論中介紹了bldcm的發展歷程、機本身的結構特點和工作原理等;第二章、針對五位置傳感器bldcm的起動問題,文中詳細給出了檢測定位起動技術;第三章、從機的數學模型入手,詳細論述了反動勢端壓法和系統的控制策略;第四章、介紹了硬體實現中的兩個重要器件: dsp ( tms320f240 )和功率逆變器控制晶元( ir2131s ) ;第五章、詳細給出了控制系統的硬體實現細節;第六章、利用ti提供的ccs集成開發環境,將前面章節的控制方案用軟體加以實現,給出了主要部分的程序流程圖和一些編程要點以及實驗結果。
  7. Specification for harmonized system of quality assessment for electronic components - blank detail specification : pulsed magnetrons excluding frequency agile magnetrons

    元件器質量評定協調體系規范.磁腔空白詳細規范
  8. Measurements of the electrical properties of electronic tubes. part 23 : methods of measurement of vacuum pulse modulator tubes and valves

    性能的測量.第23部分:真空調制的測量方法
  9. A new type high efficiency synchronous step - up dc / dc converter for hand - held device is designed in this thesis. it works in the pfm ( pulse frequency modulating ) mode, and its switching frequency can up to 500 khz. it offers a built - in synchronous rectifier that reduces size and cost by eliminating the need for an external schottky diode and improves overall efficiency by minimizing losses

    本文設計了一種用於移動設備的高效同步整流的dc / dc升壓晶元,該晶元採用pfm (周期調制)調制方式,工作頻率最高可達500khz ,內部集成功率作為同步整流,代替傳統的肖特基二極體,導通阻僅有0 . 4
  10. Detail specification for electronic components. type 3da505 l band silicon pulse power transistor

    元器件詳細規范. 3da505型l波段硅功率晶體
分享友人