脲甲醛樹脂 的英文怎麼說

中文拼音 [jiǎquánshùzhī]
脲甲醛樹脂 英文
urea formaldehyde resin
  • : 名詞[化學] (尿素) urea; carbamide
  • : Ⅰ名詞1 (天乾的第一位) the first of the ten heavenly stems2 (爬行動物和節肢動物身上的硬殼) she...
  • : 名詞[化學] (有機化合物的一類) aldehyde
  • : Ⅰ名詞1 (木本植物的通稱) tree 2 (姓氏) a surname Ⅱ動詞1 (種植; 栽培) plant; cultivate 2 (樹...
  • : 名詞1. (動植物所含的油質) fat; grease; tallow 2. (胭脂) rouge 3. (姓氏) a surname
  • 甲醛 : [有機化學] formaldehyde; cascophen; arofene; methanal; formol; methylene oxide
  • 樹脂 : resin; jaffaite; peucine
  1. Wood adhesives - urea - formaldehyde, phenol - formaldehyde and melamine - formaldehyde resins

    木材工業膠粘劑用三聚氰胺
  2. Wood adhesives : urea - formaldehyde, phenol - formaldehyde and melamine - formaldehyde resins

    木材工業膠粘劑用三聚氰胺
  3. The tea waste powder with different sizes as an additive was used to urea - formaldehyde ( uf ) resin, and the effects of the tea waste powder sizes and amount on the free formaldehyde content of uf resin, the formaldehyde emission, and hood strength of uf resin hooded plywood were studied in this paper

    摘要將不同顆粒度的茶葉廢料粉添加到膠中,研究了茶葉廢料的顆粒度、加入量等對膠黏劑的游離含量、黏接膠合板的釋放量及膠合強度的影響。
  4. The experimental results indicated that the tea waste powder as an additive to uf resin could reduce its free formaldehyde content and reduce the formaldehyde emission of uf resin bonded plywood ; the tea waste powder with much less size was easily mixed with uf resin and acted much more effective ; the tea waste as an additive to uf resin in a proper amount did nut decrease the bond strength of plywood

    實驗結果表明,茶葉廢料作為填料添加到膠黏劑中,能夠降低其游離含量以及其黏接膠合板的釋放量;茶葉廢料顆粒度越小,與混合性越好,消除效果越顯著;茶葉廢料的適量加入不會降低膠合板膠合強度。
  5. Standard specification for urea - formaldehyde resin adhesives

    脲甲醛樹脂膠粘劑標準規范
  6. Standard test method for nonvolatile content of urea - formaldehyde resin solutions

    脲甲醛樹脂溶液中不揮發物含量的標準測試方法
  7. Study on reducing content of free formaldehyde of uf

    降低游離含量的探討
  8. Study on using nanometer sio2 and caco3 for the free formaldehyde content of the uf resin

    3改性含量及性能研究
  9. Chemical analysis of urea -, thiourea - and melamine - formaldehyde resins and aminoplastic moulding materials in the moulded and unmoulded state

    尿素.硫和蜜胺-.氨基塑料-模塑材
  10. Templates for major construction 2, 000 tonne plastic production technology transfer, low - cost, environmentally friendly type of plastic resins and thiourea aldehyde wave aldehyde production technology transfer and increased nianji " zhengshi card " indoor to agents - - formaldehyde by 15 yuan per kg doses ( no secondary pollution ) and the national cheng zhao agents

    主要有建築模板專用膠2000元/噸生產技術轉讓、低成本、環保型膠及消增粘劑生產技術轉讓和「正始牌」室內去毒劑- -清除劑每公斤15元(無二次污染)並誠招全國各代理商。
  11. Cellular plastics as in - situ foam in building ; in - situ foam produced from urea - formaldehyde resin for thermal insulation ; application, properties, execution, testing

    建築中現場發泡用泡沫塑料.絕熱用-現場發
  12. In japan, an amendment law on construction standards has been implemented, which is stipulated that the products containing formaldehyde should not be used indoors, including urea - formaldehyde resin, melamine resin and resorcinol resin

    日本已開始實施建築標準法修正案,規定室內不允許使用含系列防腐劑的、三聚氰胺和間苯二酚等產品。
  13. By using the othogonal test of l9 ( 3 ^ 3 ), the regeneration of ureaformaldehyde gel, was studied and the optimum operation conditions were determined : the mass ratio of formaldehyde ( 37 % ) to gels is 2. 5 : 1, the final motar ratio of regenerative resin is 1. 3 : 1 ( f : u )

    摘要選用正交l9 ( 3 ^ 3 )試驗研究了凝膠的再生,分析試驗結果得出了凝膠的再生的最佳工藝條件:( 37 % )與凝膠質量比為2 . 5 : 1 ,再生與尿素終物質的量比1 . 3 : 1 。
分享友人