脹管試驗 的英文怎麼說
中文拼音 [zhàngguǎnshìyàn]
脹管試驗
英文
expand test- 脹 : 動詞1. (膨脹) expand; dilate; inflate 2. (脹大) swell; distend; bloat
- 管 : Ⅰ名詞1 (管子) pipe; tube 2 (吹奏的樂器) wind musical instrument 3 (形狀似管的電器件) valve;...
- 試 : 名詞(古代占卜用的器具) astrolabe
- 驗 : 動詞1. (察看; 查考) examine; check; test 2. (產生預期的效果) prove effective; produce the expected result
- 試驗 : trial; experiment; test
-
The heat - exchange apparatus is the window for air - conditioner to exchange energy with outside. we analyze the efficiency of heat - exchange apparatus by the theory of heat - transmit, and compare the advantage and disadvantage of different type evaporator ' s and condenser ' s design by lots testing, and compare the effect of heat - exchange for different type flake, and compare the effect of heat resistance for different stretch of copper tube and flake. then we get many useful results from those different comparing
蒸發器與冷凝器統稱為換熱器,換熱器是空調器與外界進行能量交換窗口,利用傳熱學原理對換熱器的效率進行分析,通過大量的試驗比較不同的蒸發器,冷凝器設計方案的優劣;比較冷凝器使用不同片型對換熱效果的影響;比較銅管與翅片的不同脹緊對熱阻的影響,通過比較得出很多有用的結論。Abstract : calculation methods on hydraulic expended tube - to - tubesheet joints are reviewed. the application of ansys in the research of hydraulic expanding technique is then presented, and an example is given
文摘:對液壓脹管的計算方法進行了回顧,介紹了ansys在脹管分析中的應用,並提供了模擬脹管過程及拉脫試驗算例。Then experiment was processed to testify the calculated results. based on the theory of vibration mode, harmonic response and experiment, fea meshing, fea element and bound condition of expansion joint were analyzed. then a parametric fea modeling & post process software was developed by apdl and visual basic langrage
本文採用有限元數值分析方法,利用大型商用有限元計算軟體ansys ,研究了基於結構參數化設計思想的波紋管膨脹節的振動模態和含波紋管膨脹節管系的振動響應分析方法,開展了波紋管膨脹節模態試驗驗證。Research on experiment and expansion model of expansive concrete filled steel tube
鋼管微膨脹混凝土試驗與研究Mechanics experimental study of solid expansion pipe
實體膨脹管力學行為試驗研究In this article, through lab and engineering site trials that the physical data of new type pipe materials is corrected, the results are as follow : ( l ) the expansion coefficient of new plastic pipe materials is more large than that of iron pipe. ( 2 ) new plastic pipe materials have different heat - resisting character and according to the water temperature to choose pipe materials ; ( 3 ) the loss of head of water for new type pipe materials is more smaller than iron pipe and also correct the loss of head of water that calculated by theory ; ( 4 ) probing into the press - resistance character of new plastic pipe materials
本文通過試驗室試驗及工程現場試驗,對新型給排水管材的幾個重要的物理性能參數進行實驗測定,糾正了以往的錯誤認識。研究結果表明: ( 1 )新型塑料管材線脹系數遠遠大於鋼管和鑄鐵管,設計和施工中要嚴格考慮管道的伸縮; ( 2 )新型塑料管材耐高溫性能各不相同,需根據管內水溫選定管材; ( 3 )新型管材水頭損失遠小於鋼管,並對原水頭損失計算公式進行了修正; ( 4 )對于塑料管材的耐壓性能進行了探討。Methods of test for rubber and plastics hoses and hose assemblies - hydraulic pressure tests - determination of volumetric expansion of fuel - dispensing pump hoses
橡膠和塑料軟管及軟管組件試驗方法.第102部分:液壓試驗.第3節:燃料分配泵軟管體積膨脹測定The physical experiments and theories on thermodynamics prove that gas thermal insulation coefficient changes apparently when hydraulic transition process happens. so four appropriate processes were given - sub - process 1 of compressing, sub - process 2 of inflating, sub - process 3 of inflating, sub - process 4 of compressing
試驗與理論分析表明,在管道系統發生水力過渡過程時氣體多方指數n存在較為顯著的變化,並非單一常數,從而提出了相應的四過程:即壓縮子過程1 、膨脹子過程2 、膨脹子過程3和壓縮子過程4 。Methods of test for rubber and plastics hoses and hose assemblies - hydraulic pressure tests - determination of volumetric expansion of hydraulic hoses
橡膠和塑料軟管組件試驗方法.第102部分:液壓試驗.第4節:液壓軟管體積膨脹測定分享友人