腐改率 的英文怎麼說

中文拼音 [fǔgǎilǜ]
腐改率 英文
rate of spoilage
  • 腐 : Ⅰ名詞（豆腐） bean curdⅡ動詞（腐爛; 變壞） decay Ⅲ形容詞（腐爛） rotten; corroded; putrid
  • 改 : Ⅰ動詞1 （改變） change; transform 2 （修改） revise; alter; modify 3 （改正） rectify; correct 4 ...
  • 率 : 率名詞（比值） rate; ratio; proportion
  1. Ferrous sulphate treatment improves the erosion rate of the alubrass. the corrosion rates observed are however higher than that obtained with mexel 432

    硫酸亞鐵處理改善鋁黃銅的浸蝕率，然而其腐蝕率仍高於m . 432處理。
  2. Abstract : the causes for low efficiency of the heater in no. 2 crude unit of jpc refinery are described and analyzed including water leaking of steam soot blower, dew point corrosion caused by steam, soot deposits in convection chamber owning to poor soot blowing, high flue gas temperature, no heat recovery of flue gas, and poor performance of insulation lining, etc. by using sonic soot removing system, flue gas recovery system, spray coating of fiber and rock wool, as well as adjustment of flow scheme accordingly in the technical revamping. the dew point corrosion is completely eliminated, the insulation performance is improved, the heat loss is reduced by 1. 25 %, the flue gas temperature is reduced to about 170, and the heater efficiency is increased from 83 % to more than 90 %

    文摘:分析了金陵石油化工公司煉油廠二套常減壓裝置加熱爐存在的因蒸汽吹灰器漏水，蒸汽引起露點腐蝕及吹灰效果差造成對流室積灰，排煙溫度高，煙氣熱量未回收利用以及爐子保溫襯里效果差等問題，提出採用聲波除灰系統、煙氣回收系統、纖維噴塗和巖棉噴塗及相應的流程調整等改造措施.測定結果表明，本次技術改造解決了因蒸汽吹灰器漏水所造成的露點腐蝕問題，提高了保溫效果，減少散熱損失1 . 25 % ，排煙溫度降至170左右，裝置的爐效率由83 %左右提高到90 %以上
  3. The causes for low efficiency of the heater in no. 2 crude unit of jpc refinery are described and analyzed including water leaking of steam soot blower, dew point corrosion caused by steam, soot deposits in convection chamber owning to poor soot blowing, high flue gas temperature, no heat recovery of flue gas, and poor performance of insulation lining, etc. by using sonic soot removing system, flue gas recovery system, spray coating of fiber and rock wool, as well as adjustment of flow scheme accordingly in the technical revamping. the dew point corrosion is completely eliminated, the insulation performance is improved, the heat loss is reduced by 1. 25 %, the flue gas temperature is reduced to about 170, and the heater efficiency is increased from 83 % to more than 90 %

    分析了金陵石油化工公司煉油廠二套常減壓裝置加熱爐存在的因蒸汽吹灰器漏水，蒸汽引起露點腐蝕及吹灰效果差造成對流室積灰，排煙溫度高，煙氣熱量未回收利用以及爐子保溫襯里效果差等問題，提出採用聲波除灰系統、煙氣回收系統、纖維噴塗和巖棉噴塗及相應的流程調整等改造措施.測定結果表明，本次技術改造解決了因蒸汽吹灰器漏水所造成的露點腐蝕問題，提高了保溫效果，減少散熱損失1 . 25 % ，排煙溫度降至170左右，裝置的爐效率由83 %左右提高到90 %以上
  4. The authour investigate the dosing conditions and effect of the pac to the huanghe water - source, which includes the following four parts : the selection of the pac ; the confirmation of dosing scheme and effect of the pac ; the research of application of potassium permanganate in combination with pac ; the research of the pac ' s modification and the modified effectiveness. the experiment is mainly carried out on the pilot system in the jieyuan water plan of tianjin. the results of the reseach include the following : l ) the pac from zunhua plant is selected as the better carbon for the source water of tianjin through the experiment ; 2 ) through the pilot experiment we conclude that the pac ' s best adding point is the mixing tank and the better dose is 10mg / l, on which the codmn of filtered water can be decreased to 40 % and the effluent have no problem of odour and color ; 3the adsorbing experiment show that pac mainly adsorb the organic matters which molecular wt., distribution between 500 and 3000, and can adsorb organic matters whose molecular wt., distribution are bigger than 6000 if the dose of it is adequent ; 4 ) pac together with potassium permanganate can remove the organic matter more effectively than each of them alone, and reduce the rising trend of turbidity of the flotation ' s effluent due to adding pac ; 5 ) the thesis made a research on the surface properties and the adsorbing capability of the modified carbon by oxidizer : the modified carbon with 20 % h2o2 can remove more organic pollutants than the untreated one by 12 % when we add a higher dose of coagulant ; 6 ) the modification of reduction and loading metal ions are also sttldied, and drow the following conclusions : the modified carbon with 5 % ammonia can enhance the organic matter ' s removal effectiveness by 10 % to the tianjin source water than the untreated one, and the modified one with loading metal ion remove the organic matters from the tianjin source water better ( 8 % ) than the untreated one due to the strong affinity betwween the humic acid and copper ion

    本文的實驗主要是在天津芥園水廠的中試系統上完成的，論文的成果和結論主要包括： 1 ）通過靜態實驗選定河北遵化活性炭廠生產的煤質炭為適合天津原水的炭種； 2 ）中試實驗確定粉末活性炭的較佳投加點為混合池投加，較佳投加量為10mg l ，此時可使濾后水的cod _ （ mn ）降低40 ，且可較好地控制濾后水的嗅味和色度； 3 ）初步確定粉末活性炭對原水中有機物的吸附主要集中在分子量在500 - 3000范圍內，投量增大時可吸附部分分子量大於6000的有機物4 ）中試實驗表明：粉末活性炭與高錳酸鉀聯用可取得較兩者單獨應用時對有機物更好的去除效果，且對因投加粉末活性炭而造成的氣浮出水濁度升高有一定的改善作用； 5 ）研究並初步確定氧化改性對粉末活性炭表面性質和有機物的去除效果的影響：粉末活性炭的氧化改性會使其表面的酸性官能團大量增強，表面極性增加；經20的過氧化氫改性的活性炭在增大混凝劑投加量（ fecl _ 3投量為15mg l ）時對有機物的總體去除效果較原活性炭提高12 ， 1次氯酸鈉改性活性炭對有機物的去除效果較原活性炭提高6 ； 6 ）研究並初步確定還原改性、負載金屬離子對原水中有機物的去除效果的影響：經5氨水改性的活性炭可提高天津源水中有機物的去除率達到10 ；負載銅離子后的活性炭可提高對腐殖酸類物質的去除能力，一般可提高8左右。
  5. The formulae that didn " t contain fluorine had low rates of corrosion, high stability and easy operation and had distinct improvement in coating quality, surplus of chromium, saving electricity and energy and environmental protection etc. when they were compared with the commercial additive of wr - 1 and the electrolyte formula of fenghui galvanization plant, the results showed that the effect of chromium plating of the formulae obtained in this study are more excellent

    所研製的配方，不含氟、腐蝕率低，穩定性好，易操作，在鍍層質量、節鉻、節電、節能、環境保護諸方面都有明顯的改善，並將其與市售的wr 1添加劑和淬惠電鍍廠鍍鉻效果進行了對比，結果表明本研究得到的配方鍍鉻效果更優良。
  6. The variations of the surface state and environment conditions could change the procedure of exfoliation, therefore, the potentiometry and electric resistance methods in this paper are used to measure the exfoliation rate of aluminum alloys in a constant temperature, the experimental results show that relations of natural corrosion potential vs time have a resemblance to those of corrosion rate vs time, both relations are all at the different change rates in the front and back of 120 minutes

    超硬鋁合金表面狀態、環境條件的變化，均可能改變剝蝕的發展過程，為此，本文提出在恆溫條件下，用電位法、電阻法定量研究鋁合金的剝蝕性能。實驗結果顯示了lc4cs鋁合金的自腐蝕電位與時間的關系，和腐蝕速率與時間的關系有著十分相似的規律，兩者均在120分鐘前後有不同的變化。
  7. Amendment 1 - insulating and sheathing materials of electric and optical cables - common test methods - part 5 - 1 : methods specific to filling compounds - drop point - separation of oil - lower temperature brittleness - total acid number - absence of corrosive components - permittivity at 23 c - dc resistivity at 23 c and 100 c

    電纜和光纜用絕緣和護套材料.通用試驗方法.第5 - 1部分:填充復合物的專用方法.滴點.油分離.較低溫脆性.總酸值.無腐蝕性成分. 23時的介電常數. 23和100時的直流電阻率.修改件1
分享友人
分享到 Line

分享到臉書