膜電容 的英文怎麼說

中文拼音 [módiànróng]
膜電容 英文
membrane capacitance
  • 膜 : 名詞1. [生物學] （像薄皮的組織） membrane 2. （像膜的薄皮） film; thin coating
  • 電 : Ⅰ名詞1 （有電荷存在和電荷變化的現象） electricity 2 （電報） telegram; cable Ⅱ動詞1 （觸電） give...
  • 電容 : electric capacity; capacitance; capacity
  1. Cbb61 metallized polypropylene film capacitor for ac

    Cbb81 pps高壓聚丙稀膜電容器
  2. Among various fabrication techniques of thin film, the sol - gel process has gained much interest for the preparation of pzt thin film, due to ihe advantages of good homogeneity, easy control of composition, low in - ill i reaving temperature, easy formation of large area thin films pb ( zrxti : - k ) 0 :, ( pzt ) films were prepared on the ito coated glass plates and low resistor silicon wafer in sol - gel dip - coating process associated wi di heat treatment : at different temperatures and characterized by x - ray diffraction ( xrd ) and transmission electron microscopy ( tem ). lt is shown that the pzt ferroelectric thin films with ( 110 ) preferred orientation and well - crystallized perovskite structure can be obtained after annealing at 680 ? for 30 minutes on ito substrate and at 800 " c for lornin on silicon substrate

    Pzt的制備方法有很多，其中溶膠?凝膠（ sol - gel ）方法可以和集成電路（ ic ）光刻工藝相互兼容，處理溫度低，有大面積塗敷性能，能精確地控制組分，無需復雜的真空設備，成本低廉，所以對于集成鐵電薄膜電容的應用這種方法有很廣闊的前景。本文利用sol - gel技術在摻錫的in _ 2o _ 3透明導電薄膜（ ito ）襯底和低阻硅襯底上成功地制備了pzt鐵電薄膜。運用了x射線衍射， sawyer - tower電路和lcr電橋分別對薄膜的晶化溫度，結構和電學性能進行了測試。
  3. A higher surface coverage and a lower film capacitance were obtained with a subsequent modification with alkanethiol, indicating a significant improvement in the quality of the films

    用烷基硫醇進一步修飾席夫堿自組裝膜后，表面覆蓋度明顯增加，而膜電容顯著降低，說明膜質量得到了改善。
  4. Fp film and paper condenser

    紙絕緣薄膜電容器
  5. H _ e _ y _ s _ a venta de productos para la industria alimentaria : concentrado y jaleas de maracuy, mole con la receta original poblana, caf, leche en polvo, grasa but rica

    海門市銀燕電子有限公司主產薄膜電容器，主要應用於電子節能燈、通訊設備、家用電器等。
  6. For many applications thin - film resistors and capacitors offer certain distinct advantages over their junction counterparts

    在許多場合，薄膜電阻、薄膜電容與結電阻、結電容相比有一些明顯的優點。
  7. V2a pc poly carbonated film capacitor

    V2a pc聚碳酸酯薄膜電容polycabonate
  8. Cl21xmefminisubminiature metallized polyester film capacitor

    Cl21x mefmini超小型金屬化聚脂膜電容器
  9. It is capable to lower the insertion loss by using high conductivity electrode material and increasing the electrode thickness and quality factor of bst capacitor. at the same time increasing the tunability of the dielectric constant and the length of the transmission line can increase the phase shift

    通過使用高電導率的電極材料、增加電極的厚度、提高bst薄膜電容的q值可以實現器件插損的降低；增大薄膜的介電系數變化率和傳輸線長度可以增加移相度。
  10. A common structure for capacitors is two sheets of metal foil separated by sheets of plastic or paper dielectric and formed into a roll

    電解電容器、紙介電容器和塑料薄膜電容器不適合用於高頻去耦。
  11. X1y emi suppression capacitor cbb13 polyropylene film capacitor

    Cbb13 ppn聚丙稀膜電容器
  12. Metalized film capacitor

    金膜電容
  13. Structure and properties of thickfilm capacitors fabricated by laser microcladding rapid prototype

    激光微細熔覆快速原型製造的厚膜電容組織性能
  14. Several patch clamp configurations have b een used to study the activity of ionic channels. the resting potential and capa citance as well as resistance of different lens cells were also measured

    不僅記錄了晶體細胞膜上多種通道活動，還測量了不同種屬晶體上皮細胞的靜息膜電位和膜電容，以及位於晶體內不同深度的晶體纖維細胞間的縫隙連接電阻。
  15. Cl21 metallized polyester film capacitor

    Cl21 mef金屬化聚脂膜電容器
  16. Cbb21 metallized polypropylene film capacitor cbb21 - b metallized polypropylene film capacitor - box

    Cbb21 mpp金屬化聚丙稀膜電容器
  17. Cl11 polyester film capacitor cl21x - bmembsubminiature metallized polyester film capacitor - box

    Cl21x mefmini超小型金屬化聚脂膜電容器
  18. Cl21x - bmembsubminiature metallized polyester film capacitor - box cl21xmefminisubminiature metallized polyester film capacitor

    Cl21x mefmini超小型金屬化聚脂膜電容器
  19. Abstract : based on the characteristic of film pluse capacitors, this paper introduces the performance reliability of metalized film plused capcitor banks, and discusses the estimate of performance reliability in two different conditions

    摘要：基於金屬化膜電容器的特點，提出了金屬化膜電容器組的性能可靠性，並分兩種情況討論了性能可靠性的估計方法。
  20. On the condition of absence of feature degradation modal of parts and effective aid tool, the failure mechanism and reliability model of parts in power module are analysised, and with the result of failure analysis and empirical data the life model of metalized electrode capacitor is figured out, which is proved to be weibull distributions

    在缺乏元器件性能老化模型和有效輔助工具的前提下，研究了能源模塊電路主要元器件的失效機理和可靠性模型。利用對金屬化膜電容器失效分析結果和經驗數據給出金屬化膜電容器的威布爾壽命模型。
分享友人
分享到 Line

分享到臉書