膠化性能 的英文怎麼說
中文拼音 [jiāohuàxìngnéng]
膠化性能
英文
gelling property-
Rheological and gelation properties of pvc paste filled with nanometer caco
糊的流變及凝膠化性能The results show that in 185 saturated steam, pyrite tailing doesn ' t hydrate alone, but is converted into calcium silicate hydrate when mixed with lime
結果表明： 185飽和蒸汽壓下，硫鐵尾礦不具有水熱水化的能力，硫鐵尾礦與石灰可以形成具有膠凝性能的水化產物。Their properties have been investigated by using scanning electronic microscopy ( sem ), differential scanning calorimetry ( dsc ), x - ray diffraction ( xrd ), thermogravimetry - differential thermal analysis ( tg - dta ), infrared spectroscopic analysis ( ir ), and gas chromatography ( gc ), etc. the effects of the mulser ' s stirring rate and the emulsifier concentration on the properties of encapsulated pcms have been systematically studied, and nanopcms have been obtained by increasing the stirring rate or the emulsifier concentration. the influences of different nucleating agents on micropcm performances have also been investigated in detail to search for a suitable nucleating agent to prevent micropcms from super - cooling
首先，系統研究了乳化機轉速和乳化劑濃度對膠囊性能的影響，並通過提高轉速或乳化劑濃度獲得相變材料納膠囊；其次，系統研究了不同成核劑對微膠囊性能的影響，找到合適的成核劑抑制了相變材料微膠囊的過冷現象；再次，詳細研究了環己烷對膠囊性能的影響，並通過添加適量環己烷提高了相變材料微膠囊及納膠囊的耐熱溫度。Silicone rubbers are used for both high and low temperature applications, since their properties change little with temperature.
聚硅烷橡膠因性能隨溫度變化小，故在高溫和低溫的場合都能用。Influence of tapping system on film property of vulcanized
硫化膠乳膠膜性能的影響Abstract : through contrast test ， characters of ig sealant filled by mineral oil were compared with those of the sealant unfilled by mineral oil ， such as durability ， heat aging resistance ， adhesive ability and the compatibility with hot melt butyl sealant ， and the ultraviolet irradiating resistance of the ig made by them
摘要：本文通過對比實驗，比較了摻油和未摻油中空玻璃密封膠的耐久性、熱老化性能、粘接性能以及與熱熔丁基密封膠的相容性，比較了其製造的中空玻璃的耐紫外輻照性能。Through contrast test, characters of ig sealant filled by mineral oil were compared with those of the mineral oil unfilled sealant, such as durability, heat aging resistance, adhesive ability and the compatibility with hot melt butyl sealant, and the ultraviolet irradiating resistance of the ig made by them
摘要通過對比實驗，比較了摻油和未摻油中空玻璃密封膠的耐久性、熱老化性能、粘接性能以及與熱熔丁基密封膠的相容性，比較了其製造的中空玻璃的耐紫外輻照性能。Abstract : through contrast test, characters of ig sealant filled by mineral oil were compared with those of the sealant unfilled by mineral oil, such as durability, heat aging resistance, adhesive ability and the compatibility with hot melt butyl sealant, and the ultraviolet irradiating resistance of the ig made by them
本文通過對比實驗，比較了摻油和未摻油中空玻璃密封膠的耐久性、熱老化性能、粘接性能以及與熱熔丁基密封膠的相容性，比較了其製造的中空玻璃的耐紫外輻照性能。As a rapid curing accelerator for natural and general synthetic rubber. also as a plasticizer for natural rubber to enhance its aging resistance
為天然及一般合成橡膠的快速硫化促進劑，對天然膠兼有增塑作用，可使製品具有較好的抗老化性能。For 2h, the osc and special surface area decreased sharply, meaning a bad thermal stability. the osc and special surface area of the samples prepared by precipitation keep very well after aged, exhibiting a promising thermal resistance. while the samples prepared by dipping method have a much more stable osc at different temperature, that is, they have a good thermal stability
研究表明，採用溶膠?凝膠法制備的樣品在老化前具有最大的儲氧量和比表面積，但經高溫老化后，其儲氧量急劇下降，表現出很差的抗高溫老化性能；採用沉澱法制備的樣品在老化前後，其儲氧量和比表面積降幅最小，有良好的高溫熱穩定性能；採用浸漬法制備的樣品不管老化與否，其儲氧量並不隨著儲氧溫度的改變而大起大落，表現出較好的熱穩定性。The chitosan / glycerol membrane has best properties with 8 % ( wt ) glycerol and fixed at 70 ? for 2 hours in a mixed fixation agent composed of ethanol, glycerol and sodium hydroxide
通過將殼聚糖和明膠共混，充分利用兩者的優點，達到生理功能的協同增效及物化性能的改善。Studies on physical and chemical properties of lignosulfonate from dahurian larch bark residue after extraction
落葉松栲膠廢渣木質素磺酸鹽理化性能的研究Effects of activator on the hydration properties of fly ash - cement binders
激發劑對粉煤灰水泥膠凝材料水化性能的影響Rubber, vulcanized or thermoplastic - determination of heat ageing properties
硫化或熱塑性橡膠.熱老化性能的測定Latest researches in fcc catalysts using silica sol as the binder were reviewed, including the properties, features and factors influencing on stability of silica sol
摘要介紹了以硅溶膠為粘結劑的催化裂化催化劑國內外研究現狀，以及硅溶膠的性能、特點和影響硅溶膠穩定性的因素。And reached the following specific conclusions : rubber content with the increase of resistance to ageing rubber modified asphalt increased ageing after less than for low - temperature service, the quality of reduced losses, soften point increase needle into a normal degree. summed up the aging asphalt and modified asphalt laws made spent rubber for asphalt modified agents, the principles of the size options and dosage of rubber powder for spent rubber modified asphalt road asphalt in the application provided a good technical support
得出了隨膠粉含量的增加膠粉改性瀝青的抗老化性能提高，老化后低溫延度比減小、質量損失量減小、軟化點提高，針入度呈正態分佈及改性瀝青老化的規律，提出了廢膠粉用作瀝青改性劑時粒徑選擇和摻量確定的原則，為廢膠粉改性瀝青在公路瀝青路面中的應用提供了良好的技術支持。In this paper, the property difference of sio2 sols used for preparing thin films by esam method or sol - gel process has been discussed. three kinds of sio2 sols were prepared, catalyzed by hcl or nh3 h2o only, or hcl first and then nh3 h2o respectively ( please note : in following text, the sio2 sol catalyzed by hc1 first and then nh3 h2o and its correspondent films will be named sio2 sol 1 # and film 1 ; the sio2 sol catalyzed by nh3 h2o only and its correspondent films will be named sio2 sol 2 # and film 2 # ). through investigating the assembling properties of the sols, observing thin films " microscopic structure with tem and testing their transmissivity with 721 spectrophotometer, we find that the first kind of sol is not suitable for preparing esam films, but the last two, i. e. sol 1 # and sol 2 #, are good
本文討論了esam法制備薄膜所用的溶膠與sol - gel法所用的溶膠在性能上的區別，在hc1或nh _ ? h _ 2o分別單獨催化和hc1 nh _ 3 ? h _ 2o分步催化三種催化條件下制備了sio _ 2溶膠（以下規定hc1 nh _ 3 ? h _ 2o分步催化的sio _ 2溶膠為1 ~ #溶膠，相應的薄膜為1 ~ #薄膜， nh _ 3 ? h _ 2o催化的sio _ 2溶膠為2 ~ #溶膠、相應的薄膜為2 ~ #薄膜） ，在通過組裝薄膜並用透射電鏡（ tem ）觀察薄膜微觀結構以及用721分光光度計測試樣品的光透射率，得出了后兩種催化方法所制備的溶膠適合於esam法鍍膜，而第一種溶膠不適于用此法鍍膜的結論，用傅立葉紅外光譜（ ft - ir ）研究了溶膠組成；用差熱失重分析儀（ dta - tg ）對膠體進行了熱分析。Results show that basic parameter can determinate content of c3s in steel - making slag powder ; however, it can not determine cementitious property of steel - making slag. cementitous property of steel - making slag powder is determined by mineral composition calculated from chemical composition and treating process, which means intrinsic cementitous property of steel - making slag is determined by total content of active mineral composition, c2s, c3s, c4af and c3a, and content of ca ( oh ) 2 marking loss of active mineral
研究結果表明，堿度僅能反映鋼渣中c _ 3s的含量，並不能完全反映鋼渣的膠凝性能；鋼渣的膠凝性能取決于由化學組成計算出的礦物組成及鋼渣的處理方式，即鋼渣中活性礦物c _ 2s 、 c _ 3s 、 c _ 4af及c _ 3a的總量及表徵活性損失礦物ca （ oh ） _ 2的量決定著鋼渣本身的膠凝性能。The thermal - oxidative - ageing property of nanocomposites was higher than that of carbon black reinforced rubber
納米復合材料的熱氧老化性能也明顯高於炭黑補強膠料的性能。Mechanical property, thermal - oxidative - ageing property, flame retardancy and dynamic mechanical analysis ( dma ) of nanocomposites have been studied, and a comparison between nanocomposites and carbon black reinforced rubber was made
研究了納米復合材料的力學性能、熱氧老化性能、阻燃性能和動態粘彈性等，並與炭黑補強膠料的一系列性能進行了比較。分享友人