膠合板表面 的英文怎麼說

中文拼音 [jiāogěbǎnbiǎomiàn]
膠合板表面 英文
face veneer
  • 膠 : Ⅰ名詞1 （某些具有黏性的物質） glue; gum 2 （橡膠） rubber 3 （姓氏） a surname Ⅱ動詞（用膠粘） st...
  • 合 : 合量詞（容量單位） ge, a unit of dry measure for grain （=1 decilitre）
  • 板 : Ⅰ名詞1 （片狀硬物體） board; plank; plate 2 （專指店鋪的門板） shutter 3 [音樂] （打拍子的樂器） ...
  • 表 : Ⅰ名詞1 （外面;外表） outside; surface; external 2 （中表親戚） the relationship between the child...
  • 面 : Ⅰ名詞1 （頭的前部; 臉） face 2 （物體的表面） surface; top 3 （外露的一層或正面） outside; the ri...
  • 表面 : surface; superficies; boundary; face; rind; sheet; skin; outside; appearance
  1. Tensile properties and impact properties measurements were done at room temperature. the volume resistivity of rectangular samples was measured using a zc36 electrometer and a high 240a voltage supply, for samples with a low resistivity level a dt - 9205b digital multimeter was used, silver paint was applied to ensure complete contact between sample and electrodes, namely, to eliminate the contact resistance. the phase morphology of blends was also studied using a jeol jsm - 5900lv scanning electron microscope ( sem )

    體積電阻率的測定：當r _ v 10 ~ 8時，製成100 100 4mm板材，用zc36型高阻儀測量；當r _ v 10 ~ 8時，用dt - 9205b型數字式萬用表測試試樣的體積電阻，為了減小接觸電阻對測試的影響，採用銀導電膠將銅片粘接在試樣的兩個端面上，靜置24小時，待銀導電膠凝固，試謝長瓊:熱拉仲對pet / pe / cb復合導電體系形態和性能的影響樣的電阻穩定后再測量。
  2. High-density plywood was used for all formed surfaces.

    對所有模板表面均使用了高密度的膠合板。
  3. 1, product uses : wall panels, ceiling panels, fire panels, waterproof panels, boxes, etc., can be substituted for wood plywood so qiangqun, doors and windows shutter panels, furniture, etc., as well as by the need to reconcile painting, water painting, and processed into various types of panels face and can be used for the basement, air and mine, moist environment works, but also with a variety of heat preservation material composite, manufactured composite food warming plate 2, product characteristics : bolivia has a magnesium plates withstand high temperatures, fire, acoustic vibration, waterproofing curing, pest control, light corrosion, drug - free tasteless clean, the paint can be directly with noodles, available gas nails, direct, tiles, surface better color

    1產品用途：墻板，吊頂板，防火板，防水板，包裝箱等，可替代木質膠合板做墻裙，門窗板門板，傢具等，也可根據需要做調和漆，清水漆，並可加工成各種類型的板面，同時可用於地下室，人防和礦井等潮濕環境的工程，還可以與多種保溫材料復合，製成復合保溫板材2產品特性：玻鎂板具有耐高溫阻燃吸聲防震防水防潮防蟲輕質防腐無毒無味無污染可直接上油漆，直接貼面，可用氣釘直接上瓷磚，表面有較好的著色性。
  4. Plaque is formed by pasting single plate and synthetic wooden single plate on veneer

    貼面板利用單板和人造木質單板貼在膠合板表面製成。
  5. The defect of rotary - veneer surface affects the quality of the wood - board panels products such as plywood, the computer vision system that forms using linear ccd gathers the image of veneer tape can be used automatic control and optimization of veneer tape cut out offer tech support

    摘要旋切單板表面的缺陷直接影響膠合板等人造板製品的質量，利用線陣ccd組成的計算機視覺系統採集單板帶的圖像，可為單板帶裁剪的優化和自動控制提供技術支持。
  6. However, the die attach layer delaminated after 500 cycles and pcb cracked in the underfilled samples after long time cycling. c - sam is employed to investigate the delamination in the underfilled samples. highly concentrated stress - strain induced by the cte mismatch between the bga component and the pcb board, coarsened grain and two kinds of intermetallic compounds ( nisn / nisns ) which formed during reflow and thermal cycle and their impact on the reliability of solder joints are discussed in this paper

    充膠樣品粗化尤為嚴重； ? ni - sn金屬間化合物包括兩層：其中，靠近ni焊盤的那層比較平整，同時， eds結果分析表明其化學式近似為nisn ，而靠近焊料的那層呈板條狀，化學式近似為nisn _ 3 ，文獻表明其為亞穩相； ?充膠使得樣品最大應力范圍降了接近一個數量級並降低了dnp的作用，同時，器件失效模式變為晶元粘接層分層； ? c - sam結果表明本論文採用的充膠樣品，晶元粘接層分層起始於500周左右，而經過2700周循環的樣品，分層幾乎擴展到整個界面。
  7. The floor of the game field is made of 20mm thick ply - wood, and is fully coated with emulsion paint

    場地的地板由20毫米厚的三合板構成，表面塗滿乳膠漆。
  8. The entire valve body and bonnet, inside and outside are fully coated with a fusion bonded epoxy that offers protection against corrosion and abrasion. the wedge is fully encapsulated with a vulcanized sbr or epdm rubber. all trims are made of stainless steel and copper alloy to prevent from polluting fluid medium

    閥門內外表面採用無毒環氧樹脂粉末塗敷，閘板全包耐蝕橡膠，其他與介質接觸的零件，均採用不銹鋼和銅合金製造，具有良好的抗蝕性能，不污染介質。
  9. And the value drop to the lowest at ph = 0. 8. as the increase of heat treatment temperature, the pore size distribution peak of sio2 microspheres is very narrow, meanwhile the specific surface area is the smallest before 160 c. the polymer template is removed at 350 c, so the pore structure of sio2 particles has a big change which involve the increase of specific surface area and the broaden of pore size distribution peak. with the continuous raise of temperature the sio2 network will shrink little, as a result the average pore size will decrease, but the specific surface area has no obvious change

    結果發現：二氧化硅膠體顆粒均勻分佈於脲醛聚合物網路中，煅燒去除有機模板后微球表面變粗糙，而粒徑沒有明顯變化； ph值較小時，復合微球中聚合物含量較大，而ph值較大時，得到復合微球結構鬆散，因此熱處理后的二氧化硅微球孔容及平均孔徑都較大，而在ph = 0 . 8時，得到最小值；武漢理工大學碩士學位論文隨著熱處理溫度的變化，小於160時，空分佈較窄，而比表面積較小，在350時，由於有機模板的去除，微球孔結構發生突變，比表面積明顯增大，而孔徑分佈變寬，溫度繼續升高時，二氧化硅網路發生收縮，平均孔徑變小而比表面積由於有機炭化物的完全去除沒有太大變化;微球中的微孔在熱處理過程中處于平衡狀態，分佈沒有太大變化。
  10. In the preparation of new antifriction layer, all component of antifriction layer are made into liquid antifriction adhesive that is sprayed evenly and quantitatively on the surface of decorative layer. by a series of processes, we can gain a new high antifriction layer with decorative function and high antifriction capability

    將耐磨層的所有組份按一定比例製成液體形態的耐磨膠，再將耐磨膠均勻、定量地噴塗于裝飾紙表面，經一系列工藝得到集裝飾效果與高耐磨性能於一體、成本很低的新型高耐磨復合強化地板。
  11. The smooth surface of the phenolic glue film faced plywood can smoothen the concerte ' s face, especially for the concrete construction with clean water

    粉醛覆膜膠合板表面光滑，能夠製作平滑的混凝土表面，特別適合現澆清水混凝土工程施工，使用后表面極佳。
  12. After mechanical and process properties testing, the results indicated that : ( 1 ) the film resin can make the properties good in climbing drum peer strength of sandwich constructions composite, the little effects of the film resin on other mechanical properties have been given ; ( 2 ) the sandwich composite has the better mechanical properties at central symmetry layer than asymmetric layer ; ( 3 ) through the study of the different pressure of the sandwich composite, the result is obtained that the edgewise properties increases, the flexural properties decreases with the pressure increase from 0. 2mpa to 0. 5mpa ; ( 4 ) at the sameness extend layer, the mechanical properties of the laminate is bigger than that of the honeycomb sandwich panel ; ( 5 ) through the studies on honeycomb sandwich plate delamination under three - point bending tests. it is found that the flexural strength decreases with the area of delamination increases

    研究表明： （ 1 ）膠膜能明顯的提高蜂窩夾層結構的剝離性能，對其它性能的影響不大； （ 2 ）對稱鋪層較非對稱鋪層的力學性能高； （ 3 ）固化壓力由0 . 3mpa提高至0 . 5mpa時，蜂窩夾層結構的側壓強度提高，而彎曲強度和剪切剛度分別降低； （ 4 ）蜂窩夾層結構中的面板較同樣材料鋪層的復合材料疊層板的力學性能低； （ 5 ）蜂窩夾層結構的界面上有缺陷時，彎曲強度下降，且隨著缺陷面積增大，彎曲強度下降幅度增大。
  13. As a consequence, in order to prepare core - shell particles with well - defined composition, morphology and properties, furthermore to obtain ordered advanced nanocomposite materials, the future research in nanoengineering of particle surfaces should focus on both optimization of the existing approaches and the development of new methods, make full use of the specific chemical and / or electrostatic interaction between colloidal templates and shell substance or its precursors

    指出利用膠體粒子模板表面與殼層物質或其前驅物間的特殊相互作用（包括靜電和化學相互作用） ，是完善現有制備方法和發展新方法來制備具有設定組成、結構和性能的核殼復合粒子的關鍵，同時也是將來的粒子表面納米工程和獲取有序的、先進的納米復合材料的主要方向。
  14. Plywood. classification by surface appearance. part 5 : methods for measuring and expressing characteristics and defects

    膠合板.表面狀況的分類.第5部分:測量方法和特徵及缺陷的表示
分享友人
分享到 Line

分享到臉書