自動時差電路 的英文怎麼說

中文拼音 [zìdòngshíchādiànlù]
自動時差電路 英文
automatic time difference circuit
  • 自 : Ⅰ代詞（自己） self; oneself; one s own Ⅱ副詞（自然;當然） certainly; of course; naturally; willin...
  • 時 : shí］Ⅰ名1 （比較長的一段時間）time; times; days:當時at that time; in those days; 古時 ancient tim...
  • 差 : 差Ⅰ名詞1 （不相同; 不相合） difference; dissimilarity 2 （差錯） mistake 3 [數學] （差數） differ...
  • 電 : Ⅰ名詞1 （有電荷存在和電荷變化的現象） electricity 2 （電報） telegram; cable Ⅱ動詞1 （觸電） give...
  • 路 : 1 （道路） road; way; path 2 （路程） journey; distance 3 （途徑; 門路） way; means 4 （條理） se...
  • 自動 : 1 （自己主動） voluntarily; of one s own accord 2 （不憑借人為的力量） automatic; spontaneous 3 ...
  • 時差 : 1 [天文學]（平太陽時和真太陽時的差）equation of time2 （不同時區之間的時間差別）time difference時...
  • 電路 : [訊] circuit （ckt）; electric circuit; electrocircuit電路板 circuit board; 電路保持 guard of a c...
  1. Abstract : a new clock - driven eco placement algorithm is presented for standard - cell layout design based on the table - lookup delay model. it considers useful clock skew information in the placement stage. it also modifies the positions of cells locally to make better preparation for the clock routing. experimental results show that with little influence to other circuit performance, the algorithm can improve permissible skew range distribution evidently

    文摘:提出了一種新的時鐘性能驅動的增量式布局演算法，它針對目前工業界較為流行的標準單元布局，應用查找表模型來計算延遲.由於在布局階段較早地考慮到時鐘信息，可以通過調整單元位置，更有利於后續的有用偏差時鐘布線和偏差優化問題.來自於工業界的測試用例結果表明，該演算法可以有效地改善合理偏差范圍的分佈，而對電路的其它性能影響很小
  2. Neural network control is an important mode of intelligent control, and it is widely used in branches of control science, first, the architecture and the learning rule ( error back propagation algorithm ) of multiplayered neural network which is widely used in control system are presentedo especially, the paper refers to the architecture of diagonal recurrent neural network and its learning algorithm - - - - - recurrent prediction error algorithm because of its faster convergence with low computing costo next, before introducing the neural network control to the double close loop dc driver system, the controllers of current and velocity loop are designed using engineering design approach after analysis of the system, simulation models of the system are created

    神經網路控制是智能控制的重要方式之一，它廣泛應用於自動控制學科各個領域。本文首先敘述了控制系統中常用的多層前饋網路結構及演算法（ bp演算法） ，特別提及了能夠較好描述系統動態性能的對角遞歸神經網路和在用遞推預報誤差演算法訓練drnn時取得了較快的收斂速度。其次，應用工程方法分析設計了tf - 1350糖分離機的電流、轉速雙閉環直流調速系統的控制器，作為引入神經網路控制的設計基礎，並建立了系統的模擬模型。
  3. The algorithm can not only eliminate the influence of the cumulative errors of the photoelectric code recorder, but also it can satisfy the requirement of the real - time control. a direct inverse model controller of fuzzy neural network with changeable structure based on takagi - sugeno inference is presented and it is used to the motion control of mobile robot. in order to avoid the obstacles successfully, detection results from ccd and ultrasonic sensors are fused by a fuzzy neural network, which acts as an avoidance controller

    包括移動機器人的融合自定位問題：移動機器人利用光電編碼器進行自定位，同時用擴展卡爾曼濾波器融合多個超聲波傳感器的測量值，採用回朔演算法將融合值用於復位光電編碼器，消除了光電編碼器累積誤差的影響，並能滿足實時控制的要求：並提出一種基於takagi - sugeno模型的變結構模糊神經網路直接逆模型控制器，並應用於移動機器人的運動控制；利用模糊神經網路避障控制器融合ccd攝象機與超聲波傳感器探測到的環境信息，以實現機器人的安全避障。
  4. Aiming at such problems in combustion system of homemade middle and miniature boiler, as a complex system with the character of dead zone, time variation, serious non - linearity, large time delay, coupling and a lot of disturbance, this paper presents a new set of optimal control resources. by using well - matched control method on system, stable automatic running is realized. having the serious divulgence coals difference a lot from each other in character, instability of chemistry, value of lowest emission of heat, home - made boiler controller is not at all ideal. instead of traditional model that controls the ratio based on proportional control or with the correct signal of the amount of oxygen, this paper, combined with intellect control theory - - fuzzy control and self - optimizing concept, propounded a kind of fuzzy self - optimizing controller to be used in air supplying system of the boiler, and expatiates on the idea of dividing the control process into two parts, dynamic and static to realize, thus meets the demand of homemade boiler economic running

    本設計針對國產中、小型電站鍋爐燃燒系統參數時變、嚴重非線性、干擾因素復雜、耦合嚴重、模型不易確定的特點，提出多變量協調控制方案，解決了系統可控性差，難以實現穩定自動運行的問題；在此基礎上，改變以往以煙氣含氧量控制送風的傳統模式，針對國產電站鍋爐設備主體及一、二次送風迴路泄露嚴重，煤種混雜、成分不穩定、燃燒發熱值低、燃燒效率不高等問題，應用智能控制理論中的模糊控制技術，結合自尋最優控制的思想，設計了一種模糊自尋優控制器，應用在電站鍋爐送風控制系統上，並闡述了動靜態兩種實現途徑，通過在線優化風煤配比，實現最佳經濟燃燒，切實保障了鍋爐的經濟運行。
  5. Directional solidified cu - cr in - situ composites have high strength, high electricity but without such problems of interfacial contamination and low stability as in the conventional man - made synthetic composites due to self - driven engender in the process of directional solidification, so this composites are expected to be used as contact cable, which is made for trunk line electrification

    定向凝固cu - cr自生復合材料由於具有高強度、高導電性，同時因其在凝固過程中自動形成而避免了人工復合材料中長期存在的界面污染、穩定性差等不足，因而在電氣化鐵路用電車線材方面有廣闊的應用前景。
  6. Automatic time difference circuit

    自動時差電路
  7. According to the requirements to pd pattern auto - recognition, this paper studies systematically the basic theories and realizable methods for auto - recognition of pd gray intensity image : ( 1 ) in the requirement of on - line pd monitoring for transformer, several discharge models are designed and the relevant experiment methods projected. with discharge model tests, a lot of discharge sample data is acquired. on the base of systematical research on recognition for pd gray intensity image, this paper puts forward two kinds of fractal features, the 2nd generalized dimensions of original pd images and fractal dimensions of high gray intensity pd images, and then the relevant extraction methods

    針對局部放電模式自動識別的需要，作者系統地研究了局部放電灰度圖像自動識別中的基本理論和實現方法： （ 1 ）根據變壓器局部放電在線監測的要求，設計了放電模型和實驗方法，並通過模型實驗獲得了大量放電樣本數據，為構造局部放電灰度圖像和採用bpnn進行識別作好準備； （ 2 ）研究了局部放電灰度圖像的構造方法以及降維構造32 32灰度和矩陣的方法；在用人工神經網路對局部放電進行模式識別時，分析了bp網路的優缺點，對典型bp網路的結構和學習訓練演算法提出了改進，採用帶有偏差單元的遞歸神經網路作為模式分類器；採用32 32灰度和矩陣進行bpnn識別結果表明這種方法是有效的。
  8. The real - time automatic gain control makes full use of the delay feature of signal channel, and controls the synchronization of adc precisely, and adjusts the signal gain in real - time, and compensates the error in digital domain, at last, this kind of technology expands the dynamic range of system adc

    採用的實時自動增益控制電路利用信號通路的延遲特性，精確控制模數轉換器同步，實時調整信號增益，在數字域補償誤差，擴展系統動態范圍。
  9. Moreover, video control program to implement internal function of fpga is designed including video capture time sequence control, ping - pang frame buffer read and write time sequence control and lcd display time sequence control, and program ' s simulation and analysis is also provided. at last, this paper presents a portable iv ' s video processing system, and proposes three buffer strategy to control capture buffer. and a moving object detection algorithm of combing an adaptive background subtraction technique with a three - frame differencing is adopted

    設計了基於fpga系統結構的車載視頻顯示電路板；利用單片機io口模擬i2c時序，實現了視頻解碼晶元控制；利用fpga實現視頻控制，研究了採集通道時序控制、雙幀存ram讀寫時序控制及lcd顯示時序控制的方法，並進行了軟體模擬和分析；設計了車載視頻檢測系統方案，給出了管理採集緩沖區的三幀緩沖策略，採用綜合三幀差分和自適應背景相減的演算法實現運動檢測，連通體檢測去除虛目標，模擬實驗證明其有效性，同時分析了該演算法在dsp視頻檢測系統中的簡單實現方法。
  10. The latter primarily improves the transmission distance and reliability by selecting the repeater automatically. the frequency domain auto - adaptatation filter algorithm is deduced and reliabity by selecting the repeater automatically. the frequency domain auto - adaptaion filter algorithm is deduced and a method of frequency domain algorithm to restrain the marrow band interference is given on the foundation of the time domain minimum mean square error auto - adaptation filter. then the meter reading system to can learn the power network structure and automatically create linked path by using neural networks auto - study ability and analyzing the reading data

    後者主要是對中繼節點的自動選擇，以提高信息的傳輸距離與可靠性。針對電力線擴頻通信通道的特點，在時域最小均方誤差自適應濾波演算法的基礎上，推導了頻域自適應濾波演算法，並提出了頻域演算法抑制窄帶干擾的具體方法。運用神經網路的自學習方法，通過對抄讀數據進行分析，使抄表系統感知電網拓撲結構，自動建立中繼路徑。
  11. The differential protection is locked when switching the current and voltage, and the misoperation of differential protection is reduced

    在電流、電壓迴路切換時自動閉鎖差動保護，減少了保護誤動的機率。
  12. Abstract : the thesis discusses the causes of measurement errors in auto - capactity measuring instrument circuit and introduces several effective methods to minimize measurement errors

    文摘:本文就自動電容測量儀電路造成測量誤差的原因進行了討論，同時介紹了減小測量誤差的幾種有效方法。
分享友人
分享到 Line

分享到臉書