自校正系統 的英文怎麼說

中文拼音 [zìjiàozhēngxìtǒng]
自校正系統 英文
self correcting system
  • 自 : Ⅰ代詞（自己） self; oneself; one s own Ⅱ副詞（自然;當然） certainly; of course; naturally; willin...
  • 校 : 校名詞1. （學校） school 2. （校官） field officer3. （姓氏） a surname
  • 正 : 正名詞（正月） the first month of the lunar year; the first moon
  • 系 : 系動詞（打結; 扣） tie; fasten; do up; button up
  • 統 : Ⅰ名詞1 （事物間連續的關系） interconnected system 2 （衣服等的筒狀部分） any tube shaped part of ...
  • 校正 : check; correction; adjust; revise; proofread and correct; rectify; calibrate; make true; master c...
  • 系統 : 1. （按一定關系組成的同類事物） system 2. （有條理的;有系統的） systematic
  1. A generalized minium variance pole assignment pid self - tuning controller can be used for the system with gentle time - varying delay. the controller algorithm is simplified. its effectiveness has been shown in many simulation uses

    在考慮系統時滯特性的情況下，提出了適合一類時滯系統的廣義最小方差極點配置自校正控制器，並對控制器演算法進行了簡化，使該控制器簡單易行，適應性強，模擬結果表明它的有效性。
  2. On the part of the design of nine - component thrust vector stand, an automatic hydraulic pressure original position calibration system, a scheme of original position calibration, and the great rigidity universal flexible combinatorial underprop are designed. by using the scheme of “ universal flexible combinatorial underprop plus software digital filter ”, the inherent frequency of test stand is improved, and the problem of test stand libration is solved. then, the resolving method of the disturbance between underprops of the moveable frame is proposed, and the disturbance revise equation is deduced

    在推力矢量試車臺設計方面，設計了自動液壓原位校準系統、原位校準方案以及大剛度萬向柔性組合支撐;採用「萬向柔性組合支撐+軟體數字濾波」的方案，提高了試車臺動架的固有頻率，解決了試車臺動架的振動問題;提出了動架約束互擾問題的解決方法，推導了互擾修正方程;研究了九分力推力矢量測量誤差分析方法，並計算了推力矢量測量精度。
  3. The method of adjusting parameter of fuzzy control automatically is introduced into two - stage vibration isolation, and the scaling gains are revised online

    將參數自校正模糊控制方法引入雙層隔振系統，通過在線整定量化因子。
  4. We have advanced equipments in the world, whole set apparatus made in german, special tools used in jatta and audi vehicles, advanced testers, wrong readers, launch tester, inner peeper, advanced repairing machines, automatic lift shaft, wheel balancer and italy automatic lacquer baker, computer print reached ministry standard

    義大利全自動烤漆房，全自動電腦調漆設備，義大利全自動輪胎平衡機，全自動輪胎安拆機義大利吊裝起重設備加拿大車身校正系統汽車電能試驗器廢氣分析儀電腦故障閱讀器空調系統冷媒測漏儀abs測試儀噴射測試儀機油壓力測試儀等。
  5. An indirect self - adaptive fuzzy - neural network controller ( fnnc ) has been proposed with its parameters and the structure tuned simultaneously by ga in virtue of the powerful optimization property of ga. the structure of the controller is based on the radical basis function ( rbf ) neural network with gaussian membership functions. the performance of the proposed fnnc is compared with a conventional fuzzy - pid controller and the simulation results show that the fnnc presents encouraging advantages

    針對神經網路採用一維反向傳播訓練演算法速度較慢且易於陷入局部極小點的不足，設計了一種間接自校正模糊神經網路控制系統，利用遺傳演算法（ ca ）對隸屬度函數的結構和參數進行優化，模擬比較表明該控制比模糊pid控制具有更優的性能。
  6. In this paper, we derive predictive models of system and auxiliary system from double constant alterations respectively. the controller based on d - step ahead predictor can locate the closed loop poles at desired positions, whose parameters are adjusted by estimations of plant parameters that are separately estimated. an auxiliary estimator is developed to avoid ill - condition in solving diophantine equation. simulations show that these control systems have better dynamic responses under existence of measurable disturbance

    引入雙恆等變換推導出系統及輔助系統的的d步預測模型，基於估計器的自校正控制器能將閉環極點配置在所希望的位置，它的參數是由與其相互獨立的對象參數調節.提出使用輔助估計器克服丟番方程的病態問題.模擬表明在存在可測干擾的情況下該系統具有良好的動態性能
  7. Abstract : in this paper, we derive predictive models of system and auxiliary system from double constant alterations respectively. the controller based on d - step ahead predictor can locate the closed loop poles at desired positions, whose parameters are adjusted by estimations of plant parameters that are separately estimated. an auxiliary estimator is developed to avoid ill - condition in solving diophantine equation. simulations show that these control systems have better dynamic responses under existence of measurable disturbance

    文摘:引入雙恆等變換推導出系統及輔助系統的的d步預測模型，基於估計器的自校正控制器能將閉環極點配置在所希望的位置，它的參數是由與其相互獨立的對象參數調節.提出使用輔助估計器克服丟番方程的病態問題.模擬表明在存在可測干擾的情況下該系統具有良好的動態性能
  8. When unknown and bounded disturbance, parametric uncertainties and unmodelled dynamics exit at the same time, the system will automatically tune regulator parameters so as to guarantee robustness of speed synchronized control system and achieve indirectly position synchronized control

    對未知有界擾動、參數變化和未建模動態採用h _魯棒自校正調節器控制，可根據環境與特性變化自動整定調節器參數，有效抑制擾動、參數變化和未建模動態對系統同步性能的影響。
  9. And this algorithms have been proved to be valid by computer analogize for two different model. after a detailed analysis of the glass furnace, put award a method of disassemble multivariable control : the upper levels use fuzzy supervise control, provide reference signal for lower level ; the lower level select and use a modified self - regulating fuzzy controller or a double closed - loop controller for time - sluggish system

    在分析窯爐特性的基礎上，以溫度系統為例，根據其被控參數多、大滯后、非線性等特點，提出分層分區的智能控制策略：上層採用模糊監督控制器，為下層提供參考信息，下層根據控制要求及被控對象特性分別採用了一種改進的自校正控制演算法和一種適合於滯后過程的雙環模糊控制器。
  10. Then, as the substitute of the traditional pi controller, neuron adaptive psd controller is used to alternate the velocity loop of dc driver system, simulation results show that the super - shoot in new system is small and the performance in the way of anti - disturbance and anti - time - varying parameters are higher than the traditional pi controller and robustness of the dc driver system improved greatly, in addition, through analysis of the character of the neuron adaptive psd controller, the paper presents a neural network self - tuning control method for dc driver system in which the diagonal recurrent neural network is used to identify the plant to calculate the plant ' s sensitivity for psd controllers simulation results indicate that excellent static dynamic target was got with this control method and the performance of the system is improved greatly,

    然後，應用單神經元自適應psd控制器改造調速系統的轉速環，代替傳統pi調節方式的轉速控制器。模擬表明，新系統在超調、抗負載擾動和參數時變方面性能優于的傳統的pi控制方式，系統的魯棒性增強。在分析單神經元自適應psd控制器特性后，本文提出用對角遞歸神經網路辯識控制對象，為psd控制器提供靈敏度參數，從而構成一神經網路自校正控制方案。
  11. A checksum system is used for each piece. when you specify the 4 edges correctly, it ' s border will turn from red to green

    有一個校驗系統自動對每一個方格進行檢查。當您把每個方格的顏色配置正確后，方格的邊界線將由紅色變為綠色。
  12. To reappear stochastic waveform on esvrst in time field, the minimum variance implicit self - tuning regulators of siso and mimo systems are deduced based on carma models in this paper. the robustness of the regulator being used to control esvrst is validated good

    本文推導了在時域內對電液伺服道路模擬試驗臺進行隨機波形再現控制時，基於carma模型的，單輸入單輸出系統和多輸入多輸出系統的，隱式最小方差自校正調節器。
  13. One dimension river flow roughness parameter inverse analysis kalman filter is introduced into the model to solve stochastic error in observed data. applying kalman filter automatism revising system, dynamic roughness course is obtained. using dynamic roughness course the model result precision is improved, it is more consistent with observed data

    對於一維河道糙率參數反分析，針對觀測資料存在的隨機誤差，引進卡爾曼濾波器的自動校正系統，求解出河道糙率變化的動態過程，使用動態糙率計算，明顯改善模型的模擬精度，使模擬過程和觀測過程很好吻合。
  14. R. d. lorenz and d. b lawson, " performance of feedforward current regulators for field - oriented induction machine controllers ” ieee trans. ia, vol. 23, no. 4, 1987

    吳捷，姜智堅.感應電機調速系統新型滑動模解耦與自校正控制.中國電機工程學報1999 （ 1 ）
  15. Finally, stc structure is used to form a composite neural networks adaptive control system of temperature and ga is also applied to train nn controller

    最後，應用自校正控制結構組成復合神經網路自適應溫度控制系統，並對神經網路控制器進行了訓練。
  16. The thesis finished a sample instrument used in measurement node. it is based on 8 - bit micro controller unit and has smart functions including auto calibration, auto scale change and auto balance of whetstone bridge. the data can be processed, stored, transferred and displayed in the sample device

    本文完成了測試系統中基於16位微處理器的網關的硬體架構和軟體實時多任務內核的設計；研製了基於8位微處理器的具有自校正、自動量程轉換及測試電橋的自動調平功能的測試節點樣機；實現了測試節點的數據處理、存儲、顯示和傳送；繪制並編寫了測試節點的硬體電路圖和軟體源程序。
  17. Unified self - tuning wiener state estimators are presented, which can handle the state filtering, smoothing and prediction problems in a unified framework, and their applications to the self - tuning tracking filters are given

    提出了統一的自校正wiener狀態估值器，它可統一處理系統狀態的濾波、平滑和預報問題，並給出了在自校正跟蹤濾波器中的應用。
  18. Application to parameters of pid control based on genetic algorithm

    電弧爐電極調節系統的自校正控制
  19. The parameters estimation with the least square method is applied to the open speed system. the least square estimation with forgetting factor and the least square error self - tuning control are applied to the close speed system and controller parameters arc obtained from estimation parameters directly

    採用最小二乘參數估計演算法對某渦扇發動機低壓轉速進行開環辨識，採用帶遺忘因子的最小二乘估和直接獲得控制器參數的自校正控制對該系統進行閉環控制。
  20. Based on compensation control thought, through using neural network pid controller as compensation tache of traditional pid controller, a kind of hybrid pid controller is designed. combined with neural network, self - tuning control can realized better control over non - linear system. utilizing the advantages of fuzzy control and neural network control, a kind of neural network adaptive fuzzy controller based on fast bp algorithm is presented and it may control the plant on line. at last, the hybrid pid controller is applied in tension system of h - section continuous rolling mills and tension - free control is realized. the simulation results show that it has better performance than traditional pid controller. at the same time, it provides some reference for the control of other similar systems

    在此基礎上，基於補償控制思想，利用神經pid對傳統pid進行補償，設計了一種混合pid控制器；神經網路與自校正控制的結合，使得自校正方法能對非線性系統實現比較理想的控制效果；利用模糊控制與神經網路控制各自的優點，提出了一種基於快速bp演算法的神經網路自適應模糊控制器，能夠對系統進行在線控制。最後將混合pid控制應用於h型鋼連軋機張力系統中，實現微張力控制，模擬結果說明其較傳統pid具有更好的性能，同時也為其它類似系統的控制提供一些參考。
分享友人
分享到 Line

分享到臉書