臺站誤差 的英文怎麼說

中文拼音 [táizhànchā]
臺站誤差 英文
station error
  • : 臺名詞(指臺州) short for taizhou (in zhejiang province)
  • : Ⅰ動詞1 (站立) stand; be on one s feet 2 (停下來; 停留) stop; halt; pause Ⅱ名詞1 (停車點) st...
  • : Ⅰ名詞(錯誤) mistake; error Ⅱ動詞1 (弄錯) mistake; misunderstand 2 (耽誤) miss 3 (使受損害...
  • : 差Ⅰ名詞1 (不相同; 不相合) difference; dissimilarity 2 (差錯) mistake 3 [數學] (差數) differ...
  • 誤差 : error
  1. Network errors - by - station ( ethernet, token ring, fddi, and frame relay )

    的網路(以太網、令牌網、
  2. The result has the reference significance for choosing geoelectric observation location and observation data error correction

    分析結果對地電觀測選址、及其觀測數據校正具有參考價值。
  3. This mode allows you to pinpoint errors by the sending station and the type of error

    此模式通過發送類型,支持查明
  4. In this dissertation, we studied the tcra1101plus total station position system, which introduced the principle and characters of the instrument ' s closed loop tracking system. also we explained the cause of prism ' s position error and brought forward mathematic model to correct, moreover, the good results has been drawn form the expenriments. the kinetic survey system have been realized, which the sampling rate attain more than 5hz and the position precision can be less than 2mm on condition that targeted - point moving slowly at the velocity below 2cm / s. having finished the survey system to examine whether the fine - tuning stewart platform in good status, we have finished mensurating the position reference of the fine - tuning stewart platform and the offset of the prism

    在此基礎上研製了多儀器在線控制高頻采樣動態跟蹤測量系統,采樣率大於5hz ,在跟蹤小於2cm / s低速運動目標時,測量精度好於2mm ;完成對饋源二次精調系統的檢測,包括對二次精調平位置基準的標定和觀測棱鏡偏心的測定;設計不同動態測量實驗,對全儀動態跟蹤的來源和特點進行了分析;從實驗角度,對全儀的測量時滯及其穩定性進行了測試分析,給出了定量的結果;比較了全儀和計算機的內部時間系統,發現兩者存在較大異。
  5. Error rates are also displayed for gauging severity of the error stream from a particular station

    還可以顯示率,用於測量特定臺站誤差流的嚴重性。
  6. Network station error statistics displays ethernet, token ring, and fddi errors broken down by station

    網路臺站誤差統計按照顯示以太網、令牌網和
  7. At first, by using the feature that the excess delays of nlos propagation follow the exponential distribution, the los propagation parameters are reconstructed and the toa parameters measured from all bs are preprocessed. then, the ms ' s position is estimated by the los locating algorithm with the preprocessed data. finally, to mitigate the effect of the errors in reconstructed parameters, the estimated results are smoothed

    首先,利用非視距傳播時延服從指數分佈的特點,對不同基一次測量的數據進行預處理,重構視距傳輸參量;然後,對處理后的數據採用視距定位演算法估計移動位置;最後,對估計結果進行平滑后處理,以減小重構出的參量的影響,進一步提高定位精度。
分享友人