荷電率補償 的英文怎麼說

中文拼音 [hédiànlǜbǔcháng]
荷電率補償 英文
complement of chargeability
  • 荷 : 荷名詞（蓮） lotus
  • 電 : Ⅰ名詞1 （有電荷存在和電荷變化的現象） electricity 2 （電報） telegram; cable Ⅱ動詞1 （觸電） give...
  • 率 : 率名詞（比值） rate; ratio; proportion
  • 補 : Ⅰ動詞1 （修理; 修補） repair; mend; patch 2 （補充; 補足;填補） fill up; add supplement; supply; ...
  • 償 : 動詞1. （歸還; 抵補） repay; compensate for 2. （滿足） meet; fulfil
  • 補償 : compensate; make up; make up for; make it up to sb. ; make sth. good; compensation; offset
  1. First from system aspect, this paper uses voltage sensitivity, pv curves method, equivalent reactive compensation method, back - up generation method to evaluate the reactive value of the generators in seven buses system and ieee 14 buses system. the vs and pv methods can evaluate the source ' s ability of tracking the load ' s variation. the erc and back - up methods can evaluate the availability of replacing other generators. the value determines the cost

    從對系統貢獻角度，採用電壓靈敏度方法（ vs法） 、 pv曲線法、等效無功補償法（ erc ） 、無功備用方法來確定一個七節點系統中的發電機的無功價值和ieee14節點系統的發電機的無功價值，電壓靈敏度法和pv曲線法可比較出不同電源跟蹤負荷變化的靈敏度大小，而等效無功補償法和無功備用方法可比較出不同電源替換其它發電機是否是最有效率的。
  2. On the base of widely investigating and researching, author deems that the conventional reactive power compensation devices used by consumer had many defects with among others : lower response time, remaining residual voltage on the compensation capacitors, and so on. because of existing improper trigging time, it is impossible to realizing balance compensation for 3 - phrase unbalance loads

    本文在充分調研的基礎上，認為目前採用的傳統的無功功率補償裝置存在響應速度慢、觸發時刻不合適、補償電容器上有殘壓、不能實行三相平衡補償、對電網產生污染、不能消除負荷本身產生的高次諧波等弊病。
  3. Now the affect and the measure of hypo _ harmonics is in the research. the influence of negative sequence is almost eliminated along with the enlargement of the system ' s capacity and the alternate connection of traction substations. the fixed parallel compensate equipment applied in traction substations consist of a constant capacitor and a constant inductance, so its output is constant

    負序電流的問題已經因系統容量的增大、牽引變電所採用輪換接線方式而基本解決，電力部門實行的「反轉正計」 ，使採用對無功功率固定補償方式由於牽引負荷變化頻繁而出現補償容量不足或過補償現象，難以達到滿意效果。
  4. The main product instant no power but automatic compensating controlling device is especially applicable to the places, where the instant charge changes acutely and continually, and this product has got state patent and the quality and technical indexes are one - up level of our country in the same products, and it has been recognized as energy - economizing product by china energy - economizing association and it has won the award of excellent technological product of international technology management association and it has been added to 1 net of china petroleum energy

    主要產品瞬時無功功率自動補償控制裝置，特別適用於瞬時負荷變化大而頻繁的用電場所，該產品已獲國家專利，在同類產品中質量及技術指標處于國內領先水平，被中國節能協會認證為「節能適用產品」 ，榮獲國際科技管理協會「優秀科技產品」獎，已加入中國石油能源一號網。
  5. To make pic ( particl - in - cell ) simulations. to set up models of guns and magnetic field and simulate them in the vacuum and plasma, respectively. we found that plasma held back part of space charge effects and improved trajectory of electrons. but beam would oscillate and became instable as accretion of plasma density. by simulating again and again, we draw a conclusion magic could n ' t work when plasma density was more by far than beam electron density. at last a four - stage depressed collector was simulated

    建立電子槍和聚焦系統模擬模型，分別在真空和填充等離子體條件下進行模擬。發現填充等離子體能補償部分空間電荷效應，改善電子束包絡軌跡，提高電子的流通率，但是隨著等離子體密度的增大，束電子會出現振蕩不穩定性，遺憾的是通過反復多次模擬發現本文所用粒子模擬的代表性軟體magic無法用於模擬等離子體密度遠高於束電子密度的情況。
  6. The reactive power optimization compensation is to find the suitable compensation place and the best compensation capacitance by adjusting the generator bus voltages, transform taps and reactive compensation capacities in the condition of satisfying power load requirement, which can guarantee the secure and high quality power for consumers. the improved genetic algorithm is applied in this thesis according to the features of reactive power optimization of high voltage transmission bus, which are the non - linear problems with multi - variables and multi - restrictions

    電網無功優化補償是在有功潮流調度給定的情況下，以負荷節點電壓和線路輸送無功功率作為狀態變量，運用優化演算法，調節發電機節點電壓、變壓器可調分接頭和無功補償裝置，在滿足電力負荷的要求下，尋求合理的無功補償點和最佳補償容量，保證電網能夠安全、優質地向用戶供電。
  7. If we compensate the pump station with lower power numbers for electric power and electric capacity, we can reduce the current load in the power source and the lines

    對已建成的功率因數偏低的泵站採用電力電容補償，可減少電源和線路的電流負荷。
  8. The magnitude of the conductivity maximum increases and shifts to lower temperature with increasing sr content. in this paper, the electrical conductivity reaches maximum value at x = 0. 4. below the temperature corresponding to the maximum value, the electrical conductivity is found to follow the relationship for the small polaron hopping mechanism, charge compensation of oxygen vacancy dominates electrical conduction at high temperature, and oxygen vacancy acts as traps to catch carriers, resulting in the decrease of carriers concentration and mobility

    通過電學和熱學性能測試結果表明，電導率隨著sr含量的增加以及溫度的變化都出現了極大值，在本論文中，在sr含量為0 . 4時電導率值最大，電導率最大值對應的溫度隨著sr含量的增加而降低，這是由於在低溫下以小極化子導電機理為主，在高溫階段則是氧空位的電荷補償占據主導作用，氧空位使得載流子的濃度和可動性減弱，從而導致電導率降低。
  9. The combined motor vibration sensor which is held manually with double charge amplifier placed inside and with frequency compensating circuit is designed based on the existed press - electricity accelerator of vibration and the measuring vibration system of charge amplifier in the paper

    本文在現有振動壓電式加速度計、電荷放大器測振系統的基礎上，設計了手持式內置微型雙電荷放大器和頻率補償電路的一體化發動機振動傳感器。
  10. Finally, how the pwm - fcl contributes to the system stability, three - phase load unsymmetry and the transmission capacity is discussed. and how to decide a reasonable compensation rate of the pwm - fcl is also proposed

    最後討論了pwm - fcl對系統穩定、三相負荷不平衡的作用以及它對輸電線路功率傳送能力的影響，並說明在設置其補償度時所應該考慮的問題。
  11. This article emphatically discussed and analyzed following points : load command feed forward function can improve the rapid respond character of steam turbine generator ; lead of load command have advance control function on boiler main control and can highly improve the stability of main steam pressure ; the use of predict control and state space variable function can improve the quality of boiler steam temperature control effectively, control the steam temperature in the defined range and increase the boiler and turbine life and efficiency even if working state changed in a big range ; linear compensation can restrain the vibration of generator load in the condition of big loa d change

    本文重點討論、分析提出負荷指令前饋作用可以提高汽輪發電機快速響應特性；負荷指令的導前功能對鍋爐主控有超前控製作用，能顯著提高主蒸汽壓力的穩定性；採用預測及狀態空間法能有效改進鍋爐蒸汽溫度控製品質，在大幅度工況變化下仍有效控制蒸汽溫度在額定范圍內，提高鍋爐、汽輪機壽命及其效率；汽輪發電機組的快速響應性與汽輪發電機組負荷振蕩問題間的平衡關系，採用線性補償可以有效抑制在負荷變化梯度較大情況下發電機負荷振蕩問題。
  12. The design method of the double charge amplifier are worked out based on the requirement of the sensor for testing circuit and the effect of sensor for work environment, the method of compensation of the frequency being extended is studied, and the butterworth filter of five order which is adapted itself is designed creatively by the isppac in chapter three

    第三章從敏感元件對測量電路的要求和工作環境的影響出發，提出了雙電荷放大器的設計方案，研究了頻率拓寬補償的方法，使用isppac創新設計了自適應butterworth5階低通濾波器。
  13. According to the characteristic of nine - area diagram of substation vol / var coordinated control, this system gives the defination of fuzzy sets and the degree of membership of input / output variables, and designs corresponding control rules. the results of simulation demonstrate the system can satisfy the constrains of the day - adjusting times of the switching of on - load transformer and paralleled compensation capacitors, and ensure voltage quality, reactive power basical balance. considering the var requirement in different load time period and the control demand in load saltation, a improved control scheme is provided. the results of simulation show the improved scheme can meet the demand of vol / var in different load time period, protect the wrong operation when either voltage or reactive power appears saltation, and decrease the times of regulation of the switching of on - load transformer and paralleled compensation capacitors finally, a background software module of substation vol / var coordinated control is designed, based on the supervisory control and data acquisition system of substation

    模擬結果證明該系統能在各種負荷條件下確保電壓合格和無功基本平衡，且能滿足變電站對有載調壓變壓器分接頭日調節次數和並聯補償電容器組的日投切次數的限制。通過考慮不同負荷時段對無功功率的需求和負荷突變情況下的控制要求，對上述模糊控制策略進行了改進，模擬結果證明改進后的控制策略能滿足不同負荷時段對電壓和無功的要求、抑制電壓或無功突變情況下的誤動作，且有效地減少了有載調壓變壓器分接頭和並聯補償電容器組的調節次數。最後基於變電站scada系統設計了一后臺電壓無功綜合控制軟體模塊。
  14. The filed test was made in guangping substation of handan power supply company and the results of filed test indicated that the device is successful and it improved the voltage quality and power factor at various load condition

    該裝置在邯鄲供電公司廣平變電所進行了現場實驗，實驗結果表明，它可以在各種不同負荷狀況下，自動進行並聯補償電容器的投切和主變分接頭的控制，提高了電壓合格率和功率因數。
  15. Based on the strategy the automatic voltage and reactive power control device was developed. the device is controlled by microcomputer and can adjust the ratio of transformer and switch the capacitor automatically according to operating condition

    在此基礎上，研製成功了變電所電壓無功自動控制裝置，裝置以微處理器為控制核心，可根據實測的母線電壓和負荷功率因數，自動進行主變分接頭調整和補償電容器投切。
分享友人
分享到 Line

分享到臉書