蒸氣壓縮過程 的英文怎麼說

中文拼音 [zhēngqìyāsuōguòchéng]
蒸氣壓縮過程 英文
vapor compression process
  • 蒸 : Ⅰ動詞1. （蒸發） evaporate2. （利用水蒸氣的熱力使食物熟或熱） steam Ⅱ名詞[中醫] （將藥物隔水蒸熟） steaming
  • 氣 : Ⅰ名詞1 （氣體） gas 2 （空氣） air 3 （氣息） breath 4 （自然界冷熱陰晴等現象） weather 5 （氣味...
  • 壓 : 壓構詞成分。
  • 縮 : 縮構詞成分。
  • 過 : 過Ⅰ動詞[口語] （超越） go beyond the limit; undue; excessiveⅡ名詞（姓氏） a surname
  • 程 : 名詞1 （規章; 法式） rule; regulation 2 （進度; 程序） order; procedure 3 （路途; 一段路） journe...
  • 蒸氣 : steam; vapour蒸氣供暖 steam heating; 蒸氣管 steam pipe; 蒸氣管道 steam pipeline; 蒸氣渦輪機 steam...
  • 過程 : process; procedure; transversion; plication; course
  1. Analysis is made on structure characteristics of the finned - tube, and analysis has been made on the special heat and mass transfer principle of every micro - unit under both dry and wet conditions. appropriate hypothesis is made and based on the energy, mass and momentum equivalent, the evaporator models of dynamic distributed parameters are set up. in addition, the gascooler and internal exchanger models of dynamic and distributed parameters, the throttling valve models and the compressor models are set up, too

    本文的內容如下： 1對翅片管蒸發器的結構特點進行分析，選取適當的微元體，對于干、濕工況下每個微元分別進行傳熱傳質分析，通過適當的假設，利用質量守恆方程、能量守恆方程和動量守恆方程建立了蒸發器的分佈參數數學模型；對回熱器劃分微元建立了分佈參數數學模型；對氣體冷卻器建立了分佈參數數學模型；對壓縮機建立了數學模型；建立了節流閥的數學模型，為系統模擬奠定了基礎。
  2. The air thermal cnergy water heater creates the new generation hot water cquipments. it makes use of the negative card promise successfully, drieing a hot pump with the elcctrie power. equiping through a hot pump medium of compesing parts evaporate a machine. hot pump, congealed machine and inflate valve, urge the work quality completes evaporationt absorb calories within air continuously compress compress congealed reduce expenses evaporate of the thermody name energy cirenlation proess, transfer the calories in the environment to the water thus in, transfer the in great quantities free calories in the air to the life to use a water in

    空氣節能熱水器是創新一代熱水設備，它成功地運用逆卡諾原理，用電能驅動熱泵，通過熱泵裝置中的構成部件-蒸發器，熱泵，冷凝器和膨脹閥，促使工質不斷完成蒸發（吸收空氣中的熱量）壓縮冷凝節流蒸發的熱力循環過程，從而環境的熱量轉移到水中，將空氣中大量免費的熱量轉移到生活中水中
  3. Thermodynamic analysis on wet compression process is done in this thesis and studies are done on ideal wet compression process, actual wet compression process, water droplet evaporative rate, wet compression work, inlet evaporative cooling, wet compression efficiencies and water droplet breaking. and thermodynamic model of wet compression process is established, which gives out rules of and methods to calculate wet compression parameters

    本文從熱力學的角度對濕壓縮過程進行了分析，分別對理想濕壓縮過程、實際濕壓縮過程、水滴的蒸發速率、濕壓縮功、進氣蒸發冷卻、濕壓縮效率和水滴的破碎等進行了研究，建立了濕壓縮過程的熱力學模型，給出了濕壓縮過程狀態參數的變化規律和計算方法。
  4. In this complicated process, the air is cooled by the sensible and latent heat of water ; at the same time, the water is vaporized, and the water vapor is also compressed

    但該過程是復雜過程，既有水的潛熱、顯熱對連續被壓縮空氣的冷卻，還有水的不斷蒸發以及水蒸氣的壓縮過程。
  5. Simulation results show that the surge line moved up - left relative to the original one and surge margin became larger when wet compression is used, which means wet compression can extend steady - operation regions of compressors and the si a - 02 gas turbine. at last, based on the moore - greitzer model surge and rotating stall of a compression system with wet compression is modeled with consideration of inlet evaporative cooling and compressor pressure rise when wet compression is used

    哈爾濱工程大學博士學位論文最後，本文在壓縮系統moors grei上zer模型的基礎上，考慮進口蒸發冷卻的作用和壓氣機濕壓縮過程的作用，推導出了濕壓縮系統喘振和旋轉失速的統一模型，該模型可以模擬系統發生喘振和旋轉失速時的瞬態響應以及噴水濕壓縮對系統瞬態響應的影響。
分享友人
分享到 Line

分享到臉書