蒸鍍 的英文怎麼說

中文拼音 [zhēng]
蒸鍍 英文
vapor deposit
  • : Ⅰ動詞1. (蒸發) evaporate2. (利用水蒸氣的熱力使食物熟或熱) steam Ⅱ名詞[中醫] (將藥物隔水蒸熟) steaming
  • : 動詞(用電解或其他化學方法使一種金屬附著到別的金屬或物體表面上) plate
  1. But alq3 was used in oelds by vacuum evaporation mostly because of its poor dissolubility, and easily recrystallized from the oelds so that the oelds " stability decreased

    但是alq3溶解性差,一般都通過真空蒸鍍製作器件,此外它會在器件內因器件發熱發生重結晶從而導致器件穩定性下降。
  2. Induction heating evaporation system

    感應加熱蒸鍍系統
  3. However, both of them have disadvantages. mo tip feas is fabricated by evaporating tip cathodes on base, so it has bad coherence with the base. on the other hand, the characteristics of silicon result in the bad heat stability, bad emission reliability, and low current density

    然而,這兩種陰極存在各自的缺點,如鉬尖錐是蒸鍍在基底上的,所以與基底的附著力不強;而硅的特性又決定了其熱穩定性差,發射的可靠性低,發射電流有限。
  4. The enhanced photoconductive effect from small amount of tnf facilitates the preparations of new organic photoconductive devices under the drive of low fields. in the fourth chapter, inclpc nanoparticles embedded in poly ( n - vinylcarbzaole ) ( pvk ) were prepared successfully by dissolving inclpc in aprotic organic solvent / lewis acid with great concentration for the formation of electron donor - acceptor complexes, i. e., the method of complexation - mediated solubilization. the fabricated inclpc nanoparticles were characterized by means of uv / vis absorption, x - ray diffraction pattern, and tem

    論文的最後一章中,我們合成了具有較好的電子傳輸性能的化合物』一二苯基四竣酸花酚亞胺( ddp ) ;研究了其溶解性、熱穩定性、晶體結構、紅外光譜、紫外吸收光譜和蒸鍍薄膜的屬性,並用量子化學計算方法模擬其單分子的空間構型;載流子遷移率測試的結果約為ix10 「 、 m 』 v 」 』 ? s 「 』 。
  5. Ionized cluster beam evaporation system

    成團離子線束蒸鍍系統
  6. Fluent in both written and spoken english, and can communicate with foreign colleagues

    熟悉真空蒸鍍工藝、真空膜設備。
  7. During this process, the level of doping concentration exceeds the density of cd vacancy in the crystal. in addition, the preparation of au contact on cd1 - xznxte wafers was studied. after further thermo - treatment, the stable ohm au contact was achieved

    此外,對于在cd _ ( 1 - x ) zn _ xte晶體上制備穩定歐姆接觸電極進行了相應的研究,制定出相應的蒸鍍及退火工藝。
  8. In this study, si nanomaterials were prepared by a thermal evaporation system, and four kinds of si nanomaterials, nanoparticles, nanoclusters, nanoclusters with hf treatment, and nanoclusters with ch3cooh treatment, were studied

    本研究系以熱蒸鍍系統制備奈米矽,並探討四種不同形式的奈米矽材料的發光機制,分別為矽奈米粒子、矽奈米團塊、以及經由氫氟酸和醋酸處理后的矽奈米團塊。
  9. Vapo u r deposited metal film

    蒸鍍金屬膜
  10. Composition and structure of ti6ai4v alloy surface on which pure titanium was coated by vacuum - evaporating at high temperature

    鈦合金表面高溫真空蒸鍍鈦塗層的組成和結構
  11. Lppp thin films were prepared by spin coating from a solution of lppp in toluene and alq was formed by vapor deposition. different configuration devices with lppp single - layer, lppp micocavity and lppp / alq heterojunction were fabricated

    利用lppp甲苯溶液旋塗制備lppp薄膜,真空蒸鍍法制備alq膜和電極,分別製作了lppp單層無腔、 lppp單層微腔、增強型lppp / alq異質結結構的有機電致發光器。
  12. Study on the technology of electric purging in heat - reflective glass

    真空蒸鍍熱反射玻璃電清洗工藝研究
  13. Optical device vacuum evaporation equipment

    光學元件真空蒸鍍設備
  14. Semiconductor vacuum evaporation equipment

    半導體真空蒸鍍設備
  15. Resistance heating evaporation system

    電阻加熱真控蒸鍍系統
  16. Research on metallic finishing of polyester textiles by vacuum evaporation

    滌綸紡織品真空蒸鍍法金屬整理的研究
  17. It fits for decorative films, such as various plastic products, and glass

    適用於蒸鍍各種塑料製品玻璃等裝飾膜。
  18. Vaccum evaporation chemicals

    真空蒸鍍化學藥品
  19. Vacuum evaporation or deposition

    真空蒸鍍
  20. This paper describes the theory of oxide vacuum coating and the form mechanism of film. it is discussed the technique that nonmetal is conated on polymer. the barrier performance of this new material that is produce by using different deposited method and raw materials is compared

    論述了非金屬真空膜的發理論和層的形成機理,討論了非金屬膜的技術方法與工藝,比較了不同蒸鍍原料與方法對材料阻隔性能的影響與效果。
分享友人