薄層位移 的英文怎麼說

中文拼音 [bócéngwèiyí]
薄層位移 英文
laminar displacement
  • 薄 : 名詞[方言] （浮萍） duckweed
  • 層 : i 量詞1 （用於重疊、積累的東西 如樓層、階層、地層） storey; tier; stratum 2 （用於可以分項分步的...
  • 位 : Ⅰ名詞1 （所在或所佔的地方） place; location 2 （職位; 地位） position; post; status 3 （特指皇帝...
  • 移 : Ⅰ動詞1. （移動） move; remove; shift 2. （改變; 變動） change; alter Ⅱ名詞（姓氏） a surname
  • 薄層 : sheet; thin layer; seam; thin wall; leaf; flash; lamelli; lemell-; lamin-
  1. The presence of small amount of liquid at grain boundaries tends to form thin viscous layer which surrounds the finer grains. intergranular fracture may occur at the grain boundaries between two fine grains not covered by viscous phases. the high ductility achieved at low strain rates is generally attributed to dislocation glide - creep accommodation mechanisms

    原始晶界上產生少量液相，形成薄的固液共存粘性層並包圍細化的晶粒，沿晶斷裂主要發生在無粘性層的細晶粒間；而在較低應變速率下，三叉晶界位錯攀援?蠕變協調機制鬆弛晶界滑移產生的應力集中，晶界上產生較多液相，有利於晶界滑移進行。
  2. In this paper, it is studied and analyzed characteristic of stress, distortion etc. of pipe liner structure combining dahuofang transport water tunnel practice project, tunnel boring machine construction, and it is considered that affects internal force of pipe liner for early stress of underground structure and digging load. in nonlinear finite element calculation model, folium cells have been simulated among pipe liner and pipe liner and wall rock. under varies load condition, it has educed that changing rule of stress, distortion and load characteristic pipe liner in kinds of wall rock tunnel by analysis and calculation

    本文結合實際工程，分析研究了大夥房水庫輸水隧道工程在採用掘進機施工方法的情況下，利用管片襯砌的結構應力、變形等受力特性，考慮地下結構初始應力和開挖荷載對襯砌內力的影響，採用薄層單元模擬襯砌管片之間、襯砌管片與圍巖之間的非線性有限元計算模型，通過分析計算得出不同荷載工況下各類典型圍巖段隧道襯砌管片受力特徵、應力和位移變化規律。
  3. But setting of strengthened floor will result in the sudden variation of structural stiffness and internal force, and will come into being weal story. the yield mechanism will difficultly " story column, weak beam " and " strong in resistance of shear force, weak in resistance of bending moment "

    在風荷載作用下，設置加強層是一種減少結構水平位移的有效方法；但在地震作用下，加強層的設置將會引起結構剛度、內力突變，並易形成薄弱層，結構的損壞機理難以呈現「強柱弱梁」和「強剪弱彎」的延性屈服機制。
  4. At present, the checking computation of collapse preventing performance of architecture is realized by calculating the plastic displacement between layers of the unsubstantial layer under the action of the rarely met earthquake

    目前，我國建築防倒塌驗算是通過對罕遇地震作用下對薄弱層的層間彈塑性位移的驗算來實現的。
  5. Based on the nodal mechanics theory and generalized displacement method, equations that the thin - wall cylinder pile is simulated with the beam element are derived. the influence of the number of beam element is researched, and conclusion that the number of beam element and the number of soil layer should be uniform is draw up

    應用節點力學的基本理論和廣義位移法的基本概念，推導了用梁單元模擬薄壁筒樁的計算公式，研究了梁單元離散樁體結構時梁單元的數目對計算結果的影響，得出了梁單元數量宜與樁穿過土層數目相一致的結論。
  6. Aimed at the present code of structure design without the specific method of frail - layer check computations of frame structures in high vibration areas, this article provides the parameter modifying method for the checking according to different regulations of earthquake parameter and by deducing and contrasting the relation of elasticity and plasticity displacement angle limitation of several earthquakes from the given conditions of present code

    摘要針對現行結構設計規范中沒有明確給出高震區框架結構薄弱層驗算具體方法的情況，從規范給定的條件入手，通過時大、小地震下彈性、彈塑性位移角限值關系的推導和對比，提出了在高震區框架結構薄弱層驗算中進行參數修正的方法。
  7. The pseudo - dynamic test of 1 / 3 - scale model six - story building assembled with hollow shear wall with seams. the internal forces, the deformation and the failure mechansm of the building under earthquake are studied. the rules of frequency, damping and response spectrum are studied. the characters of earthquake response such as structure displacement, interstory drift, action of earthquake, the amplificatory coefficient of acceleration and the rule of strain are discussed. at last, this paper presented the design method of this structure based on the aseismic style and put forward the construction

    進行了帶縫空心剪力墻結構六層樓房的1 3模型的擬動力試驗，研究了結構在水平地震作用下的受力特點、變形特徵、破壞形態等力學性能；得到了結構在不同受力階段的頻率、阻尼、反應譜等動力特性變化規律；討論了結構各樓層的水平位移、層間位移、地震力、加速度放大系數及構件應力分佈規律等結構地震反應特徵；指出了結構的抗震類型、薄弱層及薄弱部位；提出了多層帶縫空心剪力墻結構的第一階段設計方法和相應構造措施。
分享友人
分享到 Line

分享到臉書