薄膜增強材料 的英文怎麼說

中文拼音 [bómózēngqiángcáiliào]
薄膜增強材料 英文
film-reinforced material
  • 薄 : 名詞[方言] （浮萍） duckweed
  • 膜 : 名詞1. [生物學] （像薄皮的組織） membrane 2. （像膜的薄皮） film; thin coating
  • 強 : 強形容詞（強硬不屈;固執） stubborn; unyielding
  • 材 : 名詞1 （木料） timber 2 （泛指可以直接製成成品的東西; 材料） material 3 （供寫作或參考的資料） ma...
  • 料 : 名詞1 （材料; 原料） material; stuff 2 （喂牲口用的穀物） feed; fodder 3 （料器） glassware 4 （...
  • 薄膜 : thin film; film; diaphragm
  • 材料 : 1. （原料） material 2. （資料） data; material 3. （適于做某種事的人才） makings; stuff
  1. Diamond - like carbon gradient film on ti6a14v alloy substrate have been prepared by means of plasma source ion implanted - ion beam enhanced deposition ( psii - ibed ). for potential applications as artificial joint materials and artificial cardiac valve materials, its trobological performance and hemocompatibility has also been evaluated in the present ph. d. thesis

    本研究採用等離子源離子注入?離子束增強沉積技術（ psii - ibed ）制備了鈦合金基類金剛石梯度薄膜材料，對類金剛石梯度薄膜這一新型人工關節材料和人工心臟瓣膜材料的生物摩擦學性能和血液相容性進行了研究和評價，研究了摩擦磨損對材料血液相容性的影響。
  2. The properties of cn thin films such as their morphology, component, crystal structure and the bonding structure and the relation between those properties and the gas - phase reaction parameters were discussed, showing that the deposition of p - c3n4 thin film is the compete result of various reaction processes in the dynamics balance conditions ; the process of cn films depo sition is diagnosed in situ through the optical emission spectra technique, the effects of experimental parameters on the concentration of the precursors and the gas - phase reactions in the plasma have been obtained ; the main reaction precursors for film deposition identified ; the relation between the characteristics of cn thin films and the reaction process in the plasma is analyzed. the cn thin films deposition under different substrate temperatures in high pressure pe - pld shows that the si atom of the substrate has participated the cn films growth process, based on this the growth mode of cn thin films on the si substrate is proposed. the further experiment of cn thin films deposition on si substrate scratched by diamond as well as covered with fe catalyzer has been attempted, which indicates that changing the dynamics conditions of the surface reaction can alter the growth characteristic of the cn thin films and can enhance obviously the films growth rate

    採用pld技術進行了碳氮化合物薄膜沉積，得到了含氮量為21at的cn薄膜；研究了襯底溫度和反應氣體壓強對薄膜結構特性的影響，給出了cn薄膜中n含量較小、 sp ~ 3鍵合結構成分較少和薄膜中僅含有局域cn晶體的原因；引入脈沖輝光放電等離子體增強pld的氣相反應，給出了提高薄膜晶態sp ~ 3鍵合結構成分和薄膜的含n量可行性途徑；應用pe - cvd技術以ch _ 4 + n _ 2為反應氣體並引入輔助氣體h _ 2 ，得到了含n量為56at的晶態cn薄膜；探討了cn薄膜形貌、成分、晶體結構、價鍵狀態等特性及其與氣體壓強和放電電流的關系，證明了- c _ 3n _ 4薄膜沉積為滿足動力學平衡條件的各種反應過程的競爭結果；採用光學發射譜技術對cn薄膜生長過程進行了實時診斷，得到了實驗參量對等離子體中活性粒子相對濃度和氣相反應過程的影響規律，給出了cn薄膜沉積的主要反應前驅物，揭示了cn薄膜特性和等離子體內反應過程之間的聯系；採用高氣壓pe - pld技術研究了不同襯底溫度條件下cn化合物薄膜的結構特性，揭示了si原子對薄膜生長過程的影響，給出了si基表面碳氮薄膜的生長模式；在金剛石研磨和催化劑fe處理的si襯底上進行cn薄膜沉積，證明了通過控制材料表面動力學條件可以改變碳氮薄膜結構特性，並可顯著提高晶態碳氮材料的生長速率。
  3. In this paper, the vacuum thermo - cycling effects and vacuum ultraviolet effects on space inflatable structural materials were analyzed based on a thorough survey over the studies done through flight tests, ground simulation experiments and theoretical research. the main contents of this thesis are as follows : the performance damage effects of thermo - cycling on space inflatable structural fabric carbon fiber reinforced epoxy laminates ( cf / ep ), aluminized kapton ( al / kapton ) films which used as reflector of space inflatable antenna were investigated by a temperature range of - 120 120 with the vacuum degree 10 - 5 pa which conducted with space environment ground - based simulation facility

    本文在對國內外飛行試驗、地面模擬試驗以及理論研究等所取得的成果調研的基礎上，針對空間充氣結構材料進行地面模擬真空熱循環與真空紫外輻照的研究工作:利用真空熱循環地面模擬試驗機研究了真空環境（ 10 - 5pa ）中- 120 120的熱循環條件下空間充氣支撐結構織物碳纖維增強環氧樹脂（ cf / ep ）層合材料、空間充氣展開天線反射面鍍鋁聚酰亞胺（ al / kapton ）薄膜的空間環境效應。
  4. Nano - zns : mn2 + dispersed in pvb film has the same enhancement after exposure in solar light. the material has potential on measuring the dosage of uv irradiation of solar light

    薄膜樣品在太陽光輻照下同樣有熒光增強行為，預示該樣品可以作為一種紫外輻照劑量的記錄材料。
  5. A kind of novel composite photocatalysts containing tio2 and tourmaline particles, such as tourmaline / tio2 composite photocatalysts and tourmaline / [ tio2, sio2 ] composite photocalysts, were fabricated mainly by the sol - gel technique, whose microstructure, photocatalystic activities and spontaneous polarization were investigated by the scanning electron microscope ( sem ), uv - visible spectro - photometer, etc. the novel porous composite films of tourmaline / tio2 were prepared from alkoxide solutions on the surface of copper by sol - gel method

    本工作利用電氣石礦物材料的天然電極性、輻射紅外線性能和tio _ 2的光催化性能，研製以電氣石為載體， tio _ 2薄膜和[ tio _ 2 ， sio _ 2 ]復合薄膜為催化劑的新型復合催化材料。研究材料的制備技術、結構、性能及電氣石表面tio _ 2晶體生長機理、電氣石增強tio _ 2光催化效率機理。
  6. Second, after lots of experiments for the process of glass fiber surface modified, we primely avoided the glass fiber reunite with each other, and successfully prepared the glass fiber reinforced composites film

    其次，通過大量實驗對玻璃纖維表面處理工藝進行了深入研究，避免了玻璃纖維在環氧樹脂基體中形成團聚的現象，從而成功地制備了應變片基底材料，即玻璃纖維增強環氧樹脂復合材料薄膜。
  7. This paper discussed a new coated fabric used for membrane, which is made by multi axial warp - knitted fabric of the pet fiber reinforcing pvc sheets

    研究以滌綸經編多軸向織物為基布、表面復合聚氯乙烯壓延薄膜製成的新型可作膜結構材料使用的織物增強柔性復合材料的拉伸性能。
  8. In order to otain high quality zno thin films, we, for the first time, employ the plasma enhanced chemical vapor deposition ( pecvd ) to prepare high quality zno thin film at low temperature using a zinc organic source ( zn ( c2h5 ) 2 ) and carbon dioxide ( co2 ) gas mixtures. the effects of the growing condiction and the native oxide layer of si substrate on the quality of zno thin films was studied in detail. to prepare p - zno and overcome the dufficulty of reverse due to the interaction between the n atomic, we obtain high qulaity p - zno by a easy way of thermal zn3n2

    為了在低溫下制備高質量的氧化鋅薄膜，我們採用金屬有機源和二氧化碳氣源，首次利用等離子體增強化學氣相沉積的技術在低溫下制備了高質量的氧化鋅薄膜，系統地研究了生長條件以及襯底表面氧化層對薄膜質量的影響，確定了生長高質量氧化鋅薄膜的優化條件；為獲得p - zno材料，克服在zno中摻n雜質間相互作用影響摻雜效率不易獲得p - zno的困難，我們通過熱氧化zn3n2的方法制備了p - zno ，獲得了一系列研究結果： 1 、詳細研究了氣體流速比，襯底溫度和射頻功率實驗參數對氧化鋅薄膜特性的影響。
分享友人
分享到 Line

分享到臉書