表層溫度 的英文怎麼說

中文拼音 [biǎocéngwēndù]
表層溫度 英文
skin temperature
  • 表 : Ⅰ名詞1 （外面;外表） outside; surface; external 2 （中表親戚） the relationship between the child...
  • 層 : i 量詞1 （用於重疊、積累的東西 如樓層、階層、地層） storey; tier; stratum 2 （用於可以分項分步的...
  • 溫 : Ⅰ形容詞（不冷不熱） warm; lukewarm; hot; gentle; mild Ⅱ名詞1 （溫度） temperature 2 （瘟） acute ...
  • 度 : 度動詞[書面語] （推測; 估計） surmise; estimate
  • 表層 : skin layer; superficial coat; veneer; surface; sexine; bloom; supercrust; surface layer表層沉積 [...
  • 溫度 : [物理學] temperature
  1. Preliminary analysis on the relationship between the distribution of fishing ground of pacific saury cololabis saira and sst in northwest pacific

    西北太平洋秋刀魚漁場分佈及與海水表層溫度的關系分析
  2. The experimental results showed that the bed temperature and the adhe - sive concentration and especially the fluidizing gas velocity had great influence on the granule ' s strength

    結果表明，在本實驗范圍內，流化氣速對顆粒強度的影響顯著，床層溫度、粘結劑濃度對顆粒強度也有較大的影響，而且均是非單調的。
  3. Around 40 ; the neutral curve obtained by the growth rates of the temperature fluctuation has a ringlike curve separated from the main branch of nachtsheim s calculation by velocity fluctuation at the lower grashof number side ; and its phase velocity is close to the maximum mean velocity where the critical layer of the eigenmode locates. the thermal fluctuation decays rapidly as the nondimensional frequency above 0. 4, so that it means that the coupling effect between instability wave generated by buoyancy fluctuation and velocity waves by invicid instability seems weak enough for their critical layers in the range of the nondimensional frequency

    詳細研究了自然對流邊界層中最早失穩的浮力振型的功率譜波長波速與臨界層位置等基本特徵和它為主導其他振型尚未失穩時按線性理論得到的3種相互獨立振型的振幅分佈。系統地測量了它所對應的溫度和速度漲落的振幅增長規律和中性曲線，實驗結果表明，溫度漲落的中性曲線在低格拉斯霍夫grashof數
  4. Micro - jets impingement cooling heat sink is used to cool the high power lda owing to the very thin hydrodynamic and thermal boundary layers in the impingement region when a jet impinges on a surface. reasonable array of jets can develop the uniform of temperature distribution on target very much

    微射流陣列冷卻熱沉，是利用射流沖擊在駐點區能產生很薄的邊界層來提高換熱效率的，合理的布置射流孔，可以極大的提高被冷卻表面溫度分佈的均勻性。
  5. The results shows that temperature in the porous dried layer varies - as a exponential discipline whose changing scope is determined by the mass flux and a linear distribution in temperature exists across the frozen layer

    結果表明，多孔乾燥層溫度按指數規律變化，變化幅度取決於水汽流率，凍結層溫度按線性分佈，預測凍干時間與實際結果相符。
  6. Heat fluxes estimated from radiative temperature by this model is more accurate than other regular corrective methods. two - layer model has been proposed for many years but was difficult to apply in remote sensing because component temperature were unavailable in traditional thermal sensors. a new airborne multi - angular thermal sensor system and retrieved soil and canopy temperatures were used to solve two - layer model, and the simulated heat fluxes show much better accuracy than the results from one - layer model especially above dry surfaces

    雙層模型雖然提出很多年了，但在應用中一直存在信息不足，求解困難的問題，本文用最新多角度熱紅外遙感數據? ? ? amtis系統反演的組分溫度，首次實現了雙層模型在遙感中的應用，結果表明，在輸入參數精度相近的情況下，雙層模型模擬的通量誤差遠小於單層模型，尤其在土壤乾旱，表面溫度較高的地表，雙層模型的理論優勢在計算中表現得更加突出。
  7. In - situ measurements of heat loss through thermal insulation of equipments and pipes - surface temperature method

    設備及管道絕熱層表面熱損失現場測定表面溫度法
  8. It utilizes the thermoelectric couple and thermal imaging system for the first time to monitor the internal heat conduction of the decoration for the buildings, and the uses the thermal imaging system and thermoelectric couple of copper constantan to follow up the monitoring to the surface temperature of the tiles and the temperatures in many

    論文中首次利用熱電偶及熱像儀對飾面墻體的內部熱傳導過程進行了監測，利用熱像儀及銅-康銅熱電偶對面磚表面溫度及砂漿內部各層多點溫度進行了跟蹤監測，結果表明面磚表面溫度及砂漿內部各層溫度變化趨勢基本一致，而且從熱像儀測出的面磚表面溫度值與由熱電偶測出的面磚表面溫度值基本相同。
  9. Thirdly, the conclusions of the two aspect applications are given as follows : the exploration of the application of the evaporation duct prediction to the flux relationship research and evaporation duct predicting shows that based on this predicting method and with microwave refractometer, as sensor, ( 1 ) the dimensionless gradient function of temperature, humidity and refractivity in the flux relationships can be determined with higher precision, ( 2 ) the limitations of conventional observations on the predicting accuracy for evaporation duct can be avoided and the precise prediction for evaporation duct can be obtained with the accurate measurement of refractivity profile within a few meters. the radar performance under given evaporation

    三、對兩個應用問題的討論表明：基於本文發展的蒸發波導預測理論，使用微波折射率儀為傳感器： （ 1 ）開展通量關系研究時，可以用於邊界層溫度、濕度和折射率無量綱梯度函數的精確測定和得到蒸發波導環境預測所需的偽折射率參數化函數關系； （ 2 ）預測蒸蒸發波導環境特性和傳播特性及其應用研究發波導環境時可以避免使用傳統氣海界面要素測量中存在的局限，並用折射率音d面不太高的精確測量結果精確預測蒸發波導環境。
  10. And it can be concluded that cracks on top floor ' s walls are caused by the temperature difference between floor or wall ' s inner and outer surface and the temperature difference between floor and walls. if the floor and wall ' s thermal resistance is appropriate, the cracks issue on cscbb can be solved

    分析表明，砌體建築頂層墻體的裂縫主要是墻體、屋面板內外表面溫度差異和屋面板、墻體之間的溫度差異所致，因此如果墻體和屋面的保溫隔熱措施合適，砌體建築的溫度裂縫問題是可以解決的。
  11. Thermal bridges in building construction - heat flows and surface temperatures - general calculation methods

    高層建築中的熱橋.熱流和表面溫度.第1部分:一般計算方法
  12. In surface temperature. i ' ve sent you an e - mail

    .表層溫度下降我已經給你發了電子郵件
  13. . . in surface temperature. i ' ve sent you an e - mail

    . . .表層溫度下降我已經給你發了電子郵件
  14. The correctness of the models and simulation had been verified indirectly by testing the temperature inward - outward superficial coat of the bearing race snap

    通過對感應加熱過程中軸承內環內外表層溫度的測試，間接證明了所建模型和計算機模擬的正確性。
  15. As the results suggested, the climatological shift was primarily induced by variability of the air temperature and the decrease of temperature adjacent to the changjiang river estuary was influenced by the run - off of the changjiang river

    2 ）黑潮：對夏季表層溫度的影響在31on以南，對深層溫度和鹽度幾乎可影響到整個海域，其影響自60年代以來一直呈增強趨勢。
  16. The surface of the maximum sea temperature anomaly ( msta ) was constructed from the subsurface sea temperature anomaly data in the tropical pacific from 1955 to 2002. it is quite similar to the depth distribution of the 20 ? c isotherm, which is usually used to represent the center of the thermocline layer

    利用1955 - 2002年48年熱帶、副熱帶太平洋地區次表層溫度距平資料，構造了溫度距平極值深度分佈的曲面圖（ msta ） ，它很接近20溫度面的深度分佈，因此有理由認為這一深度曲面很接近熱帶溫躍層的深度面。
  17. The numerical results show that the nature frequencies of the structure are affected by the temperature effect, boundary conditions and the number or orientations of layers ; the proper orientations can change the nature frequencies ; the effect degree on the nature frequencies of cross - ply laminated cylindrical shell is different from that of the antisymmetric one

    結果表明，溫度效應、邊界約束、鋪層層數顯著影響結構的固有頻率，適當的鋪層角度會改變結構的固有頻率，不同的鋪層方式對結構固有頻率影響程度不同。
  18. A correlation was studied out here :, for experiment with sparger 1 # ;, for experiment with sparger 2 #. sparger decreased interfacial heat transfer coefficient, total clotted liquid and steam energy transfer and weakened surface temperature vibration. it also decreased thickness of hot water layer, attenuated steam condensation and shortened the time of balance

    加裝遮流板使實驗初期階段的表面冷凝換熱系數hif降低76 93 ；減少了累計凝結量67以上；降低蒸汽流能量的傳遞，使表面溫度波動顯著降低；減少了熱水層的厚度；減緩了蒸汽凝結的劇烈程度，大大縮短了系統壓力平衡需要的時間。
  19. To make the thermal efficiency best, y, a, av / as should be : r : [ 60 - 75 ] a : [ 1 - 1. 5 ] av / as : [ 0. 8 - 1 ] in this paper, numerical model of solar radiant floor heating system is also built. the model of numerical model is solved by finite differance method. the smaller the distance to the tube is, the higher the temperature on the surface of the floor is

    地板表面相鄰兩管間水平方向的溫度分佈：距離加熱管越近，溫度越高；兩管中間處溫度最低；供回水溫差越小，地板表面溫度分佈越平緩；在供回水溫度和排管間距均一定的情況下，地板覆蓋層厚度越大，其溫度分佈越為平緩，對應的地板表面溫度分佈越均勻。
  20. According to heat load source of die cavity, temperature distribution gradient equations and heat flux equations and the peak value equations of temperature load at die cavity surface have been obtained with research of temperature distribution and transfer laws of die surface by unsteady heat transfer theory

    摘要根據鍛模型腔熱負荷來源，通過非穩態傳熱理論，分析研究了模具工作表面層的溫度分佈與傳遞規律，給出了型腔表面溫度分佈梯度和熱流密度公式，並給出了鍛模型腔表面的溫度負荷峰值的計算公式。
分享友人
分享到 Line

分享到臉書