表觀氣孔度 的英文怎麼說

中文拼音 [biǎoguānqìkǒngdù]
表觀氣孔度 英文
apparent porosity
  • 表 : Ⅰ名詞1 （外面;外表） outside; surface; external 2 （中表親戚） the relationship between the child...
  • 觀 : 觀名詞1. （道教的廟宇） taoist temple2. （姓氏） a surname
  • 氣 : Ⅰ名詞1 （氣體） gas 2 （空氣） air 3 （氣息） breath 4 （自然界冷熱陰晴等現象） weather 5 （氣味...
  • 度 : 度動詞[書面語] （推測; 估計） surmise; estimate
  • 氣孔 : [礦物學] blowhole; [植物學] stoma; [動物學] spiracle; pore; stigma; [冶金學] gas hole; gas pocket; [建築] air hole
  1. The investigation of a lot of parameters about treated sandstone, brick materials and earthen materials with fluorited polymers has been carried out, such as the formation of polymer, the penetration depth, porosity, capillary absorption and penetration coefficient, water uptake, compressive strength, drilling resistance, absorption isotherms of water vapor, water vapor diffusion, color changes as well as resistance to desegregation of water, frizzing - throwing cycles, worming - cooling cycles, and so on. in addition, the influence of salt crystallization, acid and base, and uv aging have also been assessed in order to better understand the protection effects and utilization possibility of two fluorinated polymers, mainly according to astm standard and the combination of international methods together with general technological

    分別以國家級文物保護單位的土質、砂巖和磚材文物樣品為對象，依據astm標準及國際通用文物保護研究方法與評估準則相結合，通過膠化物形成周期、滲透深度、孔隙度、毛細吸水和滲透系數、持水量、抗壓強度、抗鉆強度、吸附水蒸氣的能力、透氣性、外觀顏色等系列參數的測定，及凍融、冷熱循環、酸堿腐蝕后抗壓強度的衰減、可溶鹽對保護效果的影響、酸堿及光照對表面保護效果的影響，對兩種含氟聚合物及其與有機硅的共混物在文物加固保護和表面防護中的可行性和保護效果給予了系統研究。
  2. After the stolon had suffered from severing disturbance, clonal ramets could keep photosynthetic organ from being damaged through the plastic responses of the chlorophyll fluorescence traits, such as increasing nonphotochemical quenching of chlorophyll fluorescence ( npq ), decreasing actual photochemical efficiency of ps ii in the light ( f / fm " ) and photochemical electron transport rate ( etr ). moreover, the clonal ramets could also increase water use efficiency by means of decreasing stomatal conductance

    在匍匐莖受到切斷干擾后，臭柏能通過提高非光化學猝滅（ npq ） 、降低ps實際光化學量子產量（ f fm 』 ）和表觀光合電子傳遞速率（ etr ）等葉綠素熒光特性的可塑性反應來保護小枝光合機構不被破壞，並且可以降低氣孔導度以提高水分利用效率。
  3. Test methods for apparent porosity, apparent specific gravity, and bulk density of graphite electrodes

    石墨電極容積密度表觀比重和顯氣孔率的測定方法
  4. Test methods of ceramic tiles - part 3 : determination of water absorption, apparent porosity, apparent relative density and bulk density

    吸水率顯氣孔率表觀相對密度和容重的測定
  5. Ceramic tiles - part 3 : determination of water absorption, apparent porosity, apparent relative density and bulk density iso 10545 - 3 : 1995, including technical corrigendum 1 : 1997 ; german version en iso 10545 - 3 : 1997

    瓷磚.第3部分:吸水率顯氣孔率表觀相對密度和容重
  6. However for the closed stomata, induced by aba, the distribution density of particles in gcv is greatly reduced with the obviously enlarged volume, b ) buffers regulate ph of in vitro gcv sap in the tip of micro - capillaries : certain amount of buffer ( mes - tris ) is filled from the tip of micro - capillaries beforehand, and the ph of gcv sap that is sampled by the same micro - capillary sh ould be regulated by the buffer

    觀察結果與本試驗室已發表的氣孔開放過程的實驗結果一致：開放態氣孔保衛細胞液泡所含顆粒狀物的線度極小（平均直徑10nm ） ，且分佈密度極高，而經aba處理的關閉態氣孔保衛細胞液泡所含顆粒狀物的線度很大（平均直徑50nm ） ，分佈密度很小。
  7. Experimental results indicated that the polypropylene fiber can improve the workability of concrete availably, and can increase the presentation quality of structures with the voids and pits decreased ; the cracks of beam are controlled effectively, the width and length of crack decreased, the dispersibility of crack in beam face improved, and the ductility of beam increased ; and the cracking load of reinforced concrete beam is increased, the amplify up to about 30 %, simultaneity the ultimate bear capacity increased

    試驗研究表明，使用聚丙烯纖維后，能有效改善新拌混凝土的和易性，並能增強混凝土構件的外觀質量，減少構件表面蜂窩、麻面、氣孔、細小裂紋等；同時，在破壞試驗過程中發現梁的裂縫能得到有效控制，裂縫寬度減小，裂縫的發展高度降低，裂縫的條數增加，提高了梁截面的裂縫分散能力，增強了梁中混凝土的韌性；提高了鋼筋混凝土梁的開裂荷載，幅度可達30左右，增強了結構的延性，提高了結構的抗裂性能和屈服荷載。
  8. From the investigation of titania films with peg as additive, several significant conclusions could be drawn : titanium dioxide films with porous microstructure could be prepared using peg as additive ; almost no conglomeration were observed with the titanium particle ; the microstructure of titania films could be modulated by the amount of peg and treating temperature ; at the same time, the porosity of the film improved with the increase of peg ; for the specimen treated at different temperatures, the greatest porosity could be achieved when treated at 500 ? ; the adding of peg could greatly increase the dye adsorption amount

    對以peg為添加物的tio _ 2薄膜樣品的研究表明： peg的加入得到了具有疏鬆多孔結構的tio _ 2薄膜，但二氧化鈦顆粒有些團聚。 peg的含量和熱處理溫度對tio _ 2薄膜的微觀結構均有影響。 tio _ 2薄膜的氣孔率隨peg的加入量的增多而增大。
  9. Different element in some interface change in evidence, but different element in other interface change gradually. the interface often have some hole and a mass of one element. in w - mo fgm, because the different rime temperature, the size of mo grain differ from the size of w. in w - mo - ti fgm, mo - ti layer rich in ti, there are more polygonal a

    顯微組織特徵研究表明， w - mo系和w - mo - ti系梯度功能材料整體緻密，有的宏觀層間界面明顯，在界面處成分發生突變，而且還有氣孔、顆粒偏聚等缺陷，有的宏觀層間界面處成分變化平緩； w - mo系梯度功能材料由於w 、 mo的再結晶溫度不同，梯度層顆粒粒徑有顯著差異； w - mo - ti系梯度功能材料中，以ti為主的mo - ti混合區，主要以多角形固溶體存在，富ti區主要以多角形相存在。
分享友人
分享到 Line

分享到臉書