表觀溶解度 的英文怎麼說

中文拼音 [biǎoguānróngjiědù]
表觀溶解度 英文
apparent solubility
  • 表 : Ⅰ名詞1 （外面;外表） outside; surface; external 2 （中表親戚） the relationship between the child...
  • 觀 : 觀名詞1. （道教的廟宇） taoist temple2. （姓氏） a surname
  • 溶 : 動詞（溶化; 溶解） dissolve
  • 解 : 解動詞（解送） send under guard
  • 度 : 度動詞[書面語] （推測; 估計） surmise; estimate
  • 溶解 : dissolve; dissolution; solution; lysis; solvus; resolution; decomposition; resolving; solving; fu...
  1. The method of obtaining high concentration of na2feo4 solution by quick electrolysis mainly contains four aspects : adoption of either a diaphragm or an ionic membrane electrolytic cell in which a thin anodic cell lying between the two cathodes, ( 2 ) using an iron anode that has larger specific surface area, ( 3 ) keeping suitable concentration of naoh in the anodic cell, adoption of lower current density and higher electrolyzing speed. the practical technique parameters follow a s below : the naoh solution of 14 - 16mol / l, the temperature of 303 - 308k, the surface anodic current density of 300a / m2, the unit electrolyzing speed of efficiency larger than 6. 0a / l

    快速電解獲取高濃度na _ 2feo _ 4溶液的方法，主要包括四個方面：採用兩陰極室夾一厚度較小的陽極室的隔膜（或離子膜）電解槽；使用比表面積較大的鐵網陽極；保持陽極室中有適宜濃度的濃naoh溶液；採用較低的電流密度和較高的電解速度。具體工藝參數是： 14 16mol / lnaoh溶液、溫度303 308k 、表觀陽極電流密度300a m ~ 2 、有效單位電解速度6 . 0a / l 。
  2. Also, the author ’ s design strategy and creativity has been given in this paper. specifically, it includes : based on the feasibility analysis of the fit selection of control parameters in the aeration process, the aeration process of wastewater treatment of the joint - constructional complete - mixed activated sludge process has been aimed at in this paper. then, the state equations of the aeration process have been proposed in this paper, which is on the base of dissolved oxygen concentration ( do ) and discharge quantity of sludge ( qw ) as control variables, the concentration of bod and sludge as state variables. based on the present study on optimization control of wastewater treatment, the multivariable optimal control model with restriction factor has been presented in the paper with introducing modern control theory and system analysis into the field of activated sludge wastewater treatment,

    具體包括:以完全混合、表面曝氣合建式活性污泥工藝的污水處理曝氣過程為研究對象，在闡述了曝氣過程式控制制參數選取可行性的基礎上，建立了以溶解氧濃度do和活性污泥排放量qw為控制變量，以曝氣池中有機物濃度s和微生物濃度x為狀態變量的活性污泥曝氣過程的基本狀態方程;運用現代控制理論的觀點和污水處理理論，在現有關于污水處理最優控制問題研究的基礎上，建立了有約束條件多變量能耗最小數學模型，該數學模型是以有機物排放總量和狀態變量的末值條件作為約束條件，曝氣過程的能耗最小作為目標泛函;採用增廣拉格朗日乘子法對最優控制問題進行轉化，並對應用極大值原理求解能耗最小這一最優控制問題進行了詳細的解析;引入約束運算元，應用具有控制約束的共軛梯度演算法對能耗最小這一最優控制問題進行求解，並進行模擬實驗驗證。
  3. Hot shock and cathode electrolysis experimental results indicate the interface adhesion strength between coating and aluminum matrix is excellent. the element electronic probe image provide that the two composition are co - deposition ; structure analysis by xrd ( x - ray diffraction ) demonstrated that cr exists in the way of solid solution in the coating

    Sem和金相觀測結果表明浸鎳后鍍層結晶緻密、厚度均一；熱震及陰極電解結果說明鍍層與基體結合牢固緊密；鍍層元素電子探針掃描圖說明鎳鉻兩種元素均勻沉積； xrd分析證明鍍層中鎳鉻以固溶體的形式存在。
  4. In this work, the macroscopical characteristics of diesel and diesel / lpg sprays are studied through using a digital camera with a high spatial resolution. based on processing technique for digital image, the droplets photographed, which are at the spray edge, are studied. after a comparison of the characteristics of sprays for different fuels, such as diesel, blend fuels of diesel and lpg with different weight fractions, it is shown that flash - boiling injection ( fuel containing dissolved gas ) is good for the atomization of fuel

    本文對柴油和柴油lpg混合燃油的噴霧的宏觀特性採用高解析度數碼相機進行測量，並運用數字圖像技術處理了數碼相機捕捉到的處于霧束外沿的粒子，通過比較純柴油和不同lpg比例混合油的霧化性能，表明溶氣噴射（閃急沸騰）有利於噴射油滴的霧化。
  5. Experiments indicated that compared with the native starch, the paste made of granular maize starch soluble in cold water prepared by alcoholysis showed higher apparent viscosity, higher stability of freeze thaw and lower retrogradation ; while the paste made of granular tapioca and potato starch soluble in cold water showed lower viscosity, stability of freeze thaw and retrogradation

    試驗證明，相對于原澱粉糊，醇解法制備的顆粒狀冷水可溶玉米澱粉糊的表觀粘度和凍融穩定性有所提高，凝沉性降低；顆粒狀冷水可溶木薯和馬鈴薯澱粉糊的表觀粘度、凝沉性和凍融穩定性均降低。
  6. In this paper, the ceramic coatings were prepared in situ on ti - 6al - 4v alloy by micro - plasma oxidation ( mpo ). the phase composition, microstructure and corrosion resistance of the ceramic coatings were studied in detail and the technology of corrosion resistant coatings was optimized. the dissolution of the substrate and the changes of the elements in the electrolyte during the mpo process were studied to discuss the growing characters and the structure of the ceramic coatings

    本文通過微等離子體氧化（ mpo ）方法在ti - 6al - 4v鈦合金表面原位生長陶瓷膜，系統地研究陶瓷膜的相組成、微觀結構及膜層耐腐蝕性能，並優化耐蝕性陶瓷膜層制備工藝;分析基體在mpo過程中的溶解現象和電解液中離子濃度變化特點，探討電極表面陶瓷膜層生長規律和結構特點;研究膜層的等效電路、膜層結構與耐腐蝕性能的關系，並對優化工藝條件下制備的陶瓷膜層進行進一步的耐腐蝕性能測試和耐腐蝕機制研究。
  7. A 0. 85um - or 1. 3um - led - lighted fiber optic humidity sensor based on a film of 40 ~ 100nm in thickness self - assembled on the end face of the fiber can work in the range of 1 ~ 100 % rh with a response time less than 1s. this novel humidity sensor can be used for monitoring human breathing - conditions. organic molecules including congo red, a derivative of copper phthalocyanine and a fullerol were self - assembled with polymers into multilayer thin films, and organic molecules with more than 4 charged groups exhibited satisfactory features for multilayer self - assembling

    聚電解質pdda -聚染料ps - 119體系具有很好的自組裝性，多層復合膜無明確的層狀結構特徵，在宏觀上表現出單層光學塗層的特性，單層膜的厚度在納米量級且與聚電解質水溶液的濃度有關；薄膜具有濕敏特性，在光纖端面上組裝厚度為40 100nm的薄膜，採用0 . 85 m或1 . 3 m的led光源，可以製成光纖濕度傳感器，傳感器的工作區間為0 100 rh ，響應時間1s ，可以用於對人的呼吸監測。
分享友人
分享到 Line

分享到臉書