表面凹陷 的英文怎麼說

中文拼音 [biǎomiànāoxiàn]
表面凹陷 英文
dinge
  • 表 : Ⅰ名詞1 （外面;外表） outside; surface; external 2 （中表親戚） the relationship between the child...
  • 面 : Ⅰ名詞1 （頭的前部; 臉） face 2 （物體的表面） surface; top 3 （外露的一層或正面） outside; the ri...
  • 凹 : 凹名詞（凹陷的地方, 用於地名） low-lying area; depression （used in place names）
  • 陷 : Ⅰ名詞1 （陷阱） pitfall; trap2 （缺點） defect; deficiency Ⅱ動詞1 （掉進） get stuck or bogged do...
  • 表面 : surface; superficies; boundary; face; rind; sheet; skin; outside; appearance
  • 凹陷 : hollow; sunken; depressed; pit; inflection; swaying; deboss; sag; dished; thumbmark （禽類單冠邊...
  1. The bacilliform cell penetrate into interior of the fibre to degrade the cellulose strongly and produced a mass of sticky polysaccharides. after cultured 48 hours, the bacilliform cell ' s surface of sporocytophaga have a great change. at this stage the bacilliform produce a lot of sticky polysaccharides. these sticky polysaccharides associated with the sites where the filter paper was decomposed intensively and form thorns on the surface of the bacillium. at the same time, the filter - paper weight loss is the greatest and decomposing rate is the fastest, so we think that the sticky polysaccharides are produced during the cellulose degradation

    培養48小時，桿狀細胞的表面結構發生很大的變化，此時的菌體表面已產生大量的粘性多糖，這些粘性多糖因菌體在纖維素表面滑動而在菌體表面形成突起，即在纖維素被旺盛降解部位的菌體表面產生了大量突起；而產生突起的菌體深入到纖維素分子內部，纖維素表面可以清晰地看到由於菌體嵌入纖維素分子內部而留下的凹陷。
  2. The cutin layer on leaves is thin. there are a lot of cup - shaped poly - cell salt glands in depressed sites of both up - and under - epidermis

    葉表面角質層薄；上下表皮均有杯狀多細胞鹽腺，凹陷於表皮之內。
  3. Our skin surface is " cuticular layer ", and cuticular lower part is " dermal layer " ; cuticular layer and true cortex are not completely close together " sticky " together, skin is in only certain zone by connective tissue closely " bind " go up in derma, certain place is done not have ; so, absorbed water when skin " swollen " when rising, " bind " the place that live is stayed by confine however and show cave shape ; look from the exterior, cutaneous surface just has sunken have dash forward, like furrow

    我們的皮膚表面是一層表皮層，而表皮下方是真皮層；表皮層與真皮層並非完全緊密的黏在一起，表皮只在某些地帶由結締組織緊緊地綁在真皮上，某些地方則沒有；所以，當表皮吸了水腫起來時，綁住的地方卻被局限住而呈凹陷狀；從外觀看起來，皮膚的表面才有凹有突，像皺紋一樣。
  4. These specimens of ruppia are characterized by possessing a small oval endocarp, smooth endocarp surface, distinct narrowly elliptic external depressions, distinct apical mucro, slightly curved seed shape and conspicuous globose hilum. a new species, r. yushensis sp. nov

    該新種的主要特徵為內果皮卵形、表面光滑、側面具兩個顯著的窄橢圓形凹陷、頂端具一個明顯的小尖突，以及種子頂端具顯著的球形膨大的種臍。
  5. Smooth and scratchproof face : advanced european and american production technology and recipes is introduced for this product, thus the turned - out board material is of smooth face and high hardness, collision and impacting will not result in depressions and scratches

    本產品引進歐美先進生產工藝及配方，生產出來的板材，表面平整且硬度高，不因碰撞面產生凹陷和刮痕。
  6. In unfed adults, the acini were small ( 34. 79um ) and their surface had many folds. on the d2 after attachment, the gland and its acini increased sharply and reached its peak ( 97. slum ), which was about 2. 8 times of unfed female. during this period, the surface of acini was relatively smooth

    饑餓雌蟲唾液腺腺泡小（ 34 . 79 m ） ，表面有人量的突起和凹陷；吸血后2d腺體和腺泡明顯增大：交配期腺泡達到最大值（ 97 . 81 m ） ，約為饑餓期的2 . 8倍，腺泡表面明顯變得光滑；飽血后腺泡逐漸萎縮，發生自溶現象，飽血后4d唾液腺明顯退化。
  7. An indented or concave surface or area

    凹陷，窪地凹的表面或地區
  8. The source faults control oil gas accumulation and distribution in the research area : 1 ) the nearer to the source faults is, the higher the oil - gas accumulation degree is ; 2 ) the smaller fault displacement of the source fault is, the higher oil gas output near the source fault is

    源斷裂控制著貝爾凹陷布達特群油氣成藏與分佈，主要表現在距源斷裂越近油氣富集程度越高及斷距越小的源斷裂附近油氣產量越高2個方面。
  9. A cavity or hollowed surface, especially of a bone

    腔尤指骨頭的腔或凹陷的表面
  10. In fact, it can be used without painting the bare metal because it does not rust or corrode like steel frames or aluminum exposed to rock salt. this means you never have to worry about your titanium frame falling apart due to exposure to the weather. the ti 3 - 2. 5 tubing is the high strength material used in the most advanced aerospace applications

    鈦合金具有極好的抗腐蝕性能，事實上，作為自行車架的使用，它的表面不需要塗漆保護，因為它不會象鐵和鋁車架那樣生銹或腐蝕，並耐酸雨紫外線潮濕等的侵蝕，所以你不必擔心其金屬表面會因裸露在空氣中形成凹陷銹蝕。
  11. Thus wear and friction are reduced. 3 ) in the course of friction the nanometer cacos particles and cao particles can fill up the concave of the surface and even sink into substrate and fill in the worn position promptly

    （ 3 ）摩擦過程中納米碳酸鈣、納米氧化鈣粒子能填平摩擦表面低凹處甚至陷入基體中，並可及時填補損傷部位，具有自修復功能，使摩擦表面始終處于較為平整的狀態。
  12. Dimple - a concave depression found on the surface of a wafer that is visible to the eye under the correct lighting conditions

    表面起伏-在合通下線光的適過肉眼可以發現的晶圓片表面凹陷。
  13. The result indicates that from the north to the south, from the east to the west, the seal ability of four caprocks is better and better, the good seal areas of caprock distributes in heiyupao sag and its south. based on the research of the seal mechanism of the faults, this paper researched the vertical seal of t1 and t2 fautlts in binbei region by means of the mudstone content in fault zone and the pressure of fault plane. the result indicates the good seal areas of t2 fault for gas and oil distribute in daqing - anda and their north of binbei region, the good seal areas of t | fault for gas and oil distribute in wuyuer and heiyupao sags of binbei region

    本文通過濱北地區青山口組和嫩一、二段蓋層宏觀發育和微觀封閉能力分析，利用模糊數學綜合評價方法對濱北地區青山口組和嫩一、二段泥巖蓋層的封蓋能力進行了評價，結果表明這四套蓋層封蓋能力從北向南，從東向西逐漸變好。好蓋層封蓋能力區主要分佈於黑魚泡凹陷及其以南地區。在斷層封閉機理研究的基礎上，利用斷層面壓力和斷面填充泥質含量研究了濱北地區t _ 2層和t _ 1層斷層封閉性，結果表明濱北地區t _ 2斷層好的封油氣區位於大慶?安達以北局部地區， t _ 1層斷層好的封油氣區位於烏裕爾、黑魚泡凹陷處。
  14. Two species, k. borneensis and k. lanceolata, have this type. in type 2, the seed surface is areolate with prominent lumina and sunken muri

    Verrucosa屬負網紋型，其種子表面具負網紋，網眼凸起，網脊凹陷；異形南五味子k
  15. This type is the commonest in the genus, occurring in seven species, i. e. k. heteroclita, k. induta, k. japonica, k. oblongifolia, k. angustifolia, k. scandens and k. marmorata

    Scandens和大葉南五味子k marmorata屬網紋型，其種子表面具網紋，網眼凹陷，網脊凸起，此類型在南五味子屬中最為普遍。
  16. The researchers developed a manufacturing method that begins by making a bas - relief mold in a quartz plate that contains an indented image of transistors, wires or other components of electronic circuits

    研究人員所發展的製造方法，是先在一塊石英板上做出淺浮雕鑄模，上面縮印了電晶體、導線或其他電子?路，然後再把這個鑄模放到晶片表面的一層液態單體上，液體便會填滿鑄模的凹陷處。
  17. In pulsed field magnetization condition, we find some new phenomena characteristic, that is, the trapped fluxes of ybco bulk increase with increasing intensity of applied field up to about 1. 9t, but decease beyond this value and the scanning distribution map of the trapped fluxes on the surface of the superconductor is not slick, which is different with the superconductors magnetized in constant magnetic field and the normal permanent magnets

    超導體在脈沖場下具有特殊的勵磁特性，當脈沖場在1 . 9t左右時，由於在脈沖場下超導體內的磁通線運動受到較大的粘滯力作用，超導體表面中心的俘獲場分佈掃描圖將出現一些凹陷區域，這是跟超導體在恆定場下的勵磁和一般永磁體所不同的。
  18. Then we consider the problem as a " conjunction " problem : according to the solutions for wave problem in interface between two conjunctive homogeneous elastic half - spaces as well as the scattering problem of sh - waves by an arbitrary - shape - cavity in homogeneous material, we divide the elastic space with an interface cavity into two parts along the interface, each is elastic half space with an arbitrary - shape - canyon. and then dividing surfaces are loaded with undete rmined antiplane forces, and with some antiplane reacting forces to appear cracks

    然後將界面任意形孔洞和孔邊裂紋對sh波的散射問題視為「契合」問題：即從兩個相互契合的完整彈性半空間的界面波動問題和彈性均勻介質中任意形孔洞對sh波散射的解答出發，沿界面處將含孔洞的彈性空間剖分為兩個含有任意形凹陷的彈性半空間，在其剖分表面上加置未知的反平面荷載，在出現裂紋的位置加置反平面反力構造出裂紋。
  19. The works in detail are as follows : 1. base on the essential solution for a complete elastic half space impacted by antiplane line source loading at horizontal surface, the essential solution of displacement field for an elastic half space with an arbitrary - shape - canyon impacted by antiplane harmonic line source loading at horizontal surface is constructed by using the method of complex function and conformal mapping

    從完整的彈性半空間表面承受線源荷載作用問題的基本解出發，用復變函數的保角映射方法獲得含有任意形凹陷的彈性半空間在其水平面上任意一點承受時間諧和的反平面線源荷載作用時位移場的解答，即本文的green函數。
  20. Breast cancer may produce inconspicuous symptoms at early stage. possible symptoms may include breast lump, changing in shape or symmetry of the breasts, in - drawing of the nipple, abnormal discharge or bleeding from the nipple, orange - skin appearance of the breast and lumps lymph nodes in the armpit

    初期乳癌的病徵並不明顯，病人可能會在乳房或腋下發現腫塊乳房形狀改變或不對稱乳頭下陷乳頭出血或有不正常分泌物和乳房表面呈橙皮凹陷狀。
分享友人
分享到 Line

分享到臉書