補償充電 的英文怎麼說

中文拼音 [bǔchángchōngdiàn]
補償充電 英文
compensating charge
  • 補 : Ⅰ動詞1 （修理; 修補） repair; mend; patch 2 （補充; 補足;填補） fill up; add supplement; supply; ...
  • 償 : 動詞1. （歸還; 抵補） repay; compensate for 2. （滿足） meet; fulfil
  • 充 : Ⅰ形容詞（滿; 充足） sufficient; full; ample Ⅱ動詞1 （裝滿; 塞住） fill; charge; stuff 2 （擔任; ...
  • 電 : Ⅰ名詞1 （有電荷存在和電荷變化的現象） electricity 2 （電報） telegram; cable Ⅱ動詞1 （觸電） give...
  • 補償 : compensate; make up; make up for; make it up to sb. ; make sth. good; compensation; offset
  1. To consider the efficiency of charge of the mh - ni battery, this method revises the ah - methods. the battery management system realized to compensates the charge efficiency through a constringent factor

    考慮到高比功率鎳氫電池的充電效率，該方法將一般的安時法加以修正，通過一個變壓縮因子實現充電效率補償。
  2. The electromagnetic unit is composed of medium - voltage transformer, compensation reactor, damper etc., the casing is filled with insulation oil

    電磁單元由中壓變壓器、補償電抗器、阻尼器等器件組成，箱體內充絕緣油。
  3. After which, the battery will be charged by large constant current to allow the fast charging. finally, the constant voltage charging is adopted to guarantee the battery was charged to its full capacity. under the condition that the temperature has raised to a certain threshold at the constant current charging stage, the over temperature circuit is performing and it provides a compensation current which switches the system to constant temperature charging mode with the intention of protecting the ic

    即在充電初期採用較小的電流對電池進行預處理，對出現過放電的電池進行修復和保護;然後採用較大的恆定電流對電池充電，實現快速充電的目的;最後採用恆定壓充電，確保電池充滿;在恆流充電階段，當晶元溫度上升到一定程度時，晶元過熱保護電路開始工作，該電路以提供充電補償電流的形式使充電進入恆溫充電模式，對晶元進行保護。
  4. In order to reduce and compensate charge phenomena at the surface of non - conductive oxide materials under the electron irradiation, oxygen environmental scanning electron microscopy ( sem ) is offered in this thesis

    本論文提出氧環境掃描電子顯微分析方法，以減輕和補償非導電氧化物類樣品在電子束輻照作用下的表面充電現象。
  5. The charger automatically compensates for low ac line voltage or extension cord use

    充電器自動補償低交流線路電壓或延長線使用。
  6. On the base of widely investigating and researching, author deems that the conventional reactive power compensation devices used by consumer had many defects with among others : lower response time, remaining residual voltage on the compensation capacitors, and so on. because of existing improper trigging time, it is impossible to realizing balance compensation for 3 - phrase unbalance loads

    本文在充分調研的基礎上，認為目前採用的傳統的無功功率補償裝置存在響應速度慢、觸發時刻不合適、補償電容器上有殘壓、不能實行三相平衡補償、對電網產生污染、不能消除負荷本身產生的高次諧波等弊病。
  7. To make pic ( particl - in - cell ) simulations. to set up models of guns and magnetic field and simulate them in the vacuum and plasma, respectively. we found that plasma held back part of space charge effects and improved trajectory of electrons. but beam would oscillate and became instable as accretion of plasma density. by simulating again and again, we draw a conclusion magic could n ' t work when plasma density was more by far than beam electron density. at last a four - stage depressed collector was simulated

    建立電子槍和聚焦系統模擬模型，分別在真空和填充等離子體條件下進行模擬。發現填充等離子體能補償部分空間電荷效應，改善電子束包絡軌跡，提高電子的流通率，但是隨著等離子體密度的增大，束電子會出現振蕩不穩定性，遺憾的是通過反復多次模擬發現本文所用粒子模擬的代表性軟體magic無法用於模擬等離子體密度遠高於束電子密度的情況。
  8. Based on the experiment of nimh battery, investigations on characteristics of discharging and charging of nimh battery, and analysis of influencing factor of nimh battery, an approach of ah ? coe ? ocu has been carried out to estimate an accurate surplus energy and state of charge of nimh batteries, and consider the compensation of the temperature, aging and self - discharging etc. after theoretic analysis has been completed, simulations are given to determine parameters of batteries for changan hev

    本文在蓄電池試驗的基礎上，分析和研究ni - mh蓄電池充放電特性及其影響因素，建立了電池內阻、電動勢模型，提出了安時?能量守恆?開路電壓演算法（ ah ? coe ? ocu法）預測蓄電池的剩餘能量和荷電狀態計算方法，並進行溫度、循環使用壽命、自放電等補償，從而建立了蓄電池的充放電模型。
  9. In order to compensate for the capacitive charging power of transmission lines, control reactive power flow, stabilize operating voltage and restrict arc current, the shunt reactors are usually installed on ehv transmission lines, especially for uhv transmission lines

    摘要超、特高壓輸電線路為了補償線路的容性充電功率，控制無功潮流，穩定網路運行電壓，限制潛供電流等，一般要安裝並聯電抗器。
  10. The technology of micro - electronics and calculation method was fully made in the system. how to improve the accuracy of standard orifice measurement is also discussed from the following aspects : the means of measurement and transmitter, online correction of measurement parameter and abnormal condition. all those means are used to overcome its shortcomings of less scale of measurement range, short period of checkout, more tache of maintenance and low accuracy of measure

    該系統充分利用微電子技術和計算技術以及通過實際現場總結的經驗，主要從測量與變送環節採取的措施、相關參數的在線實時補償演算法、非正常情況的在線補償三個方面對如何提高量精度加以論述，盡可能地彌補孔板差壓式流量計量程比較小、檢定周期短、維護環節多、準確度低的不足。
  11. The mechanisms of charge and charge compensation are discussed : we suggest electron stimulated desorption ( esd ) at the surface and inner defects induced by the electron beam bombardment are main reasons of charge

    對ys - zro2樣品加熱到230 ，使其表面充電得到改善。本文討論了在電子束輻照下， al2o3 、 sio2 、 ys - zro2等氧化物材料的充電機制，以及氧環境的充電補償機制。
  12. According to the object and principal of this rural power network building and reconstruction, combining with the specific policy of fuxin ' s structural adjustment in economy, and based on sufficient consideration of the current situation of fuxin ' s rural power network, and the experiences of myself, and after referring to a great deal of technical information, i have done the technical and economic analysis concentrated on the following aspects, such as network arrangement optimizing, building and reconstruction of transformer substation, the building and reconstruction of low voltage power network, the technical and economic analysis of transformer renewing, the inefficient power compensation in rural power network, therefore concludes the direction of fux in ' s rural power network building and reconstruction

    論文根據此次全國農村電網建設與改造的目標和原則，結合阜新地區經濟轉型的具體方針，在充分考慮阜新地區農村電網的實際現狀的基礎上，本人根據自己多年的工作經驗，在查閱了大量技術資料的基礎上，就農村電網結構優化、變電所的建設與改造、低壓配電網的建設與改造、變壓器更新技術經濟分析、農網的無功補償進行了詳盡的闡述分析。確定了阜新農村電網建設與改造的方向。
  13. The charge related to esd can be compensated by oxygen environment, oxygen environment works mainly through making up oxygen vacancy and repairing energy band distortion in time. heating the sample and reducing defect concentration can reduce the charge related to inner defects

    對于樣品表面電子受激解吸造成的充電可通過氧環境提供補償，氧環境主要是通過及時補充氧空位、修復能帶扭曲起作用的；對于電子束調制內部缺陷造成的充電可通過加熱試樣減輕缺陷濃度來補償。
  14. In order to realize automatic and intelligent control better ; and to enhance the effect of electric power system ' s reactive power compensation and the economy of power network ; and to minimizing the times of checking in or out capacitor banks makes reactive power adjustment optimum, fuzzy control technology and genetic algorithm for reactive power optimization are proposed. we also mention how to make voltage and reactive power control optimum in the integrated automatization system of substation

    為了充分實現控制的自動化與智能化，進一步提高系統無功補償的效果和電網運行的經濟性，保證無功調節達到最佳的狀態而投切的電容器次數最少，還引入了模糊控制技術和遺傳演算法進行無功優化，探討了如何在變電站綜合自動化系統中實現電壓無功的最優控制。
分享友人
分享到 Line

分享到臉書