補償平衡器 的英文怎麼說

中文拼音 [chángpínghéng]
補償平衡器 英文
compensator balancer
  • : Ⅰ動詞1 (修理; 修補) repair; mend; patch 2 (補充; 補足;填補) fill up; add supplement; supply; ...
  • : 動詞1. (歸還; 抵補) repay; compensate for 2. (滿足) meet; fulfil
  • : Ⅰ形容詞1 (沒有高低凹凸 不頃斜) flat; level; even; smooth 2 (高度相同; 不相上下) on the same l...
  • : Ⅰ名詞1 (秤桿) the graduated arm of a steelyard2 (稱重量的器具) weighing apparatus3 (姓氏) a...
  • : 名詞1. (器具) implement; utensil; ware 2. (器官) organ 3. (度量; 才能) capacity; talent 4. (姓氏) a surname
  • 補償 : compensate; make up; make up for; make it up to sb. ; make sth. good; compensation; offset
  1. Being added an anti - phase compensating winding, this device, which is placed between high voltage line and first insulator, makes the synthesized magnetic field in magnetic core reach a dynamic balance, and thus solves the problems from remanence and assures the measurement accuracy

    其漏電流傳感增加一個反相的線圈,使得電流傳感磁芯內的合成磁場達到動態,解決了由於剩磁而帶來的問題,保證了測量精度。
  2. On the base of widely investigating and researching, author deems that the conventional reactive power compensation devices used by consumer had many defects with among others : lower response time, remaining residual voltage on the compensation capacitors, and so on. because of existing improper trigging time, it is impossible to realizing balance compensation for 3 - phrase unbalance loads

    本文在充分調研的基礎上,認為目前採用的傳統的無功功率裝置存在響應速度慢、觸發時刻不合適、電容上有殘壓、不能實行三相、對電網產生污染、不能消除負荷本身產生的高次諧波等弊病。
  3. By analyzing the load factor and unbalance factor of distribution transformer, the method of calculating and selecting the low voltage reactive power compensation capacity and compensation equipments, and the connection mode of capacitors were presented

    摘要通過對配電變壓負載率和不率的分析,提出低壓無功裝置容量的計算選擇方法和電容的接線方式。
  4. Realization of the wide - band shaping filter in baseband is carefully analyzed, and then a low - cost realization method is brought forward. furthermore, through shaping filters, i / q route self - synchronization and compensation and revise of the nonlinearity and the imbalance of amplitude and phase of the modulation circuits are advanced

    分析了基帶寬帶數字成形濾波的實現難點,提出了低代價的實現方法,並利用成形濾波解決了調制端i / q自動同步,調制電路的各種非線性和幅相不校正等問題。
  5. This dissertation presented two new methods of robust adaptive track control for a class of mimo strong nonlinear system with external disturbance. one method makes use of taylor approximation principle to linearize the mimo strong nonlinear system at the ideal equilibrium point, meanwhile external disturbance is considered, and then designs two on - line neural network controller respectively, which can dynamically compensate the high order items of taylor series and the control signals at ideal equilibrium point under the drive of state error between linear and nonlinear system. a linear feedback controller obtained by pole assignment and two on - line neural network act on the practical mimo high nonlinear system together, guaranteeing the whole system robust stable and tracking the specified signal ; the other method designs three on - line neural networks for this class of system

    本文對於一類含有外部擾動的多輸入多輸出( mimo )強非線性系統,提出了兩種新的魯棒自適應跟蹤控制方法,第一種利用了taylor近似的原理,在考慮了外部擾動的情況下,將mimo強非線性系統在理想點處線性化,分別設計了兩個在線神經網路控制,在線性和非線性系統之間的狀態誤差驅動下動態系統的taylor近似高階項及理想點處的控制信號,滿足極點配置方法的線性反饋控制和兩個在線神經網路聯合作用於實際的被控mimo強非線性系統,在保證整個系統魯棒穩定性的情況下,能夠跟蹤給定的指令信號;另一種方法是針對這類系統設計了3個在線神經網路,分別實時抵消這類非線性系統中的非線性部分、與控制量耦合的非線性項以及外部擾動,使得受控系統的輸出可以完全跟蹤給定輸入參考信號。
  6. Further more, the double optical hard - limiters and balance receiver with fbgs based encoder / decoder is introduced into ocdmia system to reduce the ber of system

    此外,為了進一步降低各類ocdma系統的ber ,我們還探討了在系統中引入雙光硬限幅接收fbg編解碼的可能性和可行性。
  7. The main content of this paper is about sensors " type - selection in testing system, the sensors " fault - detection and fault - tolerance, and the correlative signal processing algorithms, providing the control system with accurate and reliable uncompensated signal and filtering - delay - compensation signal

    本文的主要內容是研究檢測系統中傳感的選型、故障檢測與容錯及相關的信號處理演算法,為控制系統提供準確可靠的未離心加速度信號和濾波延時信號。
  8. We introduce the category, property of the reactive power source and the component of the power market, including the generator, phase modifier, condenser, svc, and parallel connection reactor, and discuss the reactive power balance in power market

    介紹了無功市場中無功電源:發電機、調相機、電容、靜止、並聯電抗以及他們的特點;討論了無功市場中各組成部分以及無功市場的
  9. Unbalance compensation based on adaptive notch filter to active magnetic bearings

    基於自適應陷波的電磁軸承不方法
  10. Djw - wb, sjw - wb series of series of single - phase three - phase micro - computer superpower avr, it gathers advaned combinated roll compensation, no - touch of wsitch, and micro - motor controlhaving special function such as high efficiency, energysaving, quick adjustment, auto - balance of three phase, no machanical breakdown and carbon brush fret. especially, the avantages of timedelay, over - voltage and under - voltage protection absorbs more and more customers

    Wb系列單、三相微電腦無觸點大功率電力穩壓是集先進的組合繞組方式和無觸點開關、微機控制交流穩壓技術於一體,具有高效工能、調節快速、三相自動、無機械故障和碳刷磨損,並具有延時,過壓欠壓報警和保護功能。
  11. Study on difficulties of direct current sensor based on magnetic potential self - balance and feedback compensation

    磁勢自回饋式直流傳感難點研究
  12. According to the characteristic of nine - area diagram of substation vol / var coordinated control, this system gives the defination of fuzzy sets and the degree of membership of input / output variables, and designs corresponding control rules. the results of simulation demonstrate the system can satisfy the constrains of the day - adjusting times of the switching of on - load transformer and paralleled compensation capacitors, and ensure voltage quality, reactive power basical balance. considering the var requirement in different load time period and the control demand in load saltation, a improved control scheme is provided. the results of simulation show the improved scheme can meet the demand of vol / var in different load time period, protect the wrong operation when either voltage or reactive power appears saltation, and decrease the times of regulation of the switching of on - load transformer and paralleled compensation capacitors finally, a background software module of substation vol / var coordinated control is designed, based on the supervisory control and data acquisition system of substation

    模擬結果證明該系統能在各種負荷條件下確保電壓合格和無功基本,且能滿足變電站對有載調壓變壓分接頭日調節次數和並聯電容組的日投切次數的限制。通過考慮不同負荷時段對無功功率的需求和負荷突變情況下的控制要求,對上述模糊控制策略進行了改進,模擬結果證明改進后的控制策略能滿足不同負荷時段對電壓和無功的要求、抑制電壓或無功突變情況下的誤動作,且有效地減少了有載調壓變壓分接頭和並聯電容組的調節次數。最後基於變電站scada系統設計了一后臺電壓無功綜合控制軟體模塊。
  13. After the analysis of power produce character of the typical three - phases unbalance load, the corresponding circuit is adopted. this main circuit is composed of the power filter series and tcr control circuit. secondly the theory of band - pass filter is analyzed in detail, and then a method of implementing butterworth band - pass filter is put forward

    簡要分析了無功的基本原理和工作特點,通過對典型的三相不負載工作特點的分析,主電路採用電力濾波與晶閘管控制電抗相接合的結構;對用於無功檢測的帶通濾波進行了分析,設計了用於負載電壓、電流信號濾波的帶通濾波,並採用運算放大加以實現。
  14. The rbf network has a better performance, and better forecasting accuracy. then mathematical model of substation voltage / var control is constructed, the squares minimization of voltage differences as target, also considering requirement of voltage and power balance, taking it into consideration that the magnitude constraint of transformer ratio and compensating capacitor, also that constraint of operation times of one day transformer tap and capacitor switch

    因此提高了學習性能,具有較好的預測精度。然後,建立變電站電壓無功控制的數學模型,考慮電壓的調壓要求和無功功率,計及變壓變比和並聯電容的上下限約束,變壓分接頭和電容允許的日調節次數的限制,以電壓偏差的方和最小為目標函數。
  15. The control method of svc for unbalanced load is mainly researched in this paper

    本文主要研究用於不負載的svc無功控制
  16. This paper brings forward that asvg is capable of compensating harmonic, negative sequence and zero sequence currents. so asvg can synchronously compensate the reactive current and harmful currents in three - phase four - wire unbalanced system

    本文提出靜止無功發生還具有抑制諧波和濾除負序、零序電流的能力,從而可以用於對三相四線制不系統同時進行無功和有害電流濾除。
  17. This paper will design an h robust controller to be used acceleration state feedback, control, or, furthermore, both speed and acceleration state feedback control, which can rapidly restore synchronous state under the condition unbalanced loads or uncertain disturbances. the result of acceleration, speed and position dynamically synchronized control is achieved

    設計狀態反饋控制作為動態同步控制,對加速度進行控制,進一步,對加速度和速度同時進行控制,使系統在不負載或不確定性擾動下快速恢復同步,以實現位置、速度和加速度三重動態同步。
  18. The simulation results prove that active power filter can not only eliminate harmonic current effectively, but also have well dynamic compensation characteristics. designing of digital low pass filter and the effect of its cut off frequency on precision of instruction current are discussed in this paper

    模擬結果證明,有源電力濾波對於三相負載或三相不負載的諧波電流都起到了很好的作用;同時當負載電流突變時,有源電力濾波具有良好的動態特性。
分享友人