補償接頭 的英文怎麼說

中文拼音 [bǔchángjiētóu]
補償接頭 英文
compensating joint
  • 補 : Ⅰ動詞1 （修理; 修補） repair; mend; patch 2 （補充; 補足;填補） fill up; add supplement; supply; ...
  • 償 : 動詞1. （歸還; 抵補） repay; compensate for 2. （滿足） meet; fulfil
  • 接 : Ⅰ動詞1 （靠近;接觸） come into contact with; come close to 2 （連接; 使連接） connect; join; put ...
  • 補償 : compensate; make up; make up for; make it up to sb. ; make sth. good; compensation; offset
  • 接頭 : 1 （連接起來） connect; join; joint 2 （找人聯系） contact; get in touch with; meet 3 （了解情況...
  1. We design and manufacture a complete line of high quality standard and custom temperature sensors including thermocouples, rtd s and thermowells as well as a wide selection of junction boxes, cable and harness assemblies. in 2004, sanjac is iso 9001 : 2000 and as9100a certified that reinforced our ability in providing excellent products for our customers

    主要產品為熱電偶熱電阻隔爆耐磨普通特殊鎧裝熱電偶快速接頭表面用熱電偶熱電偶及熱電阻接線盒brskejt各種型號的溫度補償導線等，產品種類豐富種類全。
  2. Then the paper uses the same typical four network operating conditions as the primary given conditions and when adding one set of the parallel capacitor bank, changing the 330 / 220kv transformer tap changer position step by step to change the transformer ration, through this study methods this paper found out all the optimized combination of the tap changer position and the amount of input reactive power, also obtained four sets of the 330kv, 220kv and hokv s / s bus voltage and the active and reactive power losses changing curves. through analyzing the optimized combination control curve and the network power flow, the paper generalizes the rules as following : the chief measure of coordinative control is inputting shunt reactor in chengxian s / s in winter time both in the planning year of 2010 & 2005 ; in summer time in planning year of 2010 the chief measure is to input proper shunt capacitor

    本研究通過分析所獲得的最優綜合控制組合曲線及電網潮流，總結出了如下規則：隴南電網在2005年及2010年冬大、以及2005年夏小運行方式下，綜合控制應以成縣變投入適量並聯補償電抗器作為主要措施；在2010年夏小運行方式下則投入適量並聯補償電容器作為主要措施，再輔助以選擇合適的主變有載調壓分接頭來調節，達到控制網內無功潮流分佈合理、各變電站母線電壓在理想的范圍內時電網有功損耗最小，從而也提高了電網安全運行水平及供電質量。
  3. With the consideration of most of our transformers " taps are changed manually and some fluctuate unnecessarily, this paper presents a supervision system of oltc based on plc control technique. then we combine this system with reactive power compensate device such as shunt capacitor to design a new supervision system of substation voltage and reactive power synthetic control based on plc fieldbus

    針對國內變電站電壓調整大多依靠人工調節，且有載調壓變壓器（ oltc ）分接頭動作頻繁的特點，本文提出了基於plc控制技術的有載調壓監控系統的研製方法，並以此監控系統為基礎，結合併聯補償電容器組等無功補償設備，設計了一種基於plc現場總線的變電站電壓無功監控系統。
  4. This type of joint have been widelu used in the steel pipeline system for connection, it has a very good self - compensation performance while temperature change and angle deviation of the pipeline axis

    鍛壓卡箍式柔性管道接頭該產品具有溫度自補償和角度自補償功能，是鋼制管道系統中廣泛應用的聯接件，其結構合理、耐壓強度高、密封性能好，安裝維修方便。
  5. The reactive power optimization compensation is to find the suitable compensation place and the best compensation capacitance by adjusting the generator bus voltages, transform taps and reactive compensation capacities in the condition of satisfying power load requirement, which can guarantee the secure and high quality power for consumers. the improved genetic algorithm is applied in this thesis according to the features of reactive power optimization of high voltage transmission bus, which are the non - linear problems with multi - variables and multi - restrictions

    電網無功優化補償是在有功潮流調度給定的情況下，以負荷節點電壓和線路輸送無功功率作為狀態變量，運用優化演算法，調節發電機節點電壓、變壓器可調分接頭和無功補償裝置，在滿足電力負荷的要求下，尋求合理的無功補償點和最佳補償容量，保證電網能夠安全、優質地向用戶供電。
  6. In order to ensure the whole system operate economically, power department equip transformer with onload tap changer and shunt capacitors for most distribution substations, according to the operating condition, adjusting the position of transformer taps and capacitors can control the variation of voltage and reactive power exchanger of distribution substations and power system in certain extent

    為確保整個系統運行經濟性，降低網損，電力部門在大多數變電站配置了有載調壓變壓器和並聯補償電容器組，根據運行情況適當調節變壓器分接頭的位置和投切並聯補償電容器組，可以降低電壓變化和變電站與系統的無功交換控制在一定的范圍內，確保供電質量和電網運行的經濟性。
  7. It is difficult to estimate indent depth in theory. this paper presents two methods to estimate the relationship between dent depth and contact force, respectively amend method and deflection compensate method, which are developed by using a clear geometrical relation to express indent, incursion profile and deflection difference

    本文以一種新的觀點，用一個明確的幾何關系來確定壓痕、壓頭與板的接觸面剖面及接觸中心點與邊界點之間的撓度差三者之間的關系，提出兩種近似預測接觸力與壓痕深度關系的方法? ?修正法和撓度補償法。
  8. Making use of the idea of the parallel genetic algorithms, presenting the adaptive multiple subpopulation evolutive strategy. presenting extinction and immigration strategy in order to avoid the similar or even same individuals appear. in order to enhance convergence velocity of reactive power optimization of the radial distribution system, combining the characteristic of the radial distribution system, a sensitivity analysis approach was build up for optimal selection of capacitors and mutation of transformer tap changer

    為了提高配電網無功優化的收斂速度，結合配電網的特點，提出採用簡單可行的靈敏度公式選擇無功電容補償器的安裝地點，並用靈敏度分析變異變壓器分接頭，使變異運算元的選取更符合配電網無功優化問題中關于調節變壓器分接頭的實際情況，減少了一些不必要的變異運算，使適應性和魯棒性加強；根據實際情況採用無功補償電容器的啟發式變異，使變異運算元的選取更符合無功優化問題中關于補償電容器的實際。
  9. Circuit breakers, three - pole, temperature compensated, rated currents 20 a to 50 a. unc thread terminals - product standard

    額定電流為20a至50a的溫度補償的三極電路斷路器. unc螺紋接頭.產品標準
  10. Circuit breakers, single - pole, temperature compensated, rated currents 20 a to 50 a. unc thread terminals - product standard

    額定電流為20a至50a的溫度補償的單極電路斷路器. unc螺紋接頭.產品標準
  11. Circuit breakers, three - pole, temperature compensated, rated currents 20 a to 50 a. metric thread terminals - product standard

    額定電流為20a至50a的溫度補償的三極電路斷路器.米制螺紋接頭.產品標準
  12. Abstract : the principle concept of long life sealing riveting, features of rivet with compensating tip and the special requirements on composite riveting are introduced

    文摘:介紹了長壽命密封鉚接的基本概念、帶補償頭鉚釘的特點以及復合材料鉚接的特殊要求。
  13. Circuit breakers, three - pole, temperature compensated, rated currents 2a to 25a, switching capacity 65 in - unc thread terminals - product standard

    轉換容量為65 in ，額定電流為2a至25a的溫度補償的三級電路斷路器. unc螺紋接頭.產品標準
  14. Circuit breakers, single - pole, temperature compensated, rated currents 1 a to 25 a, switching capacity 65 in 1000 a max - unc thread terminals - product standard

    最大轉換容量為65 in 1000 a ，額定電流為1a至25a的溫度補償的單極電路斷路器. unc螺紋接頭.產品標準
  15. According to the characteristic of nine - area diagram of substation vol / var coordinated control, this system gives the defination of fuzzy sets and the degree of membership of input / output variables, and designs corresponding control rules. the results of simulation demonstrate the system can satisfy the constrains of the day - adjusting times of the switching of on - load transformer and paralleled compensation capacitors, and ensure voltage quality, reactive power basical balance. considering the var requirement in different load time period and the control demand in load saltation, a improved control scheme is provided. the results of simulation show the improved scheme can meet the demand of vol / var in different load time period, protect the wrong operation when either voltage or reactive power appears saltation, and decrease the times of regulation of the switching of on - load transformer and paralleled compensation capacitors finally, a background software module of substation vol / var coordinated control is designed, based on the supervisory control and data acquisition system of substation

    模擬結果證明該系統能在各種負荷條件下確保電壓合格和無功基本平衡，且能滿足變電站對有載調壓變壓器分接頭日調節次數和並聯補償電容器組的日投切次數的限制。通過考慮不同負荷時段對無功功率的需求和負荷突變情況下的控制要求，對上述模糊控制策略進行了改進，模擬結果證明改進后的控制策略能滿足不同負荷時段對電壓和無功的要求、抑制電壓或無功突變情況下的誤動作，且有效地減少了有載調壓變壓器分接頭和並聯補償電容器組的調節次數。最後基於變電站scada系統設計了一后臺電壓無功綜合控制軟體模塊。
  16. The rbf network has a better performance, and better forecasting accuracy. then mathematical model of substation voltage / var control is constructed, the squares minimization of voltage differences as target, also considering requirement of voltage and power balance, taking it into consideration that the magnitude constraint of transformer ratio and compensating capacitor, also that constraint of operation times of one day transformer tap and capacitor switch

    因此提高了學習性能，具有較好的預測精度。然後，建立變電站電壓無功控制的數學模型，考慮電壓的調壓要求和無功功率平衡，計及變壓器變比和並聯補償電容的上下限約束，變壓器分接頭和電容器允許的日調節次數的限制，以電壓偏差的平方和最小為目標函數。
  17. Then reactive power optimizing calculation is figured out on the chongqing power network on condition that the loss minimum of the active power network is object function, taking account of the limit of voltage restriction condition, adopting three mode of generators adjustment reactive power compensation and tap change. it achieves satisfaction result, expectable purposes of reducing voltage and active loss

    然後以系統有功網損最小為目標，考慮電壓約束條件的限制，採用發電機調節、無功補償、分接頭調整三種調控方式對重慶電網低谷時段的運行方式進行了無功優化計算和分析，取得了滿意的結果，達到了預期的降壓目的，減少了網損。
  18. Circuit breakers, single - pole, temperature compensated, rated currents 20 a to 50 a. metric thread terminals - product standard

    額定電流為20a至50a的溫度補償的單極電路斷路器.米制螺紋接頭.產品標準
  19. Circuit breakers, three - pole, temperature compensated, rated currents 2a to 25a, switching capacity 65 in - metric thread terminals - product standard

    轉換容量為65 in ，額定電流為2a至25a的溫度補償的三級電路斷路器.米制螺紋接頭.產品標準
  20. Piping sleeve compensatory couplings

    管路松套補償接頭
分享友人
分享到 Line

分享到臉書