補償曲線曲度 的英文怎麼說

中文拼音 [bǔchángqūxiànqūdù]
補償曲線曲度 英文
prominence of compensating curve
  • 補 : Ⅰ動詞1 （修理; 修補） repair; mend; patch 2 （補充; 補足;填補） fill up; add supplement; supply; ...
  • 償 : 動詞1. （歸還; 抵補） repay; compensate for 2. （滿足） meet; fulfil
  • 曲 : 曲名詞1 （一種韻文形式） qu a type of verse for singing which emerged in the southern song and ji...
  • 線 : 名詞1 （用絲、棉、金屬等製成的細長的東西） thread; string; wire 2 [數學] （一個點任意移動所構成的...
  • 度 : 度動詞[書面語] （推測; 估計） surmise; estimate
  • 補償 : compensate; make up; make up for; make it up to sb. ; make sth. good; compensation; offset
  • 曲線 : [數學] curve; bight; bought; profile; net曲線板 french curve; irregular curve; curve board; splin...
  • 曲度 : camber; curvature; degree of curvature; [土] degree of curve曲度計 cyrtometer; kyrtometer
  1. In order to obtain the most economic benefits, the paper utilized the theory of " homalographic characteristic " and " share alike compensation current characteristic " to build up the best compensation relation for " hour - current " curve applied to transformer substation and for " length - current " curve applied to distribution line

    以獲得最大經濟效益為目標，利用「等面積特性」和「補償電流等分特性」理論。推導了應用於變電站的「時間?電流」曲線關系中存在的最佳補償關系，以及應用於配電線路的「長度?電流」曲線關系中存在的最佳補償關系，及補償后的經濟效益計算模型。
  2. In the paper, the four methods based on the evaluation of source ’ s reactive power are analyzed. those are voltage sensitivity ( vs ), pv curves, back - up generation and equivalent reactive compensation ( erc ) methods

    由此文章分析了四種評估無功容量價值的方法:電壓靈敏度法、 pv曲線法、備用發電量法和等效無功補償法。
  3. First from system aspect, this paper uses voltage sensitivity, pv curves method, equivalent reactive compensation method, back - up generation method to evaluate the reactive value of the generators in seven buses system and ieee 14 buses system. the vs and pv methods can evaluate the source ' s ability of tracking the load ' s variation. the erc and back - up methods can evaluate the availability of replacing other generators. the value determines the cost

    從對系統貢獻角度，採用電壓靈敏度方法（ vs法） 、 pv曲線法、等效無功補償法（ erc ） 、無功備用方法來確定一個七節點系統中的發電機的無功價值和ieee14節點系統的發電機的無功價值，電壓靈敏度法和pv曲線法可比較出不同電源跟蹤負荷變化的靈敏度大小，而等效無功補償法和無功備用方法可比較出不同電源替換其它發電機是否是最有效率的。
  4. The techniques of the barometric height measurement are researched, which is calibrated by gps information and compensated by temperature information. the barometric height measurement channel of high resolution is designed with the help of curve - fitting and digital filtering algorithm

    研究了利用gps校準零點、帶溫度補償的氣壓高度測量技術，通過曲線擬合與數字濾波技術，設計了具有較高解析度的氣壓高度測量通道。
  5. From the result we get the following conclusion : for narrow - band signal, the effect of the method based on fft is best. for wide - band signal, when snr is up to certain degree ( higher than - 7db or so ), the curves of square error of modified methods are more obvious and closer to crb. for an echo composed of more than one frequency or direction, space - frequency distribution could show more direct information of frequency and direction, which is more advantaged to make precise judge and estimation for doa of echo

    從估計結果發現，對于窄帶回波信號，基於fft的方法估計性能大大優于其他方法；對于寬帶回波信號，在信噪比達到一定程度（高於約- 7db ）時，補償后的幾種估計法的性能改善均比較明顯，誤差曲線越來越接近crb曲線；對于回波中存在多頻率多方位的情況，空間?頻率分布圖能提供較為直觀的頻率及方位信息，因此應用空間?頻率估計法來進行方位估計，更有利於進一步對回波的具體方位進行準確判斷和估計。
  6. Several materials with large coefficient of expansion were selected to make packaging components, and it was found that the packaging materials have good temperature sensitivity and compatibility with optical fibers. experimental accuracy and repetition of fbg temperature sensitivity and compensation were discussed. have selected several materials which has bigger coefficient of expansion to do packaging components, have made many temperature experiments, there have not flaws, such as aging, crackle, absciss layer, packaging materials have good temperature sensitivity and compatibility with optical fiber ; have designed the simple and practical packaging components, have performed a serials of experiments about accuracy and repetition of fbg wave - length, have obtained the first step conclusion ; have analyzed the result and made comparison between the result of different experiment, have summarized the best packaging effect and several rules to reduce mistskes

    本文所做的主要工作包括以下幾個內容：一、選取了常見的熱膨脹系數大的材料製作封裝元件，經過多次一80到80反復測試，封裝元件沒有出現老化開裂、封裝裂紋、空洞、離層等缺陷，封裝材料具有良好的溫敏穩定性及復用性，與光纖相容性較好；二、對光纖光柵進行簡單、實用的封裝處理，就封裝效果的優劣性、波長測量的準確度、重復性和封裝時產生的波長損失等方面進行了一系列的實驗，得出了初步的結論；三、對溫敏和溫度補償式封裝的實驗數據進行了詳細的分析和對比，從數字上對溫變過程中光纖光柵中心波長的改變及溫變曲線進行了定量的分析，在大量實驗數據分析結果的基礎上，總結出哪種材料封裝效果更好，以及如何有效的減小實驗誤差。
  7. For compensating the nonlinear error between winding current and the result magnetic field of stepper motor, the method of minimum square is adopted to fit and correct the error curve of subdivision step angle, and the subdivision precision is improved

    為了補償步進電機相繞組電流與其產生磁場之間非線性引起的誤差，採用了最小二乘法對細分步距角誤差曲線進行了擬合與修正，提高了細分精度。
  8. In practice, it ’ s very hard to find any ideal scatter points to track, so this thesis focuses on the motion compensation algorithm base on motion parameters estimation, which is used in r - d fft imaging algorithm and verified by simulation. work of this thesis contains : first analyze the signal - processing model of isar system in detail, and establish a 3 - dimensional mathematical scattering model of moving target. then some improvements are made on existing compensation algorithm, to get a higher image quality and reduce compute burden

    本論文有以下幾點創新: 1 .在距離向的補償（包絡對齊）方面，採用基準相關法代替相鄰相關法或積累相關法，一定程度上解決了可能出現的包絡漂移和包絡突跳現象;根據目標運動軌跡特點，採用二次曲線擬合的方法，將包絡對齊時的局部誤差轉化為全局的誤差，以便實現較優的整體對齊效果。
  9. This paper has got an analytical expression with temperature information by curve matching technique, by this means, we can not only predigest hardware circuit but also realize the function of selfrevision and selfcompensation

    本論文應用曲線擬合技術，融入溫度信息，得出帶有溫度信息的壓力解析表達式，此方法簡化硬體電路且可實現自校正自補償功能。
  10. First, the frequency - temperature ( f - t ) characteristic of quartz crystal resonator is analyzed. then, the frequency - temperature ( f - t ) characteristic curve of at - cut quartz crystal resonator ( at cut angle : 3 = 0, 1 = 35 6 ) is obtained based on analyzing the christoffel equation describing flexibility sound wave in solids, which serves as the theory basis used for temperature compensated, from which the actual circuit of oscillatory circuit is designed

    首先對石英晶體諧振器的頻溫特性進行分析，然後通過求解描述固體中彈性聲波的christoffel方程，得到其在切角3 = 0 ， 1 = 356處也即at切石英晶體諧振器的頻率溫度特性曲線，這是本文進行溫度補償的理論依據。
  11. Automatic slope control. a device which automatically changes the slope of an amplifier ' s curve to compensate for temperature changes

    自動斜率控制。自動改變放大器曲線斜率以補償溫度變化的一種設備。
  12. The program we made can calculate all kinds of compensating errors of quadric curve whose calculation accuracy can reach 10 - 6mm. the machining tools we devised can perform the functions of interception of quadric curves and errors compensation, which meets the demand of basic movements

    編制出的程序可計算出各種二次曲線的補償誤差，精度可達10 ~ （ - 6 ） mm ，設計出的加工機床可完成二次曲線的截取，補償等功能，滿足基本運動要求。
  13. Finally, some methods of digital processing techniques, such as polynomial curve fitting and exponential curve fitting and subsection curve fitting, are used firstly to compensate the performance of the detector. the measurement accuracy of the reader is improved, with the validity proved

    首次運用了多項式曲線擬合技術、指數曲線擬合技術以及採用分段擬合的技術，補償檢波器的性能，提高了通信系統的測量精度，應用效果顯著。
  14. Secondly, against the problem that the linearity of inductive micrometer is poor in wide ranges, it compares with the usual methods of non - linearity compensation, and then determines the method used in the system based on the research of characteristic curve of sensor in detail. then, it gives the detailed designs of the embedded application software and the arithmetic of non - linearity compensation. finally, the paper deals with experimental data and analyses the experimental results, with a conclusion shows that the polynomial fitting is a useful method to solve non - linearity of inductive micrometer

    首先，針對電感位移傳感器數據處理量大、實時要求性高的特點，確定採用嵌入式處理晶元pxa271作為處理器，並根據實際需要確定性能指標;然後，針對電感位移傳感器在大范圍內線性度差的問題，通過對常用的非線性補償方法進行比較，在詳細研究傳感器特性曲線的基礎上，選用分段多項式擬合的方案進行補償;在此基礎上，對嵌入式應用軟體設計給出了詳細的設計流程和分析說明，最後，對設計的系統進行實驗和數據分析，處理的結果滿足設計的性能指標，說明分段多項式線性擬合的方法在解決電感微位移傳感器非線性問題上是可行的。
  15. The sonic logging is applied to the correction of density logs in condition of less distortion of compensated sonic logs ; the density logging is used to the correction of logs in the case of severe distortion of sonic and density logs

    前者主要應用在補償聲波失真較小情況下密度測井曲線的校正，後者應用於聲波、密度都出現嚴重失真情況下的曲線校正。
  16. Aiming at drawbacks that environment simulate test laboratory ( estl ) ' s control precision is being dropped, the system digital simulation, the system characteristic analysis is proceeded ; basing on it, intelligence pid control processor, integral desaturation pid control processor, leading adjust control processor ( leading adjust of point of inflection of curve ) is planned, double loop control processors of low temperature system is consummated, so, the new control scheme and control program is formulated ; moreover through control program " simulate debugging and environment simulate test, 18 experimental curves and 19 experimental items is fulfilled totally. it proved that estl ' s control system and control program are successful. experimental result makes it known that the new control plan solves the problem of low control precision

    本論文針對環模室原控制系統存在的控制精度下降等問題，進行了系統模擬及環境模擬系統特性分析，在此基礎上，設計了智能pid控制器、抗積分飽和的控制器、預估補償控制器、完善了低溫系統的雙迴路控制，制定了新的控制方案和控製程序組態，並對其控製程序進行模擬調試及結合實際試驗對其控制系統進行驗證；共計完成了18條曲線， 19個項目的試驗，對其控制系統及控製程序進行了充分的考驗。
分享友人
分享到 Line

分享到臉書