角誤差 的英文怎麼說

中文拼音 [jiǎochā]
角誤差 英文
angle error; angular divergence; misalignment角誤差檢測器 angle-error detector; 角誤差靈敏度 angle-error sensitivity; 角誤差顯示器 angular error indicator
  • : 角Ⅰ名詞1 (牛、羊、 鹿等頭上長出的堅硬的東西) horn 2 (古時軍中吹的樂器) bugle; horn 3 (形狀像...
  • : Ⅰ名詞(錯誤) mistake; error Ⅱ動詞1 (弄錯) mistake; misunderstand 2 (耽誤) miss 3 (使受損害...
  • : 差Ⅰ名詞1 (不相同; 不相合) difference; dissimilarity 2 (差錯) mistake 3 [數學] (差數) differ...
  • 誤差 : error
  1. Fourthly, this paper standardizes the linear of the inductance sensor and analyzes its error. then we discuss the angle error of the laser sensor and the datum plane error of the mechanism. finally, the paper gives some advice to improve the mechanism

    第四,此外,本文還對電感傳感器進行了線性校正及分析,討論了激光傳感器傾角誤差,並對機械設計中的定位結構進行了分析,提出了改進的措施。
  2. The model of influence upon the parallel between servo optic axis from the angle error of installation plans presented. whereby the theoretic analysis is carried out and the analyzing results are obtained. the method of obtaining the angle error through measuring the installation plans with three - coordinates measuring device and fitting the measurement data is put forward and pave a road for lessening the influence

    對安裝面角誤差影響隨動光軸平行性的問題也建立了數學模型,以此為出發點進行理論分析,給出了分析結果;提出用三坐標測量機測量安裝面,通過擬合得到安裝面的角誤差;從而為減小這一源對隨動光軸平行性的影響鋪平了道路。
  3. Its main contributions include the following several aspects : firstly, the dissertation constructs the mathematic model of short baseline orientation determination using two geostationary satellites and analyses the applicable conditions of carrier phase interferometry. orientation determination precision is analysed in depth through both the conventional linearized method and monte - carlo computer simulation method, and the mathematical simulation results show that the linearized method has the shortcoming of fairly low elevation error analysis precision in high latitude area so as not to be very appropriate there. by analyzing the definite factors influencing orientation precision, the dissertation develops the concept of orientation dilution of precision, which uncovers the internal cause of exotic error behavior of bi - satellite orientation, and has important guiding significance for practical engineering applications

    本文系統地研究了基於「北斗一號」衛星載波相位干涉測量原理實現地球靜止雙星定向的相關技術,主要研究成果包括以下幾方面:首先,建立了利用兩顆地球靜止軌道衛星進行短基線定向的數學模型,分析了載波相位干涉測量的適用條件;採用傳統的線性化解析法及蒙特卡洛隨機模擬法兩種途徑對雙星定向的精度進行了詳細分析,數學模擬結果表明在高緯度地區線性化解析法由於俯仰角誤差分析精度略有下降而不太適合;在分析定向精度確定性影響因素的基礎上,提出了雙星定向精度衰減因子odop的概念,揭示了雙星定向特殊表現的內部機理,對實際工程應用具有重要的指導意義。
  4. Angular calibration of radar antenna system is composed of the calibration of angular error sensitivities ( also called directional sensitivity ), adjustment of cross - coupling of azimuth and elevation signals, and the calibrations of system errors such as antenna axial system error, dynamic delay and so on

    雷達系統天線的度標校包括對系統角誤差靈敏度(又稱定向靈敏度)的標定、方位俯仰信號交叉耦合的調整以及對天線軸系、動態滯后等系統的標定。
  5. The compensative relations between the tilt angular errors and groove - width difference were obtained and the compensative methods were discussed

    針對光柵拼接中的轉角誤差和光柵常數,得到了間的相互補償關系式,並對補償方式進行了討論。
  6. After the construct of the motion simulation model, genetic algorithm is used to do the adjustment of pid parameters of the control system of the joint motors, integral separation pid control and angle error analysis is finished, and three force / torque sensors, touch sensors, distance sensors and photoelectric switches are calibrated and installed

    在建立了機器人關節控制系統模型后,使用遺傳演算法對其關節電機控制系統進行pid參數整定,進行機器人關節的積分分離的pid控制策略和轉角誤差的理論分析,並進行了機器人三維力/力矩傳感器、接觸傳感器、測距傳感器和光電開關的標定與安裝。
  7. Effect of attack angle messurement error on extracting aerodynamic coefficients

    角誤差對擬合氣動系數的影響
  8. Four corners error correction of es - j series electronic balances

    系列電子天平四角誤差的調整方法
  9. The measuring system of television tracing and error of angles measurement

    電視跟蹤測量系統跟蹤和測角誤差的檢測
  10. According to the uncertainty theory, this paper analyzes how the technical criteria influence the accuracy of angle measurement and gets synthetical formula of angle measuring error

    論文研究了接收機各項技術指標對測精度綜合影響的問題,基於不確定度理論,得出了測角誤差的合成公式。
  11. Acceleration misalignment coefficient

    加速角誤差系數
  12. Tolerance of angle of advance

    提前角誤差
  13. This paper also analyses how to realize distribution of angle measuring error when we are given to the certain error of angle measurement

    論文還分析了在給定測角誤差情況下,如何實現測角誤差分配。
  14. 2. the factors which cause measurement angle errors are analyzed, and the modifications are studied to use in line extraction algorithm for plane _ plane intersection

    2 .分析了靶場試驗中引起經緯儀測角誤差的各項因素,並研究如何在面面交會方法中進行測角誤差修正。
  15. When the signal of gps is lost for five minutes, the position error is about 1400 meters, its velocity error is about 15m / s and its attitude angle error is about 10 degree

    在gps信號丟失5分鐘時,位置大約為1400米,速度大約為15米/秒,姿態角誤差大約為10度。
  16. This calibration came down all error effects to joint errors and need not resolve the inverse kinematics model, and achieved arbitrary joint errors real - time compensation

    這種標定方法把所有因素引起的均歸結為關節角誤差,無須求解機器人逆運動學方程,實現了的在線補償。
  17. At the end of the chapter, the output of hrg is used in the simulation. the result indicates that the eular angle error is lower after flp filtering if proper step size is chosen

    本文還把半球諧振陀螺實際數據引入該演算法的模擬,模擬的結果表明,選擇合適的階數可以使flp濾波后的歐拉角誤差小於濾波前。
  18. We prove theoretically that under certain reasonable assumptions the formation is asymptotically stable even wills bounded disturbances ; that is, the proposed sliding mode controller can asymptotically stabilize the errors in relative distance, relative bearing and heading direction, respectively

    在合理的假設下,從理論上證明了存在有界干擾情形下機器人編隊的漸近穩定性,即所設計的滑模控制器使得相對距離、方位角誤差及運動方向漸近穩定。
  19. For compensating the nonlinear error between winding current and the result magnetic field of stepper motor, the method of minimum square is adopted to fit and correct the error curve of subdivision step angle, and the subdivision precision is improved

    為了補償步進電機相繞組電流與其產生磁場之間非線性引起的,採用了最小二乘法對細分步距角誤差曲線進行了擬合與修正,提高了細分精度。
  20. The position errors are measured by two dimension single - frequency laser interferometer, the pitch and yaw errors are tested using phase shifting interferometer with a resolution of 0. 1nm, the linearity along motion axis is investigated by autocollimator with 0. 01 " uncertainty

    利用單頻激光干涉儀測試其運動定位特性,相位偏移干涉法測試運動轉角誤差,光電自準儀測試其運動偏擺
分享友人