計算所得數值 的英文怎麼說

中文拼音 [jìsuànsuǒdeshǔzhí]
計算所得數值 英文
computed value
  • 計 : Ⅰ動詞1 （計算） count; compute; calculate; number 2 （設想; 打算） plan; plot Ⅱ名詞1 （測量或計算...
  • 算 : Ⅰ動詞1 （計算數目） calculate; reckon; compute; figure 2 （計算進去） include; count 3 （謀劃;計...
  • 數 : 數副詞（屢次） frequently; repeatedly
  • 計算 : 1 （求得未知數） count; compute; calculate; reckon; enumerate 2 （考慮; 籌劃） consideration; pla...
  • 數值 : numerical value; numerial number; figure; magnitude; value數值表 numerical tabular; 數值天氣預報 ...
  1. That describes both how the counter interacts with a monitoring application and the nature of the values it contains for example, calculated or uncalculated

    ，它既描述計數器如何與監視應用程序交互，又描述計數器包含的值的特性（例如計算所得和非計算所得） 。
  2. In this paper, the sensibility analysis of the factors affecting the temperature in well bore is relatively systematically made by using a large number of the data calculated with the borehole flow and heat transfer 3 ? d numerical model proposed by the author. the study shows that the thermophysical parameters of the drilling fluid and formation, etc. and the entrance temperature and circulating capacity, etc. of drilling fluid have a greater influence on the temperature in well bore. therefore, accurately mastering the thermophysical parameter values of penetrated formation and drilling fluid in well bore, considering the influence of the temperature and pressure on thermophysical parameters and accurately measuring such parameters as entrance temperature and discharge capacity of drilling fluid, etc. are of utmost importance for accurately simulating the temperature in well bore

    利用由作者提出的井內流動和傳熱的三維數值模型計算所得的大量數據，文章對影響井內溫度的諸多因素進行了較系統的敏感性分析，研究表明：鉆井液和地層等的熱物理參數以及鉆井液的入口溫度、循環排量等對井內溫度有較大影響，因此，準確掌握所鉆地區地層和井內鉆井液的熱物理參數值，考慮溫度壓力對熱物理參數的影響，準確測量鉆井液的入口溫度、排量等參數值，對于井內溫度的準確模擬至關重要。
  3. The numerical simulation was made on this kind of energy dissipator by using the k - s turbulence model, the full - field distribution of the time - averaged parameter and the turbulence parameter are described in detail, the calculated time - averaged pressure has good agreement with the experimental results, some advice can be provided for the further study and application in this thesis, especially the calculated results can be used to check the lowest time - averaged pressure

    本文對洞塞式消能工採用軸對稱的k -模型進行了數值模擬，數值模擬結果詳細地描述了時均流參數和紊動參數的全場分佈，計算所得的壁面時均壓力結果與實驗結果相吻合，獲得了實體試驗難以獲得的流動特徵。可供這種消能工的進一步研究和應用提供參考，特別是可用於檢驗壓力最低點的大小。
  4. Detailed numerical simulation of krain impeller at design operating condition is made, the computed results, such as circumferentially averaged shroud static pressure distribution, meridional velocity and relative flow angel et al., show good agreement with experimental data

    對krain高速離心葉輪在設計工況下的內部流場進行了詳細的數值模擬，計算所得輪蓋壓力分佈、子午速度及相對氣流角分佈與實驗結果吻合較好，並且進一步加深了對二次流機理的認識。
  5. The linear relation assumes between the mean characteristic parameter, sorting coefficient, variation coefficient of pore structure by rectangular method and the fractal dimension by integrated linear regression, indicating that the fractal dimensions can be used to quantitatively describe the heterogeneity of reservoirs

    用由矩法計算所得孔隙結構特徵參數均值、分選系數及變異系數與用整體線形回歸所得分形維數的線性關系說明，用分形維數來定量描述儲集層非均質性是可行的。
  6. The matching rate of the suggested two methods were compared for the assembly size chaims with different number of the forming links, with different number of the forming link parts, and with different deviation distribution types on the assumption that the closing link tolerance of the selective assembly is a tenth of that calcalated by the extremum method

    以不同組成環數、不同組成環零件數、不同偏差分佈類型的裝配尺寸鏈為研究對象，取選擇裝配的封閉環公差為按極值法計算所得封閉環公差的十分之一，以匹配率為評價指標，比較了兩種方法的優劣。
  7. 3. the simulation results between the general 140mm gun and the series chamber gun have been compared to describe the advantages of the series chamber technology

    將計算所得的常規裝藥情況下的數值結果與串聯多藥室裝藥情況下的數值結果進行分析比較。
  8. The analytic expression for the spatial bright solitions obtained under the weak light intensity agrees well with the results obtained by the numerical calculation

    結果表明，在低振幅條件下空間明孤子的解析表達式與數值計算所得到的結果十分吻合。
  9. Computes the calculated value of a raw counter sample

    對原始計數器樣本的計算所得值進行運算。
  10. Obtains a counter sample and returns the calculated value for it

    獲取計數器樣本並為其返回計算所得值。
  11. You can retrieve the current calculated value for a counter using the

    方法，可以檢索計數器的當前計算所得值。
  12. Base on the experimental data some damping models such as conic model, inverse hyperbola model, exponent model, inverse exponent model, dislocation - induced damping model are put forward, and the results between numerical calculations base on above models and experiments are studied contrastively

    給出了二次曲線模型、反雙曲線模型、指數模型、反指數模型、位錯阻尼模型等阻尼模型並將按這些模型進行數值計算所得結果和實驗結果進行了對比研究。
  13. By the experiment of tension and torsion test of thin walled tube on mts, the experimental strain increment was obtained and compared with theoretical strain increment which obtained by simulation with m value 2 and the identified m value. the results of comparison validated the correctness of identified m and deformation control method using the identified m

    本文在mts實驗機上進行了薄壁管拉扭實驗，首先進行了識別材料物性參數m值的實驗，通過實驗中各階段的實際應變增量值與m值識別前後計算所得理論應變增量值的比較，驗證了識別所得m值的正確性以及根據識別所得m值進行應變控制可行性。
  14. The non uniform variation along the line of the input impedance calculated from phasor voltage to current ratio is conformed with that calculated from the phasor ratio of one plus the reflection and one minus reflection along the line

    數值驗證，由駐波電壓與駐波電流之相量比及由沿傳輸線一加反射與一減反射相量比計算所得之輸入阻抗，沿傳輸線之不均勻變化是一致的。
  15. On the basis of the design and calculation of such space truss system, this paper has analysed and summed up the experiment dataes of the wind tunnel test and made a deeply research and analysis on this kind of structure which undergoing complicated wind load. compare the wind load values which gained by calculating according to load criterion and the wind tunnel test separately and then analyze and compare the two different results got by static wind load and dynamatic ones separately. at last, analyze the two outcomes through these two different methods which in virtue of finite element program midas

    本文在鹽田碼頭閘口的工程設計基礎上，分析總結了對該建築物進行風洞試驗的試驗數據，並對利用風洞試驗數據計算所得風荷載值與按規范計算所得的風荷載值進行了比較，然後藉助有限元軟體midas對該結構在靜力風荷載作用下和動力風荷載作用下的節點位移進行了計算分析和比較。
  16. First, we develop the local search such that the search direction, search radius and numbei of search points are adjusted according to the previous search result

    首先改進了局部搜索演算法，使得搜索方向，搜索半徑和搜索所計算的函數值個數根據已有的搜索結果而自適應調整。
  17. How to : retrieve calculated performance counter values

    >如何：檢索計算所得的性能計數器值
  18. Used generally for calculated performance counter types, such as averages

    一般用於計算所得的性能計數器類型（如平均值） 。
  19. It can be found that the two models can measure the credit risk better and their numerical values of the var are relatively close, which means that at a certain confidence level, the portfolio ' s maximum loss calculated under the default model is familiar to the maximum loss in value resulted from the credit metrics model. however, under the default model the standard deviation of the loss of the loan is a bit more than the one which deviates from the average value of the loan under the credit metrics model ; in addition, the conclusion also demonstrates that the two models have some differences in the measuring the capital reserve to some extent

    從結果可以看出，這兩個模型均能較好地度量銀行貸款信用風險，其計算所得的var值比較接近，說明在給定置信水平下所能達到的最大損失和所能達到的價值上的損失在數值上是相近的；不過，違約模型下貸款損失的標準差要比creditmetrics模型下的貸款價值偏離其均值的標準差要大些；此外，結論還表現出二者在計量資本金要求上有所差異。
  20. The crack patterns calculated by this method are consistent with the test results

    用本方法進行的數值計算所得的裂縫形態與試驗結果較接近。
分享友人
分享到 Line

分享到臉書