設定值 的英文怎麼說

中文拼音 [shèdìngzhí]
設定值 英文
fixed value
  • 設 : Ⅰ動詞1 （設立; 布置） set up; establish; found 2 （籌劃） work out : 設計陷害 plot a frame up; fr...
  • 定 : Ⅰ形容詞1 （平靜; 穩定） calm; stable 2 （已經確定的; 不改變的） fixed; settled; established Ⅱ動詞...
  • 設定 : bd/ dvd settings bd/dvd
  1. Adjust the set value on the ozat ? cfs to 0 %

    將cfs臭氧發生器的設定值設為0 % 。
  2. Cipher code lock - in parameter setting value

    參數設定值密碼鎖定
  3. The specification set value of this machine is in lum unit, which is optional upon the need of tool accuracy

    此機臺規格設定值為1m單位，可依模具精度需要而選擇。
  4. Press set key at one sec is setting control value. it is set value display s number after display s - u, press or key can recompose set value, range is 1560, again press set key is backing out display the measure value. it can automatism backing out display the measure value after three sec, if it is dont press any key

    1按set鍵1s設置控制值，顯示s - p后顯示的數字為設定值，按上下鍵可修改設定值，范圍為- 50100 ，再次按set鍵返回顯示測量值，不按任何按鍵3s后也可自動返回顯示測量值。
  5. The rational transient process is set by the improving td based on the classical pid controller, which effectively reduces undershoot of non - minimum phase system

    使之用於功率設定值變化的水輪發電機組有功功率控制中，模擬結果表明了該方法的有效性。
  6. That means the controlled temperature al1ow waving in a range in a period. when the change of the temperature indoor is out of the range we enacted, the system begin to regulatc. compensate the windage last time leave behind } before decide the heatsupply parameter for the next time

    即允許被控室內溫度在一段時間內存在一定幅度的波動，當室溫變化幅度超過設定值時系統開始調節，在確定下一時間段的供熱參數之前對上一時間段的遺留偏差在短時間內給予補償。
  7. Using the digital pid control, the temperature can be controlled within the range of 300 ~ 500 with a precision of 1 and uninterrupted adjustability of temperature setting is realized

    通過採用數字pid控制，可使溫控精度在300 500 ~ c范圍內達到1 ，並可實現溫度設定值的連續可調。
  8. Through adjust the initial vaiue of the water supplied tcmperature in the second - net, the amomation systcm can auto run with a depressed standard to distribllte the energy averagely

    即當供熱能力不足時，通過調整二次供水溫度的設定值，使自動控制系統在降低供熱標準的基礎上自動運行，實現熱量的平均分配。
  9. To change the setting, simply scroll the screen area button left or right to increase or decrease the screen area size

    如欲更改設定值，您只須將設定值下方的按鈕向左方或右方拖拉，即可更改顯示尺寸。
  10. Avoiding the difficulties of detecting the difficult parameters in furnace control and of building up the models, integrated with fuzzy control and conventional pid control, abb ’ s control it system is used to predict the bloom surface and center temperature directly based on the temperature of furnace wall easily to be detected so that the temperature settings in various furnace sections can be self - corrected, the furnace temperature of each section self - adjusted and on - line parameters of combustion control self - optimized. in addition, the heating parameters and the operating status of the field plant can be monitored with alarm

    採用abb公司的controlit控制系統，避開爐子控制中遇到的困難參數檢測及建模困難等因素，直接根據容易檢測的爐壁溫度來推知鋼坯表面溫度及鋼坯中心溫度，將模糊控制技術與常規pid控制相結合，實現各段溫爐設定值自修正、各段爐溫自協調、各參數在線自整定的自尋優最佳燃燒控制;對熱工參數、現場設備的運行情況進行監視、報警，實現爐膛壓力、管道壓力、換熱器的保護控制，並將重要參數送往廠級mis網路。
  11. Abstract : the gpc or crhpc strategy with input constraints will be possible to lead to infeasibility of the control algorithm and the performance of the control system will get degradation or instable. in order to overcome this problem, a control algorithm with guaranteed feasibility is proposed in this paper. it is shown that the algorithm makes the plant asymptotically stable and drives condition setpoint close to the actual setpoint of the plant

    文摘:在系統輸入受限的情況下，採用一般的廣義預測控制或受限時域預測控制有可能會造成控制演算法不可行，從而使系統的性能變壞或不穩定.針對這個問題，本文提出一種保證可行性的控制演算法，並證明該演算法能夠使系統漸近穩定且最終使條件設定值跟蹤系統的實際設定值
  12. At the same time, the control circuit must realize power regulating of the rectifying circuit and the inverter circuit and keep some parameters impervious to the interferer. this paper has researched high frequency solid induction heating power supply

    同時，控制電路必須對整流電路、逆變電路等系統主電路部分進行功率控制，使在各種擾動下維持系統各參量不偏離其設定值。
  13. A job control statement used in cataloged or in - stream procedures. it can be used to assign default values for symbolic parameters contained in a procedure. for in - stream procedures, it is used to mark the beginning of the procedure

    在編目或流內過程中使用的一種作業控制語句，可用來對包含在過程中的符號參數賦予系統設定值。對流內過程，用來標志過程的開始。
  14. If a value of zero is specified, no magnitude limit will be imposed

    如果設定值為0則沒有星等限制。
  15. The pressure of pressure stabilizing pump will be settled on the basis of its delivery head which is not calculated but determined by the delivery head of main fire pump as the function of it is to stabilize the pressure inside the fire water system

    穩壓泵的壓力設定值決定於穩壓泵揚程，穩壓泵的揚程一般不另行計算，而是採用消防主泵的揚程，其原因在於設置穩壓泵的目的是使消防給水管網的水壓穩定。
  16. Model ftjr600 - 800 microcomputer control high - speed continuous - rolled vest bag making machine has such functions as photoelectric automatic tracking microcomputer length setting, high limit stopping, automatic counting, automatic alarm on reaching the set value, high compensation accuracy with such characteristics as neat bags, little error and high automatic of whole machine, so it is a kind of ideal equipment for producing blank bags, colorful bags, flat bags and vest bags etc and other various plastic soft packing bags

    模型ftjr600 - 800微機控制高速連續軋制背心袋製作機等功能的光電自動跟蹤，微電腦定長，高限制停車，自動計數，自動報警到達設定值，高補償精度等特點整齊袋，誤差小，高自動化整機，所以它是一種理想的生產設備空白袋，袋豐富多彩，平面袋背心袋等，以及其他各種塑料軟包裝袋。
  17. The pointer offset value and sensor gain setting value selected by this operation are not initialized by setup reset or default set operation

    這里操作選定的指針偏差值和感應增益設定值不用「歸零設定」或「錯誤重調」來清除。
  18. With compensation of signal ’ s time delay from different radiating element by phase shifters, phased - array antenna can control array beam easily. because there are no mechanical devices for rotating beam, the phased - array antenna system can scan everywhere in beam covered areas in millisecand by stepping the phase shifters. it improves the tracking velocity of antenna towards the object, and becomes the development trends of weapon system antennas

    相控陣天線利用移相器補償信號到達輻射單元時間的差異，從而控制波束方向;天線沒有機械旋轉問題，只需改變移相器的設定值，波束便可以在毫秒級內掃描其覆蓋空域內的任何地方，提高了天線對目標的跟蹤速度，是目前武器系統天線的發展方向。
  19. When it is too cold or there is not enough thermal energy in the first - nst so we can not regulate to the initial value even if the valves are all opened, we must at this time revise initial value of the t6mpeate of the second - net, lower the heat - supply standard, and make the pots which near the heat - source or far to the heatsource are both have energy to.,

    當天氣太冷或一次熱網供熱能力不足時，即便是二次熱網閥門全開也不能調節到設定值，此時必須修正二次熱網溫度設定值，降低供熱標準，使熱源近端和末端都有熱量可供，解決系統失調。
  20. We can figure out the initial value of the watcr supplied tcmperature in the second - net according to the water supplied temperature in the first - net

    根據一次熱網供水溫度計算出二次供水溫度的設定值。
分享友人
分享到 Line

分享到臉書