試樣散射 的英文怎麼說

中文拼音 [shìyàngsǎnshè]
試樣散射 英文
specimen scattering
  • 試 : 名詞（古代占卜用的器具） astrolabe
  • 樣 : Ⅰ名詞1. （形狀） appearance; shape 2. （樣品） sample; model; pattern Ⅱ量詞（表示事物的種類） kind; type
  • 散 : 散動詞1. （由聚集而分離） break up; disperse 2. （散布） distribute; disseminate; give out 3. （排除） dispel; let out
  • 射 : Ⅰ動詞1 （用推力或彈力送出） shoot; fire 2 （液體受到壓力迅速擠出） discharge in a jet 3 （放出） ...
  • 散射 : [物理學] [電學] scattering; radio scattering; scatter; dispersion
  1. The tem analysis of pa6 composites shows that optimal incorporation of nano - al2o3 into pa6 is at 10 phr of nano - al2o3, and that fillers can equably disperse in matrix

    另一方面，透射電鏡分析表明，添加量為10phr的試樣中納米a12o3粒子可以在尼龍6基體中均勻的分散。
  2. The phase structure of different cu - fe thin films were studied by using grazing incidence x - ray analysis ( gixa ). the texture and residual stress of different cu - fe thin films were measured by scan of x - ray diffraction ( xrd ) and 2 scan with different. the thicknesses of different thin films were characterized by means of small angle x - ray scattering ( saxs ) technique. by using atomic force microscope ( afm ) measured surface roughness of thin films. the component of different thin film was characterized by energy disperse spectrum ( eds ) and x - ray fluorescence ( xrf ). the magnetic properties of cu - fe thin films were measured by means of vibrating sample magnetometer ( vsm ). in addition, the giant magnetoresistance ( gmr ) effects of different films were also measured. the original resistance of the film fabricated by a direction - current magnetron sputtering system is directly affected by bias voltage

    利用掠入射x射線分析（ gixa ）技術對不同cu - fe薄膜的相結構進行了研究;利用xrd掃描及不同角度的2掃描對薄膜進行了結晶織構及殘余應力分析;運用小角x射線散射（ saxs ）技術測量了薄膜的厚度;採用原子力顯微鏡（ afm ）觀察了薄膜的表面形貌;運用能量損失譜（ eds ）及x射線熒光光譜（ xrf ）對薄膜進行了成分標定;使用振動樣品磁強計測量了不同cu - fe過飽和固溶體薄膜的磁性能;最後利用自製的磁阻性能測試設備測量了真空磁場熱處理前後不同薄膜的巨磁阻值。
  3. We tested the ambient temperature compressive strength, the ambient temperature bending strength, volume density and the porosity of the sintered composites. by means of the om, sem, and x - ray, we analyzed the composites micro - structure ; we studied the dispersion methods & the mechanism of damage of the fiber ; we also did research on the reinforced mechanism and the fabrication characteristics of the fcmc

    測試燒后試樣的常溫耐壓強度、常溫抗折強度、體積密度、氣孔率，並藉助于光學顯微鏡、掃描電鏡以及x射線衍射圖象對復合材料微觀結構進行了分析，探討了復合材料中纖維的分散方法、纖維的損傷機理、纖維增強al _ 2o _ 3復合材料的增強機理和及制備特性。
分享友人
分享到 Line

分享到臉書