試驗數據處理 的英文怎麼說

中文拼音 [shìyànshǔjùchǔlǐ]
試驗數據處理 英文
test-data reduction
  • 試 : 名詞（古代占卜用的器具） astrolabe
  • 驗 : 動詞1. （察看; 查考） examine; check; test 2. （產生預期的效果） prove effective; produce the expected result
  • 數 : 數副詞（屢次） frequently; repeatedly
  • 據 : 據Ⅰ動詞1 （占據） occupy; seize 2 （憑借; 依靠） rely on; depend on Ⅱ介詞（按照; 依據） according...
  • 處 : 處名詞1 （地方） place 2 （方面; 某一點） part; point 3 （機關或機關里一個部門） department; offi...
  • 理 : Ⅰ名詞1 （物質組織的條紋） texture; grain （in wood skin etc ） 2 （道理;事理） reason; logic; tru...
  • 試驗 : trial; experiment; test
  • 數據 : data; record; information
  1. Method of test data processing for missile used turbojet - part3 : flight test

    彈用渦輪噴氣發動機試驗數據處理方法第3部分:飛行試驗
  2. Method of test data processing for missile used turbojet - part1 : stand bed test

    彈用渦輪噴氣發動機試驗數據處理方法第1部分:臺架試驗
  3. This algorithm easily escapes from local optimal solution, have high searching efficiency, simple structure, convenient use. aiming at iteration, optimization and matlab optimization toolbox having low precision and difficulty to choose initial vector on acquiring nonlinear equations ’ solutions, equations ’ solution problem is translated into genetic algorithm optimization problem. nonlinear equations ’ usual genetic

    針對迭代法、最優法、 matlab最優化工具箱求解非線性方程組中存在求解精度不高及初始矢量難選等問題，將方程組求解問題轉化為遺傳演算法函數優化問題，建立了非線性方程組通用的遺傳演算法解法，並將其用於汽車滑行試驗數據處理中。
  4. After reading a large amount of domestic and international about shaft research materials, the thesis combines the concrete experimental condition of the laboratory, and the crankshaft crack modal parameter characteristic go on the theoretical research at different depth different position to smoothshaft, experimental study, test data processing, diagnose system developing work ect

    本論文在閱讀了大量國內外關于軸裂紋檢測的研究資料后，結合實驗室的具體試驗條件，對光軸和曲軸裂紋在不同深度不同位置時模態參數特性進行理論研究、試驗研究、試驗數據處理、診斷系統開發等工作。
  5. Two new methods have been put forward to estimate the reliability characteristic parameter. a software package has been developed to process the data obtained from reliability testing for electric apparatus. it consists of both the determination of failure distribution and the estimation of reliability characteristic parameter

    最後，設計出電器可靠性試驗數據處理軟體包，此軟體包含了產品失效分佈類型的確定和可靠性試驗結果為大子樣、小子樣、無失效數據時可靠性特徵量的估計方法，以及恆定應力加速壽命試驗數據下的可靠性特徵量的估計方法。
  6. The program of data processing in determination of percent released of pharmaceutical preparation was developed ; two modules included in this program are connected but independence each other, one module calculate percent released, one module regress equation ; determination of percent released of pharmaceutical preparation, comparison of released curve in one reference frame and modeling mathematics model were realized by running this program. the program of formulation optimization based on artificial neural network was compiled to solve the nonlinear problem in formulation optimization. provided parameters were used to predict the released amount of a set of formulations

    簡便，其計算結果與現有其他程序計算結果基本一致：開發固體制劑體外溶出試驗數據處理程序，程序運行時分為計算累積釋放百分率和優選最佳數學模型兩個相互連接又各自獨立的環節，實現了累積釋放百分率的自動計算，同一坐標系下釋放曲線的直觀比較，常用數學模型的擬合；開發基於人工神經網路的處方優化系統，解訣處方優化這一多目標、非線性優化問題，利用符合擬合精度的訓練結果預測給定處方的釋放度，預測結果與實驗結果基本相近。
  7. Adopting the mode of experiment data processing currently with computer control, the cat system is constructed, and it can contrqj hydraulic pump ' s rev and pressure

    本論文所述系統採用兼有測試試驗數據處理和計算機控制功能的微機系統模式來組建cat系統，可對液壓泵轉速和輸出壓力進行控制。
  8. Flight test graphics monitoring system is one part of flight test data processing system - ftdas - of the certain company, which completes the tasks of remote measure data adapting, remote measure data processing firstly and graphics displaying, net transmission, saving, printing of the remote measure data processed firstly, and so on

    飛行試驗圖形監視系統是某公司ftdas飛行試驗數據處理系統的一個子系統，它主要完成飛行試驗遙測數據採集，飛行試驗遙測數據的一次處理，及一次處理后的遙測參數的圖形顯示、網路傳輸、存盤、列印等任務。
  9. In order of the process of data processing arrives national standard, the article described the technology of data sign processing. compared and analyzed different methods of filter designing, chosen the method of fir with window and designed the low frequency data filter. used the software of matlab to simulate the frequency performance, which is combined with some experiments

    為了使試驗數據處理過程符合國家法規要求，本文對數字信號處理技術進行了探討，對不同的數字濾波器設計方法進行了對比分析，擇優採用fir加窗技術開發出了滿足要求的低通數字濾波器，並結合試驗情況用matlab對本濾波器幅頻特性進行了模擬計算分析。
  10. 3. a series of quasi - dynamic calibration tests by varying the pressure pulse width for the < t > 3. 5 x 8. 75mm pillar copper cylinders and o 4. 763mm copper spheres are done on the dropper - hammer hydraulic dynamic pressure calibration device. by means of data analysis, the regulations of pulse width ' s effect on the two types of plastic pressure - measuring elements are obtained

    3利用落錘液壓動標裝置組織了3 . 5 8 . 75mm柱形銅柱、 4 . 763mm銅球的變脈寬準動態校準試驗，通過試驗數據處理，獲得了兩種型號塑性測壓器件的脈寬影響規律。
  11. Data processing system for fan performance test based on windows

    的通風機性能試驗數據處理系統
  12. Data processing of geo - technical compaction test using computer

    土工擊實試驗數據處理的計算機實現
  13. Application of visual basic in keeping shear experiment data processing

    在直剪試驗數據處理中的應用
  14. Application of excel in processing test data and optimizing operating conditions

    軟體在試驗數據處理和操作條件優化中的應用
  15. Method of test data processing for missile used turbojet - part2 : high altitude simulation test

    彈用渦輪噴氣發動機試驗數據處理方法第2部分:高空模擬試驗
  16. To deal with the large scale test data in the soil test, the application of regression analysis method is explored with an engineering example

    針對土工試驗中，大量試驗數據處理的困難，結合武漢市某工程實例，探討了回歸分析法在土工試驗中的應用。
  17. The estimation by the formula is unbiased and with the least variance, many data processing show, the application of the method can gain higher precision of concrete strength value of the formula than in traditional method

    大量試驗數據處理表明，利用本文公式推定混凝土強度值比傳統方法具有更高的精度。
  18. Output result format of simulated sled deceleration is changed by program compiled by c + + language, and then according to regulation, result of simulated sled deceleration is processed with cfc60 in data processing system of sled test

    運用c + +語言編寫程序，對模擬輸出的臺車減速度結果進行了格式轉化，並在臺車碰撞試驗數據處理系統中，按照要求進行了cfc60濾波處理。
  19. In contrast to phase separation ( curve - fitting ) approaches which are largely mathematical, phase resonance testing is a physical technique. when a structure is vibrating in a normal mode, the undamped natural frequency and normal - mode shap of the structure are directly measured. in the classic phase resonance testing, the test data processing is simpler and the results are more accuracy

    相對于相位分離法來說，相位共振法是一種比較直觀的物理識別方法，在結構做「純模態」振動時，通過物理測量直接獲得模態參數;試驗數據處理工作量小，且精度一般比單輸入系統高。
  20. Modal test and analysis is a very important method to identify the structure dynamic characteristics for the updating of finite element model. it includes vibration measurement, data processing and computer application technology

    試驗模態分析技術是一種綜合應用振動試驗、數據處理和計算機技術求取機械結構動態特性的有效工具，是驗證和修改有限元模型的主要手段。
分享友人
分享到 Line

分享到臉書